···
Log in / Register

How Often Should You Inflate Your Tires?

1 Answers
DerekLynn
08/27/25 4:41am

Inflate your tires once a month and regularly check the tire pressure of all tires, including the spare, when they are cold. The correct inflation pressure for cold tires should be based on the parameters recommended by the vehicle manufacturer. Typically, the recommended tire pressure refers to the pressure measured when the tires are cold. A tire is considered cold when the vehicle has been parked for at least three hours or driven no more than 2 kilometers. If you can only measure the tire pressure when the tires are hot, subtract approximately 0.3 bar from the measured value to get the cold inflation pressure. The quality of the tires also determines how often you should check the pressure. For a good set of tires, checking during seasonal changes, temperature increases, or decreases is sufficient. There is no strict rule on how often to inflate them, but for normal daily-use family cars, checking the tire pressure every 1 to 2 months is advisable. There may be minor changes, and you can add a small amount of air as needed based on the actual situation.

Was this review help?
8
1
Share
More Forum Discussions

Can the Envision's sunroof leakage be claimed through insurance?

Envision's sunroof leakage cannot be claimed through insurance. The following is an introduction related to the Envision's sunroof leakage: Model Information: The Envision is a model under the Buick brand. As an important flagship brand under General Motors, Buick has multiple models on sale. The Buick brand was established in 1904, and the models it produces are mid-to-high-end cars, with the brand logo being three shields. Claim Details: The Envision's sunroof leakage cannot be claimed through insurance, but it can be claimed from the dealer within the warranty period. The main reason is that insurance compensation considers the principle of proximate cause, and the cause of the car's leakage is the quality issue of the sunroof, which is not covered by insurance compensation.
19
0
Share

What brand are the original tires on the new Santana?

The new Santana 1.5L Fashion Edition uses Maxxis tires, while the 1.5L Comfort Edition uses Dunlop tires. Below is a related introduction about the new Santana: Introduction: On December 16, 2012, Shanghai Volkswagen announced the official launch of the all-new Santana, offering a total of 8 models with 1.4L and 1.6L engine options. Model Overview: The exterior design of the all-new Santana no longer carries the shadow of the "Pusang" or Zhijun models. The family-style front face is similar to the design of models like the new Lavida, making it more aligned with the aesthetics of the new generation compared to the previous model. The overall lines of the new car are smooth and neat, with a simple and timeless design style.
6
5
Share

How long does it take to pick up the BYD Qin Plus-DMI?

It takes 45 working days or more to pick up the BYD Qin Plus-DMI. Below is an introduction to the BYD Qin Plus-DMI: Exterior: The front grille features a blackened treatment, paired with narrow and elongated headlights on both sides, giving the front face a highly distinctive look. At the rear, the new Qin model retains the iconic fuel version elements while also featuring a new-style taillight assembly and black bumper trim pieces on both sides of the body, presenting a refined appearance. Powertrain: The plug-in hybrid model is powered by a hybrid system consisting of a 1.8-liter turbocharged engine and an electric motor, delivering a combined power output of 109 horsepower, with the electric motor's peak torque reaching 148 Nm.
11
0
Share

What are the specific symptoms after the blower resistor is damaged?

Symptoms after the blower resistor is damaged include: air conditioning compressor failure and blower resistor failure. Main causes of blower resistor damage: Due to short circuits in the compressor or control circuit, or failures in the condenser motor, compressor electromagnetic clutch, or evaporator motor; The fuse of the car air conditioning fan does not meet the requirements, the current value is too small, there is a short circuit in the air conditioning system, or the compressor load is too large, which can also lead to blower resistor damage; Excessive current, poor heat dissipation, excessive internal resistance of the blower, loosening due to excessive flow resistance current, and shortened resistor lifespan. It is recommended to replace the blower. Methods to determine the condition of the blower resistor: The primary function of the vehicle blower resistor is to control the speed of the airflow. If it is damaged, the most noticeable symptom is the inability to adjust the speed of the central air conditioning. A detailed method to check is also very simple: prepare a multimeter, set it to the ohm range, place the multimeter's positive probe on the resistor's positive terminal and the negative probe on the negative terminal. Then check if the reading on the multimeter is normal. If the measured resistance value is 0, it indicates that the resistor is damaged. Maintenance methods for the blower resistor: Maintenance of the blower mainly includes daily inspection and maintenance of the electrical parts, daily inspection and maintenance of the mechanical parts, and periodic maintenance.
12
3
Share

Where is the battery jump-start location for the Ford Kuga?

The battery of the new Ford Kuga is located next to the engine, behind the left headlight. Battery replacement: If the battery is frequently depleted due to aging, it is recommended to replace it with a new one. If the battery depletion is caused by prolonged vehicle inactivity or electrical appliances remaining on after the engine is turned off, the issue can be resolved by jump-starting. Ford Kuga powertrain: The Ford Kuga offers two engine options: the EcoBoost180 (1.5T) and the EcoBoost245 (2.0T), with maximum power outputs of 181 horsepower and 245 horsepower respectively. Both engines are paired with a 6-speed automatic transmission, and the 2.0T models come standard with a four-wheel-drive system.
15
5
Share

How Much Horsepower Does the Isuzu 2.8T Diesel Engine Have?

Isuzu 2.8T diesel engine has a power output of 177 horsepower. Additional information is as follows: Isuzu: Isuzu is a Japanese automobile manufacturing company headquartered in Tokyo, Japan, with integrated manufacturing and assembly. Its factories are located in Fujisawa City, Tochigi Prefecture, and Hokkaido, Japan, and it is renowned for producing commercial vehicles and diesel engines. Engine: An engine is a machine capable of converting other forms of energy into mechanical energy, including internal combustion engines (reciprocating piston engines), external combustion engines (Stirling engines, steam engines, etc.), jet engines, electric motors, etc. For example, internal combustion engines typically convert chemical energy into mechanical energy. The term engine can refer to both the power generation device and the entire machine including the power unit.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.