How often should Castrol EDGE engine oil be changed?

2 Answers
VanRemington
07/25/25 4:25pm
Castrol EDGE engine oil should be changed approximately every 10,000 kilometers or once a year. The method for changing the engine oil is as follows: 1. Use a jack to lift the vehicle, locate the drain plug, and unscrew it to drain the oil; 2. Unscrew the oil filter and place a container underneath it; 3. Replace with a new oil filter and add new engine oil. The functions of engine oil are: 1. To reduce friction and high temperatures; 2. To cool and lower temperatures; 3. To clean and remove contaminants; 4. To cushion and absorb shocks; 5. To prevent rust and corrosion. Engine oil, also known as motor lubricant, is composed of base oil and additives. The base oil is the main component of lubricating oil, determining its basic properties, while additives compensate for and improve any deficiencies in the base oil's performance.
Was this review help?
7
5
Share
Skylar
08/11/25 9:48pm
I've been repairing cars for over a decade and have seen many owners using Castrol Edge. This fully synthetic oil is truly top-notch quality, capable of lasting 10,000 kilometers or one year under normal driving conditions. However, it depends on your vehicle's condition and road conditions. If you're frequently stuck in city traffic or often drive on construction sites where the engine idles for long periods, the oil degrades faster and may need replacement at around 7,000-8,000 kilometers. I recommend checking the dipstick during each maintenance service - if the oil turns as black as soy sauce, it's time for a change. By the way, frequent short-distance driving also harms the oil because the engine doesn't warm up sufficiently, leaving moisture unexpelled. It's best to inspect the oil every six months in such cases.
Was this review help?
10
5
Share
Expand All
More Forum Discussions

How to Drive a BMW X1 Automatic Transmission?

First, enter the vehicle and press the brake pedal with your right foot. After pressing the brake pedal, start the vehicle. Once the vehicle is started, you can release the brake pedal. After shifting to D (Drive) gear, release the handbrake.
14
5
Share

How to Set Up the Built-in Navigation Voice in a BMW?

You can find the voice prompt option on the navigation map interface, uncheck or cross it out, just locate and operate the speaker-like icon; If you cannot find the option to check/uncheck "Voice Prompts" on the map interface, you can try looking in the "Settings" interface; If you still cannot find the "Voice Prompts" option in the above locations, click into "Settings" and then select "Destination Guidance Settings."
1
5
Share

How to Remotely Turn on the Air Conditioning in a BMW?

The car must first have the necessary hardware support. Activate this function in the iDrive system. Press the [Lock] button on the key three times consecutively. Find the remote control interface, then press and hold the middle [START/STOP] button for about 2 seconds to start the engine. Enter the vehicle status and control button interface, locate the [Ventilate Now] button, click to remotely start the engine, and confirm.
18
4
Share

How to Turn on the Heater in a Nissan Sylphy?

To turn on the heater in a Nissan Sylphy, follow these steps: 1. Start the car and wait approximately 5-10 minutes until the coolant temperature reaches the normal operating range. At this point, you can activate the car's heating system. 2. Adjust the Sylphy's air conditioning circulation mode to recirculate air inside the vehicle. 3. Switch to the heating mode by turning the temperature control dial to the red zone (the temperature adjustment range is 18-32°C). 4. Do not turn on the A/C compressor as the heating system utilizes the vehicle's own heat circulation to regulate temperature, which saves energy. 5. Set the blower fan to an appropriate speed level and adjust the air vent direction as needed.
5
2
Share

Does the Volkswagen Polo have a sedan version?

Volkswagen Polo does have a sedan version. Here is more information about the Volkswagen Polo: 1. The Volkswagen Polo was introduced in 1975. Over the next 30 years, it went through five generations of product evolution, with total production exceeding 7 million units. It long held the top position in sales of economical small cars in Germany and was known as the "wonder boy" of Volkswagen Germany. 2. In the autumn of 1995, the third-generation Polo series added a new member—the Polo sedan, which was designed purely for practical purposes to increase trunk space. The new 60-horsepower 1.4-liter light-metal engine replaced the previous 1.3-liter engine. A 1.6-liter light-metal engine with 100 horsepower was also introduced at the same time.
1
0
Share

Where is the Changan Eado manufactured?

Changan Eado is produced at Changan's Fifth Plant, which is located on Konggang Avenue in the New North District of Chongqing. Here is more information about the Changan Eado: 1. The Eado is a global strategic model meticulously developed by Changan Automobile's global R&D team over three years, representing a global, full-time premium mid-size sedan. On March 27, 2012, the independent brand Changan Automobile announced the official launch of its new sedan, the Eado. 2. On March 6, 2015, the pure electric version of the Changan Eado was officially launched, featuring a minimalist overall design, with two models available. The Eado is the first compact-class model on Changan's all-new C platform.
1
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.