How much gear oil should be added to the rear axle of a Toyota Crown at one time?

1 Answers
WilliamDella
07/29/25 1:54pm
Toyota Crown rear axle gear oil requires 2L per refill. The rear axle of a car refers to the rear axle of the vehicle. For front-wheel-drive vehicles, the rear axle is merely a trailing axle, serving only a load-bearing function. Typically, a transfer case is also installed in front of the rear axle. The Crown is a mid-to-large-sized car brand under the Toyota Group, with dimensions of 5020mm in length, 1805mm in width, and 1480mm in height, and a wheelbase of 2925mm. In terms of exterior design, the Toyota Crown features a large-mouth front grille design, a sizable U-shaped grille, sharp headlights with integrated LED daytime running lights in a light strip configuration, presenting a rather fashionable appearance.
Was this review help?
3
5
Share
More Forum Discussions

What are the maintenance precautions for the 10th generation Accord?

Honda Accord maintenance cycle is 5000 kilometers. The following are the maintenance precautions for Honda Accord: 1. After each maintenance, the maintenance light and related parameters need to be reset. 2. Spilled oil needs to be cleaned to prevent damage to body parts. 3. Daily maintenance requires checking the 'five oils and three liquids' on the car (five oils refer to engine oil, transmission oil, fuel, brake oil, and power steering oil; three liquids refer to coolant, windshield washer fluid, and battery fluid), and adding them in time if necessary. The following are the taboos of car maintenance: 1. Avoid running the engine for a long time in an unventilated garage. 2. Avoid sucking the oil pipe with your mouth. 3. Avoid getting carburetor cleaner on your skin. 4. Avoid mechanical injuries.
19
3
Share

Does Frequently Stalling a Manual Transmission Car Damage the Vehicle?

If a manual transmission car is frequently stalled, it can indeed harm the engine. Here are the relevant details: 1. Increased Carbon Deposits: When the engine is stalled, the crankshaft experiences some impact, and unburned gasoline remains in the cylinders. Over time, this leads to an increase in carbon deposits in the engine. To avoid stalling a manual transmission car when starting, it's essential to use the clutch's semi-engagement technique. 2. Speed Difference: During startup, there is a significant speed difference between the engine's flywheel and the clutch plate in a manual transmission car. If the clutch is fully engaged abruptly, the engine may stall. To prevent this, the semi-engagement technique should be used when starting, which gradually reduces the speed difference between the clutch plate and the engine flywheel, ensuring a smooth start.
18
3
Share

Are Four Wheel Hub Stickers Illegal?

Car wheel hub stickers are not illegal. Here are the specific details: Regulations: The law stipulates that car stickers must not exceed 30% of the vehicle's body area. If they exceed this limit, approval is required. If the vehicle's body stickers are too large and have not been approved by the public security traffic management department, it will result in inconsistency with the photo on the vehicle's registration certificate, leading to the vehicle being identified as illegally modified and subject to fines. Since car wheel hub stickers do not exceed 30% of the body area, they are not considered illegal. Car Sticker Regulations: Although the color of a motor vehicle can be modified, special colors such as fire engine red, engineering rescue yellow, and national administrative law enforcement white-blue cannot be used by ordinary cars. Therefore, when modifying a car, appropriate colors must be chosen, and approval must be obtained from the relevant authorities.
13
5
Share

How to Turn Off the Auto Start-Stop Function in Audi A6L?

Here are the steps to turn off the auto start-stop function in Audi A6L: 1. The auto start-stop function of Audi A6L is set on the screen above the gear lever on the center console, replacing the previous mechanical button. 2. To turn it off, simply touch the button location. 3. The purpose of the auto start-stop function is to save fuel for the vehicle. Below are the advantages of the auto start-stop function: 1. Fuel saving: The core of auto start/stop is to automatically control engine shutdown and startup, allowing the vehicle to temporarily turn off the engine during short stops, thereby reducing fuel consumption. 2. Environmental protection: With the increasing severity of air pollution, using auto start/stop can help reduce exhaust emissions.
3
1
Share

Where is the hazard light button on Tesla Model 3?

Tesla Model 3's hazard light button is located on the center console. Here are relevant details about the Tesla Model 3 hazard light button: 1. It features a red icon with two overlapping triangles. 2. Pressing it once activates the hazard lights, primarily to alert other vehicles or pedestrians about special circumstances involving this vehicle. Below are specifications regarding Tesla Model 3's body dimensions: 1. Length × width × height measurements are 4694mm × 1850mm × 1443mm respectively, with a wheelbase of 2875mm. 2. The front suspension uses double-wishbone independent suspension, while the rear employs multi-link independent suspension. 3. Built-in configurations include an onboard navigation system, color LCD center console screen, voice control system, and other devices.
16
5
Share

What are the causes of urban road surface collapse?

Road surface collapse causes include natural collapse and man-made collapse. Below are the specific reasons for road surface collapse: Natural collapse: Surface rocks and soil layers subside downward due to natural factors such as seismic vibrations, rainwater infiltration, gravitational pressure, and underground erosion-induced hollowing. Examples include loess collapse in the Loess Plateau region, lava collapse in volcanic lava distribution areas, and freeze-thaw collapse in permafrost zones. Man-made collapse: Ground subsidence caused by human activities, such as underground mining operations creating certain ranges of goaf areas, causing overlying rocks and soil layers to lose support and resulting in ground collapse; sudden water inflow during tunnel drainage or construction, excessive groundwater extraction, reservoir storage and water diversion, etc.
10
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.