How to Adjust the Headlights of Changan CS55?
3 Answers
Changan CS55 headlight adjustment method: The headlight height adjustment knob of the Changan CS55 is located at the lower left corner of the center console area. Rotate the knob to adjust the headlight height. There are a total of 6 adjustment positions on the knob, with position 0 being the highest setting. Here is an introduction to the headlight adjustment positions: 1. Position 0 is the initial setting, typically used when only the driver or the driver and one front passenger are in the vehicle. 2. Position 1 is for when all seats are occupied, and there is no cargo in the trunk. 3. Position 2 is for when all seats are occupied, and the cargo weight in the trunk is evenly distributed. 4. Position 3 is for when only the driver is present, and the cargo weight in the trunk is evenly distributed.
I previously adjusted the headlights of my Changan CS55 myself and felt quite accomplished. Open the hood, and near the rear area of the headlight assembly, you'll find two adjustment screws: one controls the beam height, and the other adjusts the left-right direction. It's best to park the car on level ground at night, about five to six meters away from a white wall. Use a Phillips screwdriver to turn the screws for adjustment—when adjusting the height, ensure the beam doesn't shine too high to avoid dazzling other drivers, nor too low to compromise visibility. Remember, it's best to adjust when the car is unloaded, as you might need minor tweaks after loading. After doing it myself, I tested the lights while driving and was satisfied with the results. Also, remember to check regularly, especially after bumpy roads, as headlights can shift easily—maintaining even brightness is crucial. This trick saves money on mechanic visits, and DIY enthusiasts love tackling such tasks.
Adjusting the headlights is a matter of safety and should never be taken lightly. When driving the CS55, if the headlight beam is too high, it can dazzle oncoming vehicles and cause accidents; if it's too low, you won't be able to see the road clearly. It's recommended to first find an open area with a white wall and park the car on level ground to measure the distance. Specific steps: Open the hood, locate the screw holes at the back of the headlights—usually marked with arrows. Use a screwdriver to slowly turn the screws while observing the beam position on the wall. Ensure the main light point is aimed at a reasonable height on the ground (e.g., about 30 cm high at a distance of 3 meters from the wall). When I learned this trick, it took me several attempts to get it right. Considerations: Visibility is poor in rain or snow, so adjusting the headlights will make driving safer. Beginners may want to ask an experienced person to accompany them to avoid mistakes.
