How much gasoline evaporates in one hour?

2 Answers
VonSienna
07/24/25 4:05pm
Under normal temperature, 1 kilogram of gasoline can evaporate to produce 400 liters of gasoline vapor. Here are the relevant details: 1. Gasoline's volatility: The evaporation rate of gasoline is essentially a matter of its evaporation index, which refers to the property of gasoline transforming from a liquid to a gaseous state. According to relevant tests, under conditions of indoor temperature at 28°C and relative humidity at 85%, the evaporation rate of gasoline reaches 55% after 20 minutes. 2. Distillation range: Under normal temperature, 1 kilogram of gasoline can evaporate to produce 400 liters of gasoline vapor. Generally, substances evaporate fastest near their boiling points, but gasoline is a mixture and does not have a fixed boiling point. Instead, it has a distillation range, typically between 30 and 205 degrees.
Was this review help?
11
1
Share
SanLiam
08/11/25 9:00am
Oh, I remember last week when I was pouring gasoline in the garage, I forgot to put the cap back on. After just about an hour, I noticed the bottle felt much lighter and the smell of gasoline was really strong. Gasoline is prone to evaporation, especially in high-temperature environments like summer when the air conditioning isn't on—it evaporates even faster. The surface area also has a big impact; a large open container can lose dozens of times more gasoline than a small can. Wind speed matters too—a fan blowing on it will speed up evaporation. Generally, a rough estimate is that at room temperature, about half a cup's volume can evaporate in an hour, but it's hard to say exactly because conditions vary so much. Later, I learned to tighten the cap right away to avoid waste and safety risks, as it's also a fire hazard. So now, I'm extra careful when storing gasoline—using sealed containers to reduce risks and ensuring the garage is well-ventilated to prevent accidents.
Was this review help?
20
1
Share
Expand All
More Forum Discussions

What is the emission standard for the 2011 Tiida?

The 2011 Tiida complies with the China IV emission standard, which is the fourth phase of the national standard for motor vehicle pollutant emissions. More relevant information is as follows: 1. The main pollutants emitted by vehicles include HC, NOx, CO, PM, etc. Through the application of technologies such as improved catalytic converter active layers, secondary air injection, and exhaust gas recirculation systems with cooling devices, the standard aims to control and reduce vehicle emissions below specified limits. 2. The Tiida is a compact car under the Nissan brand. The 2011 Tiida is equipped with a 1.6-liter naturally aspirated engine, model code HR16DE, with a maximum power of 93kW and a maximum torque of 154Nm. This engine is paired with either a 6-speed manual transmission or a CVT transmission.
7
3
Share

Is the Eclipse Blue car color eye-catching?

Eclipse Blue colored cars are quite eye-catching, and Eclipse Blue is a car color offered by many automobile manufacturers. Here is some information about car colors: 1. Car color falls within the scope of automotive design. From an aesthetic perspective, only the right car color can better highlight the vehicle's styling design. Only in this way can the characteristics of the car be better expressed. The body color is also part of the car designer's creation. 2. People's perception of color is often influenced by surrounding colors. Car color plays a significant role in determining a vehicle's sales performance.
13
2
Share

Where are the Civic door drain holes located?

Civic door drain holes are located at the lower part of the door panel, with at least two on each door. Here is an introduction to car drain holes: 1. Sunroof drain hole: Due to its position, the sunroof drain hole is prone to blockage by leaves and other debris. If blocked, rainwater can seep through the edges of the sunroof into the car, potentially wetting the roof trim or even causing severe water accumulation inside the cabin. 2. Door drain hole: Door drain holes are usually located at the lower part of the door panel, with at least two on each door. Because of their low position, vehicles frequently driven on muddy roads may find these holes clogged with mud over time. 3. Trunk drain hole: Under normal circumstances, the trunk does not easily accumulate water. However, in extreme situations like vehicle submersion, the trunk drain hole may need to be manually opened to drain water. Depending on the vehicle, there are usually 1-2 trunk drain holes, located inside the spare tire well. 4. Fuel tank cap drain hole: Most fuel tank openings face upward, making the lower part prone to water accumulation. To prevent this, a "drain" is installed at the bottom. If this drain hole is blocked, water can accumulate during rain, posing a risk to metal components like the fuel tank cap and door panels. Therefore, this area also requires regular inspection and cleaning.
14
2
Share

What is the best oil model for Verna?

Verna is best suited with 5W20 oil. When adding oil, the amount needed should be determined based on the markings on the dipstick. Verna engines are equipped with an oil dipstick, which typically has two markings: one indicating the maximum oil level and the other the minimum oil level. The optimal oil level is between these two marks. Here are some details about oil models: 1. Oil models consist of two parts: classification and viscosity specification. The oil model usually indicates viscosity and quality. The viscosity of lubricating oil is often identified using SAE grades, where SAE stands for the Society of Automotive Engineers. 2. On the outer packaging of oil, you will often see SAE and API. SAE is the abbreviation for the Society of Automotive Engineers, and API stands for the American Petroleum Institute. The number following SAE indicates the oil's viscosity, while the number following API indicates the oil's quality grade.
16
4
Share

How to Deal with Frost on the Car Windshield?

Here are the methods to handle frost on the car windshield: 1. Frost on the windshield in winter is a normal occurrence. In such cases, you can soak a towel in warm water and wipe the windshield. After wiping the glass with the towel, make sure to dry the water on the glass thoroughly; otherwise, frost may form again. 2. Alternatively, after getting into the car, you can turn on the warm air from the air conditioner to raise the interior temperature and melt the frost on the glass. 3. To prevent frost, you can cover the windshield with a blanket when parking at night. It is also recommended to lift the windshield wipers when parking in winter nights to prevent them from freezing to the glass.
18
4
Share

How to set up auto-lock for the 10th generation Accord?

To set up the auto-lock feature for the 10th generation Accord, you need to visit a 4S shop to have the program updated. Here is some information about the auto-lock function: 1. The auto-lock function is a very practical feature. It automatically locks the car doors when the vehicle is in motion, preventing passengers from accidentally opening the doors and offering protection against door-pulling theft during traffic jams or at red lights, thereby enhancing safety. 2. The 10th generation Accord is equipped with either a 1.5-liter turbocharged engine or a 2.0-liter naturally aspirated engine. Models with the 1.5-liter turbocharged engine use a CVT transmission, while those with the 2.0-liter naturally aspirated engine use an eCVT transmission.
17
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.