How to Activate the Automatic Parking Function on the Lynk & Co 03?
4 Answers
To activate the automatic parking function on the Lynk & Co 03, simply press the button with the automatic parking symbol located in front of the gear lever. Below is relevant information: 1. The automatic parking system, also known as the parking steering assist system, aids drivers in parking in both parallel and perpendicular parking spaces, as well as in maneuvering out of parallel parking spots. When parking or exiting a parking space, the system begins to handle the steering actions. The state where the driver operates the pedals and gear lever while the system controls the steering wheel is referred to as "parking operation." 2. Once the parking assist system identifies a suitable parking space, the dashboard will display available parking modes that can be switched. Depending on the actual conditions of the parking space, select the appropriate parking mode by pressing the parking switch. Bring the vehicle to a stop and ensure it does not proceed further before the parking procedure begins. Shift into reverse gear or place the gear lever in the R position.
To activate the automatic parking feature on the Lynk & Co 03, first ensure your vehicle is equipped with this function, typically available in higher trim models. Drive slowly when parking and locate a suitable empty spot, such as parallel or perpendicular. Press the parking button near the steering wheel or on the central touchscreen to activate the system's sensors for scanning the surroundings. Then, check the dashboard or touchscreen display to confirm the parking spot position. Release the steering wheel and brakes, allowing the system to control steering, acceleration, and deceleration until a completion alert sounds. Remember to keep the speed below a specific limit, usually under 20 km/h, to ensure accurate sensor detection. Additionally, since the system relies on cameras and radar, inspect the surroundings before parking to avoid interference from children or pets for safety. Automatic parking is especially useful in crowded urban areas, offering convenience for both beginners and experienced drivers. Regularly clean the sensors to prevent misjudgments.
Activating the automatic parking feature on the Lynk & Co 03 is straightforward, provided your vehicle is equipped with this system. First, start the engine and maintain a low speed, ideally within 15-20 km/h. Second, locate a parking space; the system will prompt you once it identifies one, at which point you press the parking button to activate the mode. Third, select the parking position type on the screen, such as parallel parking or reverse parking. Finally, the system takes over the operation, and you just need to monitor the process without distraction. The system relies on ultrasonic sensors and cameras, so accuracy may be compromised in low-light conditions—avoid using it in pitch-dark areas at night. Automatic parking is highly beneficial, especially for beginners looking to avoid scratches, but I always recommend practicing a few times to familiarize yourself with the process, just in case of unexpected errors.
As a driver, I believe safety should be the top priority when activating automatic parking. On the Lynk & Co 03, look for an empty parking space while slowing down to 10-15km/h, ensuring there are no people or obstacles around. Press the dedicated parking button to let the system scan, and release control after confirmation is displayed. The system will provide an audible prompt upon completion. Avoid using your phone during the entire process and monitor the progress. Why operate it this way? Automatic parking relies on sensors, and rain or dirt can affect accuracy, so it's important to regularly clean the front components of the car. Once activated, the system handles everything, but developing good habits can prevent accidents. Safety comes first, and this feature should not be used on unfamiliar roads.
