How to Activate the One-Touch Window Lift for Honda XRV?
3 Answers
Activation settings for the Honda XRV one-touch window lift function: 1. Armrest button: To activate, first start the vehicle. Press and hold the switch to lower the window completely for 5 seconds, then press and hold to raise it to the top for 5 seconds before releasing. Once completed, the function will be enabled. 2. Central control screen: In the infotainment system, select: MENU > Vehicle > Left control button > Vehicle settings > Central door lock > Press and hold to open the window to activate. 3. Additional information: The one-touch window lift system refers to a car window glass control system that allows the window to be fully raised or lowered with a single button press.
Activating the one-touch window lift for the XRV is actually quite simple. I just helped my neighbor with his car last week. First, sit in the driver's seat and close the door, then power on the car with the key without starting the engine. Locate the window switch on the driver's side door panel, pull the button all the way up and hold it for about 6-8 seconds. Then release and immediately pull it up again, holding for 3 seconds. At this point, you'll hear a slight 'click' sound from the window motor, indicating the reset was successful. The key to the whole operation is accurately timing the two upward pulls—the first one is a long press, and the second is a short one. Don't forget to test it afterward by pressing the button to see if the window automatically rises to the top.
I often help fellow car owners with this. Just remember three steps: power on without starting the engine, pull and hold the driver's window lift button to the top for 7 seconds, then release and immediately pull again for 3 seconds. The key is holding long enough the first time to let the system memorize the window position. Last time, Old Wang's XRV lost one-touch window function after battery disconnection, and this method fixed it instantly. If there's no response after setup, it's likely the first pull wasn't held long enough - just repeat the process.
