How much does the new Jetta SUV VS7 weigh?

1 Answers
LaGenesis
07/30/25 8:51am
The curb weight of the Jetta VS7 ranges from 1.5 tons to 1.7 tons. The Jetta VS7 is a mid-sized SUV. The curb weight of a vehicle refers to the gross weight of the car when it is fully equipped according to the factory's technical conditions, including all necessary fluids. This is an important design indicator for automobiles. Jetta VS7 powertrain: The Jetta VS7 is equipped with Volkswagen's 280TSI engine, paired with a 6AT transmission. It delivers a maximum horsepower of 150 and a maximum torque of 250. This efficient golden powertrain system provides ample power and smooth coordination, with very responsive acceleration. Jetta VS7 features: The Jetta VS7 is equipped with the ACC-3.0 third-generation advanced adaptive cruise control system. For those who frequently drive long distances, constantly adjusting speed, braking, and accelerating on the highway can be very tiring. The Jetta VS7 uses a radar hidden in the front bumper to determine the distance to the vehicle ahead, accelerating when the leading car speeds up and decelerating when it slows down.
Was this review help?
1
3
Share
More Forum Discussions

What is the Difference Between Rear-Wheel Drive and Front-Wheel Drive Cars?

Introduction to the differences between rear-wheel drive and front-wheel drive cars: 1. Engine layout. Rear-wheel drive cars mostly adopt a longitudinal engine arrangement, while front-wheel drive cars use a transverse engine arrangement. In comparison, rear-wheel drive cars occupy more space, especially with the noticeably raised floor in the rear seats. If someone sits in the middle of the rear seats, the rear-wheel drive car may be at a disadvantage. 2. Driving and handling experience. The front wheels are mainly responsible for steering, while the rear wheels are responsible for driving. Therefore, for front-wheel drive cars, during sharp turns, understeer can easily occur. Secondly, rear-wheel drive cars can achieve a more balanced (close to 50:50) weight distribution, which can bring a different driving experience in terms of both vehicle stability and speed limits. 3. Fuel consumption. Due to the addition of a driveshaft in rear-wheel drive cars, there is higher power loss, resulting in higher fuel consumption compared to front-wheel drive cars.
13
4
Share

Is the Chevrolet Equinox Four-Wheel Drive?

The Chevrolet Equinox is four-wheel drive. Here is some extended information about the Chevrolet Equinox: Basic parameters of the Equinox: The specific dimensions of the Chevrolet Equinox are 4652×1843×1688mm, with a wheelbase of 2725mm. Its size performance is considered above average among vehicles in its class, so the overall passenger space is relatively spacious. Additionally, the seats inside the vehicle are wrapped in genuine leather, providing exceptional seating comfort. Powertrain configuration of the Equinox: The Chevrolet Equinox is equipped with 1.5T and 2.0T turbocharged engines, delivering maximum horsepower of 169 hp and 260 hp, and maximum torque of 250 Nm and 353 Nm, respectively. The transmission is matched with a 6-speed automatic transmission and a 9-speed automatic transmission. Some models also feature an all-wheel-drive system, making the overall power performance relatively impressive.
20
4
Share

Can Electric Cars Be Charged in the Rain?

Electric vehicles can be charged during rainy weather. Below are relevant details about electric vehicles: 1. Composition: They consist of an electric drive and control system, mechanical systems like drivetrain components, and operational devices to accomplish set tasks. The electric drive and control system is the core of an electric vehicle and represents the key difference from internal combustion engine vehicles. This system includes components such as the drive motor, power source, and motor speed control devices. The overall structure of electric vehicles is largely similar to that of internal combustion engine vehicles. 2. Power Source: Provides electrical energy to the vehicle's drive motor, which converts this energy into mechanical power. The most widely used power source has been lead-acid batteries, but with advancements in EV technology, these are gradually being replaced by other battery types due to their lower energy density, slower charging speeds, and shorter lifespan.
14
5
Share

What does a red coolant temperature light indicate?

The red coolant temperature warning light indicates that the engine coolant temperature is too high, signaling an abnormality in the engine cooling system. Here is relevant information: 1. Overheating: Excessive coolant temperature causes significant damage to the engine, commonly referred to as "boiling over," with excessive noise being the first symptom. Overheating can lead to deformation or even damage of the cylinder head and engine block, as well as dilution of engine oil and altered performance of automotive components. The optimal normal coolant temperature range is between 75 to 90 degrees Celsius. 2. Precautions: If overheating occurs, first reduce speed and pull over to the roadside. Do not immediately shut off the engine, as excessively high temperatures can cause overheating of pistons, cylinder walls, cylinders, crankshafts, etc., thinning the engine oil and causing loss of lubrication.
5
5
Share

What Causes the Clicking Sound in BMW Brakes?

The causes of the clicking sound in BMW brakes are: 1. Uneven wear of the brake discs, where radial runout exceeds the standard value when measured with tools; 2. The occurrence of uneven surfaces during usage. The solutions for the clicking sound in BMW brakes are: 1. Replace with new brake pads and perform chamfering treatment; 2. Inspect and remove any foreign objects between the brake disc and brake pad, and clean the braking mechanism. Taking the BMW 3 Series as an example: It is a mid-size sedan equipped with a 2.0L turbocharged engine, producing a maximum horsepower of 156 HP and a maximum torque of 250 Nm. The car's dimensions are 4719mm in length, 1827mm in width, and 1459mm in height, with a wheelbase of 2851mm, and it is fitted with an 8-speed automatic transmission.
4
5
Share

How often should a car be polished?

Generally, polishing once a year is sufficient, or it can be determined based on the actual condition of the car's paint, as polishing can significantly damage the paint. The methods for maintaining car paint are as follows: 1. Car washing: This is a maintenance method adopted by many car owners and is the most basic method. Whether parked or driven, the car body will inevitably accumulate some dirt. The composition of this dirt is complex and may contain acidic corrosive substances, which can cause some damage to the paint over time. Therefore, regular car washing can help protect the paint. 2. Waxing: This involves applying a layer of wax to the car's paint surface and then polishing it. Waxing helps prevent oxidation, isolate static electricity, and enhance the brightness of the paint surface. It effectively separates the paint from dust and harmful gases, thereby protecting the paint. 3. Coating: This involves applying a high-molecular film with good hardness and smoothness to the car's surface. This film solidifies directly on the vehicle's surface, meaning the paint is directly protected by this film. Even minor damage will not affect the paint surface.
17
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.