How to adjust the high beam height of BYD F3?
4 Answers
The method to adjust the high beam height of BYD F3 is: Open the engine hood, locate the adjustment bolt, and turn the bolt to adjust. The BYD F3 is a compact car. Taking the 2020 BYD F3 Classic as an example, it belongs to the compact car category with body dimensions of: length 4533mm, width 1705mm, height 1490mm, and a wheelbase of 2600mm. The 2020 BYD F3 Classic is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 109hp, a maximum power output of 80kW, and a maximum power speed of 5800 revolutions per minute.
When I drove the BYD F3 before, I also encountered the issue of the high beams being too low, so I adjusted the height myself once. First, open the engine hood, and behind the headlight assembly, you'll find a small white plastic knob or screw—the vertical one adjusts the height. Use a simple Phillips screwdriver or hex key to gently turn it: clockwise to raise the beam and counterclockwise to lower it. Make sure to park on level ground and test the beam height facing a wall about five meters away. Typically, the center of the light spot should be around the height of the headlights. Raising it helps illuminate the road farther ahead, but don’t set it too high to avoid blinding others, nor too low to ensure clear visibility. After adjusting, test the effect during nighttime driving. It’s best to have two people cooperate—one inside the car to turn on the lights for quicker adjustments. If unsure, the common adjustment point for the BYD F3 is behind the lamp base. Be careful not to mix up the left and right screws, or you’ll end up wasting your effort.
As a driver, I often help friends adjust their headlight height. The operation is quite simple on the BYD F3 - there's a hex socket screw on the headlight assembly under the hood. Use a dedicated tool to turn it slowly. First, turn off the engine for safety and park on level ground. Apply gentle torque when turning the screw to avoid damaging plastic components. Adjust the height by observing the position of the light cutoff line, usually using a marked center height on a wall as reference. I prefer to check circuit stability with a multimeter first to prevent errors. After adjustment, don't rush off - test drive at night to verify the beam pattern won't disturb others. A small wrench works best; larger tools can be cumbersome.
As a beginner driver, I also tried adjusting the high beam height of my BYD F3. After opening the hood, locate the vertical screw on the back of the headlight. Tightening it raises the beam, while loosening it lowers the light. Find an open area at night to do it yourself, and adjust the beam to a comfortable position by observing the light changes. Remember not to set it too high to avoid dazzling other drivers. Take it step by step without stress, and you'll quickly learn this handy skill.
