How to Adjust the Headlight Height of the 2021 Nissan Qashqai?

1 Answers
MacMarley
07/24/25 10:53pm
2021 Nissan Qashqai headlight height adjustment methods: 1. Adjust on the steering wheel: Use the lighting combination control switch on the left rear side, rotate the knob on the side of the combination switch, upwards to raise and downwards to lower; 2. Adjust on the headlight: A cross-shaped bolt, rotate left or right to adjust the headlight height. The Qashqai is a compact SUV under Dongfeng Nissan. Taking the 2021 Qashqai as an example, its powertrain is equipped with a 2.0L inline four-cylinder naturally aspirated engine, with an aluminum alloy structure, delivering a maximum power of 111kW and a maximum torque of 194Nm, paired with a 7-speed continuously variable transmission. The 2021 Qashqai measures 4401mm in length, 1837mm in width, 1593 or 1611mm in height, with a wheelbase of 2646mm. The body adopts a 5-door, 5-seat configuration, and the fuel tank capacity is 57L.
Was this review help?
10
5
Share
More Forum Discussions

How to Open the Engine Hood of the TACQUA?

Locate the engine hood release lever inside the cabin, then pull the hood release handle to slightly pop up the engine hood. Reach into the center front of the engine hood, lift and hold the release lever upwards while raising the engine hood. After opening the engine hood, remove the hood support rod. Insert one end of the support rod into the designated slot to prop up the engine hood. If the hood is equipped with hydraulic supports, manual propping is not required.
9
3
Share

How to Open the Vezel Trunk from Inside the Car?

There is no trunk button set inside the car. Some models have two additional buttons for the trunk, with the left one for closing the trunk and the right one for closing the trunk plus locking the car. After locating the two buttons on the left and right, simply press them to open the trunk. Once the trunk button is pressed, the locking mechanism will release, allowing you to lift the trunk directly and proceed with the next steps. After using the trunk, gently lower it to avoid unnecessary damage to the vehicle body or malfunction of the lock.
3
4
Share

How to Remove the Clutch Pedal of a Haval H2?

Locate the connection point between the clutch master cylinder and the pedal, where there is a cotter pin. Use needle-nose pliers to grip the cotter pin and pull it out. Pull the clutch master cylinder to the left to disconnect it from the pedal, then remove the clutch pedal. If the clutch makes abnormal noises, it indicates dry friction. Simply apply some grease to the spring and the friction points. Ensure smooth vehicle starting, smooth gear shifting in the transmission system, and prevent overloading of the transmission system.
7
4
Share

How to Use Jaguar's Autonomous Driving Assistance System?

Start the car under safe conditions. Press the cruise control switch twice consecutively to activate the Autopilot autonomous driving assistance. Autonomous driving assistance can only be achieved under the premise of safe driving. When you need to use the Autopilot autonomous driving assistance function, you can enable or disable certain features of the Autopilot autonomous driving assistance via the touchscreen at any time. Assisted steering can only be achieved on roads with clear lane markings and slight angles. For example, it cannot be used at intersections or during sharp left or right turns.
7
4
Share

How to Shorten the Roof Antenna on a Nissan X-Trail?

First, prepare a wrench and a shark fin antenna of the same model. Remove the reading light above the rear seat inside the car. After removing the headlight, you will see the antenna screw. Unscrew the base screw of the antenna and remove the antenna along with its base. Secure the antenna spring with the screw from the shark fin antenna and ensure it is tightly fastened. Directly cover the shark fin antenna over the original car antenna and mark the position with a pen. Finally, apply glue to the marked position on the roof and firmly press the shark fin antenna back and forth to ensure it is securely fixed.
11
0
Share

How to Start a New Energy Vehicle When the Key Battery Dies?

Use the mechanical key by inserting it into the keyhole on the driver's side door. After opening the door, use the mechanical key to start the vehicle. For push-button start, press the side of the key with the logo firmly against the push-button start switch, hold for a few seconds, and then press down to start the vehicle. Replace the coin battery. The key contains a battery; when it dies, you can purchase a replacement coin battery nearby and install it. Regularly check and replace the coin battery, and maintain the car key properly. Avoid exposing the key to environments below 0°C.
3
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.