How to adjust the height of the low beam on the Trumpchi GS4?
4 Answers
Trumpchi GS4 low beam height can be adjusted using the headlight adjustment knob. The adjustable headlight height means the front headlights have the function to adjust the angle of the light beam, allowing for optimal illumination range and improving road safety. The methods for adjusting the headlights are as follows: 1. Manual method: Mainly consists of a headlight adjustment motor and a manual switch. The headlight adjustment motor is located near the front headlights, and the control part is in the cabin. There is a manual switch on the dashboard that can be adjusted as needed. 2. Automatic method: Composed of a headlight adjustment motor, controller, and level sensors. The level sensors are installed at the front and rear ends of the vehicle body, primarily detecting the height from the chassis to the ground. The height difference is transmitted to the controller as an electrical signal, which then calculates and controls the headlight adjustment motor to achieve automatic headlight adjustment.
I've been driving the Trumpchi GS4 for a while now, and adjusting the height of the low beams is really not difficult. On the driver's side, on the panel to the left of the steering wheel, you'll find a small knob, usually round with a light symbol. Turn it counterclockwise to raise the beam and clockwise to lower it. Remember to do this on level ground, preferably at night against a wall, with the car about 3-5 meters away. Adjust until the centerline of the beam doesn't go higher than the license plate position—that's just right. Setting it too high can blind oncoming traffic, which is a safety hazard; too low and you won't see the road clearly, affecting nighttime driving. If the knob doesn't respond when turned, it might be due to poor contact or an issue with the lamp socket—check if other lights are working first. Keeping the lens clean also improves light output by preventing dust buildup from blocking the light. Regularly checking this small feature makes driving safer and more convenient.
When I first bought a new car, I didn't know how to adjust it either, but now I've learned. The adjustment for the Trumpchi GS4 is located in the control area on the left side of the steering wheel, where there's a small round knob marked with a light symbol. Turning it adjusts the height. The steps are: park on a flat surface, start with the engine off, turn counterclockwise to raise the lights, and clockwise to lower them. It's best to adjust in a garage or at night against a wall, keeping the light beam level and centered. Don't make it too bright to blind others or too dim to see road hazards. If the knob doesn't turn, check if it's stuck or if the bulb is old. After adjusting, take a short drive to confirm the effect. Regularly ensure that dirt doesn't clog the light gaps, and occasionally clean them to maintain functionality. Properly adjusting the height can actually enhance driving comfort, making nighttime travel safer and more reliable.
Adjusting the height of the GAC GS4's low beam is primarily done via the knob inside the car. Locate the knob on the dashboard to the left of the steering wheel and rotate it to make adjustments. The method involves parking on level ground, turning counterclockwise to raise the beam and clockwise to lower it. The ideal height standard is set to avoid interfering with other vehicles. If the knob malfunctions, manual inspection of the lamp base screws or consultation with a professional repair service may be necessary. Remember to test the light status before adjusting to avoid ineffective operations. Ensure the operation is safe and accurate, and perform regular maintenance to prevent issues.
