How to adjust the headlights on the Encore?
3 Answers
The method to adjust the headlights on the Encore is: 1. Open the hood of the Encore and locate the adjustment knob for the headlight angle near the headlight base; 2. The knob is designed with a plastic hexagon shape, and you can use a hex wrench of the corresponding size to adjust it. The Encore is a compact 5-door, 5-seat SUV with body dimensions of: length 4295mm, width 1798mm, height 1616mm, and a wheelbase of 2570mm. The Encore is equipped with a 1.3T turbocharged engine and a CVT continuously variable transmission, delivering a maximum power of 121 kW and a maximum torque of 240 Nm. It features front-wheel drive, with a front suspension using a MacPherson strut independent suspension and a rear suspension using a compound torsion beam non-independent suspension.
I've been driving the Encore for three years, and the light adjustment mainly relies on the lever on the left side of the steering wheel. Rotating the lever head switches between daytime running lights, low beams, and high beams, while pushing it forward flashes the high beams to alert others. If the lights seem too close, there's a numbered dial on the left side of the dashboard marked from 0 to 3—adjusting it while parked changes the beam height (0 is the closest, suitable for a full load). Remember to turn the lever to AUTO mode on cloudy days or when entering tunnels, as the automatic headlights will activate by themselves. There’s also a fog light switch on the panel to the left of the steering wheel—press it during rain or fog. Avoid adjusting the beam height while driving, as it can be distracting. If you’ve replaced the bulbs, it’s best to visit a 4S shop to calibrate the angle, otherwise, you might blind oncoming drivers.
I previously studied the Enclave's lighting system, and it's actually quite user-friendly. All lighting controls are concentrated on the left side of the steering wheel: rotate the stalk to switch modes, push forward to flash high beams. The height adjustment knob is located at the lower left of the instrument panel, with slope icons on the knob - level 0 is lowest, level 3 is highest, setting 2 is most suitable for an unloaded vehicle. Auto mode is the most hassle-free, just turn the stalk to AUTO. Here's a fun fact - this vehicle features a home lighting function: pull the stalk up after turning off the engine, and the headlights will illuminate for 30 seconds to light your path. For rear fog lights in rainy or foggy conditions, first turn on low beams, then press the fog icon button below the center console. If lights flicker, it might be a voltage issue - the battery should be checked.
