How to Adjust the Dashboard Clock on the Tiggo 3?
3 Answers
The method to adjust the dashboard clock on the Tiggo 3 is as follows: 1. Turn the key to the ACC position or remove it, and the dashboard will turn off; 2. Rotate the light switch to turn on the parking lights, and the dashboard backlight will illuminate; 3. Press and hold the dashboard button, and the hour section of the clock will start flashing; 4. Release the button and press it again, each press increases the hour by one; 5. After setting the hour, do not press the button, and the hour will flash five times before automatically switching to the minutes; 6. Each press of the button increases the minutes by one, and holding the button will continuously increase the minutes; 7. After setting the minutes, do not press the button, and the minutes will flash five times before stopping, indicating the time has been successfully adjusted.
Adjusting the dashboard time on the Tiggo 3 is actually quite simple, and I'll share my experience. First, sit in the driver's seat and turn the key to the ACC position to power on the car, which will light up the dashboard. Then, locate a button on the steering wheel, usually labeled MODE or SET, and hold it down for a few seconds to enter the setup menu. Next, use the up, down, left, and right buttons on the steering wheel to navigate to the time setting option. Once inside, you can adjust the hours and minutes by pressing the plus/minus or arrow keys to fine-tune it to your desired time. Don’t forget to press OK or the confirm button to save the settings afterward, or all your effort will be wasted. I usually pay attention to the accuracy of this time while driving because if the car develops a fault, repair records rely on it to diagnose issues—getting it right can save a lot of trouble. If the weather gets too cold or hot, an inaccurate time can also affect the automatic operation settings of the air conditioning, so checking it periodically is a wise move. In short, follow these steps a few times, and you’ll get the hang of it—it takes no more than a minute or two to complete.
When it comes to adjusting the instrument panel time on the Tiggo 3, I believe the most crucial point is ensuring safety first. Never fiddle with this while driving, as it can easily lead to distraction and accidents. You need to park the car securely first, turn the key to the ACC power position, and then proceed. There's usually a small button on the steering wheel, often labeled MODE or something similar. Press and hold it for a few seconds to bring up a range of settings options. Once you've selected the time section, use the directional buttons to adjust the numbers, incrementing or decrementing bit by bit until you reach the correct time. After saving, it's best to check the screen to confirm the changes have taken effect. Why is it important to set the time accurately? If the vehicle's log records are imprecise, in the event of an accident or malfunction, insurance companies or mechanics might misinterpret the situation, leading to complications. I've experienced a time discrepancy that delayed a maintenance reminder, almost causing me to miss an oil change. If the buttons don't respond, it might be due to low battery voltage or a minor system glitch; in such cases, it's advisable to turn off the engine and restart it. Developing a habit of checking the time during routine maintenance is a good practice, as it helps prevent problems before they arise.
