How much engine oil is appropriate for the X-Trail?
4 Answers
The 2.0L model of the X-Trail requires 4 liters of engine oil, while the 2.5L model requires 5 liters. Below is an introduction to engine oil: 1. Function: It lubricates and reduces friction in the engine, assists in cooling, provides sealing to prevent leaks, prevents rust and corrosion, and acts as a shock absorber. It is often referred to as the 'blood' of a car. 2. Composition: Engine oil consists of base oil and additives. The base oil is the main component of the lubricant, determining its basic properties, while additives compensate for and improve any deficiencies in the base oil's performance, providing certain new characteristics. Additives are an important part of lubricants.
The oil capacity for the X-Trail depends on the specific model. For my 2019 2.0L version, changing both the oil and filter requires about 4.2 liters. Last time at the dealership, the mechanic poured in exactly 4 liters first, ran the engine for five minutes, shut it off, waited ten minutes, then checked the dipstick. It was just at the lower mark, so they added another 200 ml to reach the midpoint. This amount is close to the 4.3 liters specified in the owner's manual. Older 2.5L models might need about 0.3 liters more. If you're changing the oil yourself, it's better not to buy a large drum. Get two 4-liter bottles—open a new one and use just over half, then seal the rest for next time. Be careful not to overfill, as exceeding the upper limit can damage the catalytic converter.
I have owned the X-Trail for three years and have changed the oil four times myself. Based on actual measurements, when replacing the oil in the 2.0L engine, the refill amount after draining the old oil completely ranges between 4.1 to 4.3 liters, depending on the residual oil in the oil pan. Using an oil extractor might reduce this by about 50 milliliters. The most accurate method is always to check the dipstick when the engine is cold, aiming to fill it to about two-thirds of the way between the upper and lower marks. The Nissan service manual specifies a capacity of 4.3 liters, but in practice, since it's impossible to completely drain all the old oil, a 4-liter oil container often leaves about 200 milliliters unused. If an aftermarket oil filter is used, the refill amount may need slight adjustment due to differences in filter capacity. Always check the oil level on level ground, as a slope can lead to incorrect readings.
The oil capacity for the X-Trail varies by engine model. Mainstream 2.0L models require approximately 4.2 liters for an oil change, while the 2.5L version needs around 4.5 liters. Hybrid versions differ in oil volume. It’s most convenient for owners to prepare a 5L container of oil. During the oil change, add 3.8 liters first, then start the engine and let it circulate for one minute. After turning off the engine, wait for the oil to settle before checking the dipstick. If the level is below the MIN mark, add oil slowly in increments of no more than 100 ml each time. During maintenance, check if the oil filter has been replaced—a new filter absorbs about 150 ml more oil. The factory service data specifies an oil change capacity of 4.3±0.1 liters, including the filter. Never pour all the oil in at once for convenience; instead, add it in stages for accuracy.
