How often should the battery of Dongfeng Honda CR-V be replaced?

2 Answers
LaJasmine
07/24/25 11:12pm
Dongfeng Honda CR-V batteries generally need to be replaced every 2-4 years. Here are the specific details about car battery replacement: 1. The lifespan of a car battery is typically around 2-3 years, but with proper use and maintenance, it can last up to 4 years without damage. 2. It's important to regularly check the battery; in summer, check it weekly, and in winter, check it every two weeks. Below is extended information on car battery maintenance precautions: 1. If a car's battery is not used for a long time, it will slowly discharge on its own until it becomes unusable. Therefore, start the car periodically to recharge the battery. 2. Avoid leaving the car in an open parking lot for extended periods. If long-term parking is necessary, remove the battery to prevent it from freezing and getting damaged. The battery's charge level can be reflected on the dashboard. When the ammeter shows insufficient charge, recharge the battery promptly.
Was this review help?
16
1
Share
DelChase
08/10/25 3:18pm
I drove a Dongfeng Honda CR-V for seven or eight years and found that the battery typically lasts 3-5 years before needing replacement, depending on usage habits. In city driving with frequent starts and stops daily, it might last only 2 years at most. However, if you often drive long distances in suburban areas, it can easily last up to 5 years. The key signal is when the engine struggles to start, and the lights dim—don’t ignore these signs. The CR-V uses a maintenance-free battery, which is prone to power loss in cold winter temperatures. When I lived in the north, I had to check the voltage yearly. If the multimeter showed below 12 volts, I’d replace it immediately. A money-saving tip is to turn off the auto start-stop function, avoid using electrical devices after turning off the engine, and disconnect the battery terminals for long-term parking to extend its life. Replacing an original battery costs a few hundred yuan, much cheaper and more convenient than getting stranded and calling a tow truck.
Was this review help?
11
4
Share
Expand All
More Forum Discussions

How to Turn on the Low Beam Headlights of Jetta VS5?

The method to turn on the low beam headlights of Jetta VS5 is to rotate the turn signal lever on the left side of the steering wheel clockwise once, and the low beam headlights will be turned on. Low beam headlights are used when driving at night in conditions with no street lights, poor illumination, or low visibility such as fog, rain, snow, dust, or hail. Here is an introduction to the use of low beam headlights: 1. In cities where lighting conditions are generally good, vehicles should use low beam headlights when passing through well-lit sections at night. The illumination distance of low beam headlights is about 30-40 meters. When driving at a speed of 55 km/h at night, if a situation is detected and the brakes are immediately applied, the stopping distance is exactly 30 meters. 2. When a motor vehicle is driving at night in conditions with no street lights, poor illumination, or low visibility such as fog, rain, snow, dust, or hail, and when a following vehicle is driving close to the vehicle in front in the same direction, low beam headlights should be used. When a motor vehicle passes through sharp curves, slopes, arch bridges, crosswalks, or intersections without traffic lights at night, it should alternately use high and low beam headlights to signal.
10
2
Share

How to Appeal a Red Light Violation for Motor Vehicles?

If the red light violation was not caused by the driver's own fault, in addition to early correction through methods such as review by legal officers, it can also be resolved through administrative reconsideration or administrative litigation. More relevant information is as follows: 1. While driving, if a driver mistakenly runs a red light due to being blocked by a large vehicle ahead, for such special circumstances, the traffic management department will verify and correct according to legal procedures. If the red light violation indeed occurred because the signal was obscured by the vehicle in front, or if the driver ran the red light to urgently transport a patient, in addition to early correction through methods like review by legal officers, the involved party can also appeal through channels such as administrative reconsideration or administrative litigation. 2. When electronic surveillance at intersections captures red light violations, it typically takes three photos as evidence. One photo shows the vehicle before crossing the stop line during the red light, and the other two show the vehicle continuing to move forward, crossing the stop line, and completely entering the intersection during the red light. These three photos clearly record the vehicle's movement during the red light. If the vehicle only slightly crosses the stop line during the red light but stops immediately, the traffic management department will not impose a penalty.
15
4
Share

How to Adjust the Time on a Highlander Car?

The time adjustment buttons for the Highlander car are located below the clock screen. Here is a detailed guide on how to adjust the time on a Highlander car: 1. Below the clock screen, there are two buttons for adjusting the time—H for hour and M for minute. 2. On the right side of the steering wheel, there is a DISP button. Switch to the CLOCK display, press and hold the hour digit until it flashes, then adjust the hour. Press and hold for about 5 seconds, and the minute digit will flash, allowing you to adjust the minutes. 3. The Highlander features a spacious body with an innovative and roomy interior. Additionally, the Highlander comes equipped with the highest standard safety features in its class. 4. The representative model of the Highlander is powered by a 3.5L V6 engine with an output of up to 201 kW, paired with a stepped 5-speed automatic transmission, providing smooth acceleration, excellent fuel economy, and an enjoyable driving experience. Moreover, the four-wheel-drive system, combined with the newly developed suspension system and 19-inch large-diameter wheels on the high-rigidity unibody chassis, ensures outstanding handling, ride comfort, and off-road performance.
6
1
Share

The Correct Method for Starting a Manual Transmission Car

After starting the car, press the clutch pedal completely with your left foot to prepare for the semi-clutch state. Push the gear lever into first gear with the palm of your right hand as the starting gear. Gently press the turn signal control lever downward with your left hand to activate the left turn signal and alert vehicles in front and behind.
6
3
Share

How to replace the washer fluid reservoir of BYD F6?

Use a screwdriver to pry up the washer nozzle. The nozzle has a clip structure. After prying up the nozzle, there is a small hose connected underneath. Simply remove the nozzle from the hose. Insert the new nozzle into the mounting hole and press it down directly. After installation, you can test the water spray to ensure the water stream hits the correct position on the windshield.
12
3
Share

How to engage the central differential lock on Haval H9?

When the vehicle speed is below 5 km/h. The rear axle differential lock is in the locked state. The driving mode is set to 4L mode. The speed difference between left and right wheels is less than 50 rpm. Depress the clutch pedal and shift the gear lever into low gear. Move the throttle control handle to the maximum fuel supply position. Step on the differential lock control pedal with your right foot. Smoothly release the clutch pedal to allow the vehicle to start smoothly. After driving out of the slippery area, release the differential lock pedal, and the differential lock will automatically disengage. It is used to create speed differences between wheels, allowing reasonable torque distribution between left and right wheels during turns to achieve proper turning performance.
6
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.