How to adjust the headlights of Dongfeng Fengguang 330 higher?
3 Answers
Method to adjust the headlights of Dongfeng Fengguang 330 higher: There is an adjustment screw at the rear of the headlight assembly. You can directly turn the screw with a cross screwdriver. Standing at the front of the car, turning it to the right will raise the headlights. The car headlights consist of the headlight assembly, onboard computer, and light sensor, characterized by low power consumption, high brightness, and long service life. Taking the 2019 Dongfeng Fengguang 330 as an example, its body dimensions are 4365mm in length, 1720mm in width, and 1790mm in height, with a wheelbase of 2725mm, a fuel tank capacity of 50 liters, and a curb weight of 1235kg. This car is equipped with a 1.5L naturally aspirated engine, with a maximum horsepower of 116PS and a maximum power of 85kW, paired with a 5-speed manual transmission.
I've been driving the Fengguang 330 for several years, and this is how I adjust the headlights. The wheel with 0-3 markings on the left side of the steering wheel is for height adjustment. Turning it towards 0 raises the beam, while 3 is the lowest setting. It's best to do this at night facing a flat wall, ensuring the car is parked on level ground. If your vehicle doesn't have this knob, you'll need to manually adjust the screws. Open the hood and locate the two adjustment holes at the back of the headlight assembly - the upper one controls height. Use a Phillips screwdriver to turn clockwise slowly while observing the light beam changes. Remember, setting it too high can dazzle oncoming drivers, so just turn a quarter at a time. You'll need to readjust if the car is heavily loaded or after suspension changes. I adjusted mine before a recent road trip, and it made night driving much safer.
In our shop, there are basically two methods to adjust the headlight height of the Fengguang 330. First, check the vehicle configuration: if there's a height adjustment knob, simply turn it to the 0 position, located on the left side of the dashboard near the steering wheel. If this feature isn't available, manual adjustment of the mechanical structure is required. The key steps are to open the engine compartment, where the white plastic knob behind the headlight is the height adjustment point, requiring a Phillips screwdriver. Turning it clockwise raises the beam, while counterclockwise lowers it. It's recommended to perform this operation in a professional workshop using an adjustment board, ensuring the low beam is 5 cm below the center of the headlight housing at a distance of 7.6 meters. After manual adjustment, check if both headlights are symmetrical to avoid blind spots. Once adjusted, the headlight height should remain stable for at least six months.
