How to Adjust the Headlight Height of the Malibu?

What kind of engine oil does Toyota use?

Toyota's dedicated original engine oil is Toyota Genuine Oil. The specific oil models for Toyota include 0W20, 5W20, 5W30, 5W40, and 10W30. The viscosity of engine oil changes with temperature, so special attention should be paid to its performance under both low and high temperatures. For example, in 5W-30, the first number indicates low-temperature fluidity, where 5W represents the ability to withstand -30°C. The smaller this number, the better the low-temperature fluidity, resulting in smoother cold starts for the car. The latter number represents the kinematic viscosity of the oil at 100°C. The higher this number, the better the oil can maintain its viscosity index under high temperatures, which can also be understood as better lubrication performance under high-temperature conditions. The method for changing Toyota's engine oil is as follows: Wait for the engine temperature to drop, which also allows the oil to flow back into the oil pan; Use a wrench to loosen the oil drain plug and place an oil pan to catch the old oil until no more oil flows out. Start the engine and let it run for 30 seconds to allow the oil in the main oil passage to drain; Use a special wrench to remove the oil filter; Apply oil to the seal of the new oil filter and tighten it clockwise by hand; Add new oil through the oil filler cap on the engine valve cover, usually filling about three-quarters of the oil container; Start the engine and let it run for 5 minutes, then check for any oil leaks around the oil drain plug and oil filter. If there are leaks, perform necessary repairs; After stopping the engine, pull out the oil dipstick and check that the engine oil level is within the standard range.

10

1

Share

Is a Beijing Entry Permit Required for Non-Local Vehicles to Enter Beijing?

Non-local vehicles must obtain a Beijing Entry Permit to enter Beijing; those without the permit are not allowed to enter. Below is more information: 1. Related Penalties: Driving on the Fifth Ring Road without a Beijing Entry Permit will result in a 3-point deduction and a fine of 100 RMB. Each vehicle can apply for a Beijing Entry Permit up to 12 times a year, with each permit valid for a maximum of 7 days. 2. Failure to Obtain or Expired Beijing Entry Permit: Vehicles must exit the designated areas before the permit expires. If a vehicle without a permit or with an expired permit is parked on urban roads of branch level or above within these areas, the number of days the vehicle can apply for a Beijing Entry Permit in the current year will be reduced accordingly based on the number of days parked. 3. Violation of Prohibition Signs: Driving within the designated areas without a valid permit will be considered a violation of traffic prohibition signs and will be penalized by the traffic management department of the public security authority according to the law.

8

5

Share

Why does the wiper make a loud and dry sound?

When the wiper is dry and makes a loud scraping sound, it is usually caused by the aging of the wiper rubber strip, and a new wiper needs to be replaced. Most cases where the wiper squeaks and fails to clean properly are due to wear and roughness on the rubber strip, which causes abnormal noise or incomplete removal of rainwater during operation, making it difficult to see clearly while driving in the rain. Below are some daily usage precautions for wipers: 1. Maintain moisture when using the wiper: Ensure the rubber wiper strip remains adequately moist during daily use. Only with sufficient moisture can it maintain excellent flexibility and ensure tight contact with the windshield. If the windshield lacks moisture before use, dry wiping can lead to counterproductive results. 2. Wait until more raindrops accumulate on the windshield before activating the wiper: If raindrops accumulate slowly and do not obstruct vision, it is best to wait until more raindrops gather on the windshield before turning on the wiper. When using the wiper in light rain, it is advisable to spray windshield washer fluid first to ensure sufficient moisture for lubricating the wiper.

20

5

Share

What Does the Circle Exclamation Mark on the Car Dashboard Indicate?

Red exclamation mark (specifically a circle with an exclamation mark inside parentheses) indicates a warning for the braking system, primarily signaling either a brake system malfunction or low brake fluid level. Solution: Immediate inspection and repair of the braking system are required to prevent accidents. Apart from the red exclamation mark indicating brake system issues, other exclamation marks on the car dashboard are yellow, representing general faults, automatic transmission issues, abnormal tire pressure, and lighting system faults. Below is a detailed analysis of these four scenarios: General Fault: A triangle with an exclamation mark inside. If this symbol lights up, it indicates a malfunction in the car's general performance, components, or functions. Common issues include parking sensor failure, fuel cutoff system intervention or malfunction, external light failure, engine oil pressure sensor malfunction, etc. It is necessary to visit a 4S shop for inspection to identify the source of the fault. Automatic Transmission Fault: A yellow gear with an exclamation mark inside. This is the automatic transmission fault warning light, indicating a transmission malfunction or transmission fluid level below the normal range. Transmission fluid should be replaced promptly. Abnormal Tire Pressure: A horizontal line under parentheses with an exclamation mark in the middle. This represents the tire pressure monitoring warning light, which illuminates when the tire pressure is too low. Check the tire pressure and restore it to the normal range. Lighting Fault: A yellow bulb with an exclamation mark. This is the lighting fault indicator, signaling a malfunction in one of the car's lights. Solution: Visit a 4S shop as soon as possible for inspection and repair. Alternatively, you can conduct a self-check, focusing on commonly used bulbs such as turn signals, fog lights, and interior lights, to identify the problematic area.

6

5

Share

Does Turning Off the Engine at Red Lights Save Fuel?

Turning off the engine at red lights does not save fuel. With the performance of modern engines, fuel consumption during idling is not very high—generally, idling for an hour consumes less than 1L of fuel. However, starting the engine also creates a peak in fuel consumption. Research by experts shows that the extra fuel consumed in one cold start is enough for the car to travel 3 kilometers, while the extra fuel consumed in one warm start is enough for the car to travel 1 kilometer. The impact of each engine start: 1. Negative effects on the engine and battery: Each start affects the lifespan of the engine and battery. The moment of starting causes more wear on the engine than normal operation and also easily leads to carbon buildup. 2. Energy and fuel conversion: The energy consumed by the battery during one start requires about 20 minutes of stable vehicle operation to replenish, and this energy must be compensated for by burning additional fuel.

15

3

Share

What is the mileage for the second maintenance?

Car second maintenance is generally at ten thousand kilometers. The following are the contents of the second maintenance and the role of car maintenance: Items for the second maintenance: Replace the three filters, including the oil filter, air filter, and cabin air filter; check fluids, such as brake fluid, transmission fluid, and power steering fluid to see if they need replacement; inspect external components, including brake pads, tires, shock absorbers, and suspension; check internal components, such as spark plugs, throttle body, and fuel supply system; other inspections, like front and rear wheel rotation, routine lights, battery checks, etc. Note that for the second car maintenance, no additional replacements or cleaning are required, such as engine cleaning. The role of car maintenance: The role of car maintenance is to keep the car clean and tidy, maintain normal technical conditions, eliminate hidden dangers, prevent faults, slow down the deterioration process, and extend the service life.

9

5

Share

How to Adjust the Headlight Height of the Malibu?

What kind of engine oil does Toyota use?

Is a Beijing Entry Permit Required for Non-Local Vehicles to Enter Beijing?

Why does the wiper make a loud and dry sound?

What Does the Circle Exclamation Mark on the Car Dashboard Indicate?

Does Turning Off the Engine at Red Lights Save Fuel?

What is the mileage for the second maintenance?

How to Deal with Peeling Car Paint?

What maintenance should be done at 50,000 kilometers for a car?

What are the penalties for interval speeding?

Where is the air conditioning filter of Dongfeng Peugeot 308 located?