How much fuel does a 340 horsepower engine consume at idle for one hour?

1 Answers
VanBrielle
07/29/25 11:03am
340 horsepower engine consumes approximately 6 liters of fuel when idling for one hour. Relevant information about idling is as follows: 1. Introduction: Idling is a working condition of a car, referring to the engine running in neutral gear. The engine speed during idling is called the idle speed. The idle speed can be adjusted by modifying the throttle size, etc. Idling means the engine "produces power without doing work." 2. Driving idle: When the car is in gear, without stepping on the accelerator pedal or releasing the accelerator pedal during driving, maintaining the minimum throttle opening, the engine speed is the same as the parking idle speed. This state is called driving idle.
Was this review help?
4
0
Share
More Forum Discussions

How to Repair Car Dents and Scars?

Use a dent puller to suck out the dent from the outside of the car body. Remove the interior and use tools to pry out the dented area from the inside of the car body. Use a rubber hammer to tap it back into place and level it. For shallow scratches or stains (suitable for very light scratches and stains), you can use an eraser, toothpaste, or essential balm to remove small scratches on the car body. For small, slight dents on plastic car bodies, you can use a lighter with aluminum foil or a hairdryer to heat the area until it softens, then push it out from the inside with your fingers. For large dents on aluminum or metal car bodies, you can apply Vaseline to a plunger, place it on the dented area, and pull hard.
16
4
Share

How to Clean Water Stains on Car Interior Ceiling?

First, use a high-power vacuum cleaner for dust removal, while also using a soft ceiling brush for preliminary cleaning of the ceiling. Spray a neutral foam cleaner onto the ceiling fabric. After a few minutes, gently and meticulously brush with a specialized soft-bristle ceiling cleaning brush, then wipe with a damp towel. Avoid using other hard-bristle brushes, as this may cause the fabric fibers to shed. Make sure to purchase the correct foam cleaner. A dry foam cleaner for fabric sofas can be used, which, when sprayed, will cause dust to coagulate into small beads that can then be vacuumed away. When cleaning, use a wrung-out cotton cloth or towel. A wet towel may saturate the ceiling material with cleaner, making it difficult to dry and potentially causing the material to peel.
10
3
Share

How to Lock a Car?

First, the vehicle needs to be stationary, and all doors must be fully closed for the locking system to engage. Place the gear shift lever in the P (Park) position and press the one-touch start button to turn off the engine. Engage the handbrake, exit the vehicle, close all doors, and press the lock button on the remote key fob. Remote locking method: The key fob has three buttons (unlock, lock, and open trunk or rear door). Press the lock button to lock the car, and the headlights will flash once.
20
0
Share

How to Use a Car Lift?

Before use, clear away any tools or debris around the lift that may hinder operation, and check if the control handle is functioning properly. The hydraulic system should not exhibit any creeping phenomena. When positioning the vehicle, ensure all four support arms are on the same plane. Adjust the height of the rubber pads on the support arms to make proper contact with the vehicle's chassis support points, avoiding excessive lifting. All four brackets must be securely locked. After driving the vehicle onto the lift, adjust the support blocks to align with the designated lift points for the specific vehicle model. Insert the safety lock pin when raising to the required height. If operational mechanisms become unresponsive, motors are out of sync, or brackets are uneven, promptly report for repairs. After completing operations, remove all debris and clean the surrounding area to maintain a tidy workspace. Regularly drain accumulated water from the hydraulic cylinders and check oil levels. If oil is insufficient, promptly refill with the same grade of pressure oil. Simultaneously inspect lubrication, transmission gears, and chains.
2
1
Share

How to Adjust the Height of the Car Seat Belt Slot?

First, locate the seat belt adjustment button at the seat belt position in the vehicle. You can press the button downward with your hand to adjust the height of the seat belt. Finally, hold the button with both hands and move it downward to lower the seat belt position, or push it upward to raise the seat belt position. Petite drivers should appropriately lower the height; otherwise, the force exerted by the seat belt on the body during emergency braking may cause injury. The function of the seat belt is to restrain movement and provide cushioning, absorbing impact energy, dissipating inertial force, and preventing or reducing the severity of injuries to drivers and passengers.
4
0
Share

How to Remove the Car Key Battery?

Extract the mechanical key, usually by pressing a small button, then pull it out. Use a small flat-head screwdriver to pry open the car key. There will be a small gap in the middle of the key, gently twist to pry it open. After opening the key back cover, remove the battery. When replacing the battery, ensure there is no dirt or other foreign matter on the electrode contact points. After replacing the battery, check if the key functions properly. When purchasing a car key battery, make sure it has the same voltage and model as the original battery.
6
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.