How to activate the automatic sensing front wipers on the Edge?

1 Answers
OMatthew
07/29/25 10:12pm
To activate the automatic sensing front wipers on the Edge, simply move the wiper switch to the AUTO position. The rain-sensing wipers can detect the size of raindrops through the rain sensor and automatically adjust the wiper speed, providing the driver with good visibility and enhancing convenience and safety during rainy conditions. The Edge has body dimensions of 4878mm in length, 1925mm in width, and 1734mm in height, with a wheelbase of 2850mm and a fuel tank capacity of 69 liters. It is equipped with a 2.0L turbocharged engine that delivers a maximum power of 180kW and a maximum torque of 390Nm, paired with an 8-speed automatic transmission.
Was this review help?
18
2
Share
More Forum Discussions

How to lift the rear seat of an old CRV?

Locate the buckles and base of the rear seats in the car. The operation is quite simple: reach your hand under the seat cushion and forcefully lift the front part upward until the front buckle is released. Simply secure the rear part of the back seat in place, then firmly align and insert the two front buckles into the floor base.
4
2
Share

What to Use to Clean Dirty Door Panels?

Some gaps are difficult to clean, but cleaning gel can solve this problem. Cleaning agents can dissolve dirt on the door panels, and then wiping with a towel can remove the stains. You can spray the cleaning agent on and then scrub with a brush. Using a foam cleaning method can avoid damaging the car paint.
8
5
Share

How to use the rear wiper of Volkswagen Tiguan I?

The wiper control lever behind the steering wheel. Pull the lever toward the driver to spray washer fluid on the front windshield wiper. The OFF position is the switch-off point; turn to this position when not using the wiper. 1X means the wiper swings once, and the lever will automatically rebound.
5
3
Share

How to Repair a Dented Car Door?

First, the simplest method is to cover the dented area with a car sticker. To manually restore the dent, you will need some tools, such as a suction bridge-type repair device. When the car door is severely dented and cannot be repaired, the only option is to replace it with a new one. You can visit a local auto parts store to choose a suitable new door.
2
3
Share

How to Determine the Condition of a Motorcycle Trigger?

Measure the resistance value of the trigger; it is generally between 150 and 200 ohms. Connect the positive and negative test leads to the two terminals of the trigger. Under normal conditions, a resistance reading of around 150 ohms should be displayed. If the resistance shows infinity, it indicates that the trigger is damaged.
11
5
Share

How to Quickly Drain Water from the Rear Seats of a Car?

If the cabin gets flooded, you can open the sealed rubber plugs on the chassis and turn on the air conditioning to help drain the remaining water quickly. The floor mats inside the car, made of absorbent materials, should be removed and placed in a spacious area to facilitate water evaporation. After reinstalling them, remember to turn on the air conditioning.
10
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.