How Many Training Hours Are Required for Subject 2?

1 Answers
SilasMarie
07/29/25 10:16am
For the commonly tested C1 driver's license, Subject 2 requires 16 training hours. Here is an introduction to the Subject 2 test: 1. Test Content: Reverse parking, parallel parking, stopping and starting on a slope, right-angle turns, and curve driving (S-turns). Some regions have added four additional assessment items: simulated tunnel driving, simulated slippery road driving, parking to retrieve a card, and U-turns on narrow and wide roads. 2. Passing Standard: The total score for Subject 2 is 100 points, with 80 points required to pass for a C1 driver's license. The basic requirements of the test are to master the fundamental driving operation essentials, possess the ability to control the vehicle, proficiently understand the prescribed methods for driving on the test site and internal roads, and accurately maneuver the vehicle to pass through specified spatial positions, speeds, and routes.
Was this review help?
16
5
Share
More Forum Discussions

How to Adjust the Rearview Mirrors on the Tiida?

The method to adjust the rearview mirrors on the Tiida is as follows: 1. The rearview mirror adjustment knob is located near the door handle. Turn the knob to the left to the left mirror symbol position, then you can move the knob up, down, left, or right to adjust the angle of the left rearview mirror; 2. Turn the knob to the right to the right mirror symbol position to adjust the angle of the right rearview mirror; 3. There is also a "0" symbol in the middle, representing the neutral position, which prevents accidental touching of the knob and disrupting previous settings. Taking the 2021 Tiida as an example, it is a compact car with body dimensions of: length 4393mm, width 1766mm, height 1539mm, wheelbase of 2700mm, minimum ground clearance of 130mm, and a body weight of 1180kg.
8
5
Share

What is a Limiter Gear?

Limiter gear is a manual gear. Precautions for starting a manual transmission car: 1. Do not release the clutch too quickly, lift it slowly; 2. Press the accelerator after the engine and drive shaft are connected; 3. Gently press the accelerator during semi-engagement, then release the clutch; 4. Release the handbrake before starting. The function of a manual transmission: By manually shifting the gear lever to change the gear meshing position inside the transmission, the transmission ratio is altered to achieve the purpose of shifting gears. The steps to start a manual transmission car are: 1. Get in the car and sit properly; 2. Start the car; 3. Press the clutch; 4. Engage first gear; 5. Slowly release the clutch; 6. Gently press the accelerator; 7. Fully release the clutch, and the car starts successfully.
16
1
Share

What to Do If the Car's Windshield Washer Fluid Reservoir is Leaking?

The solution for a leaking windshield washer fluid reservoir in a car is to replace either the reservoir itself or the connected hoses. The windshield washer fluid reservoir is located at the front of the engine and serves as a container for storing windshield washer fluid, which is used for cleaning, removing dirt, and providing anti-corrosion protection for car windows. Precautions for using windshield washer fluid include: 1. Spray intermittently rather than continuously; 2. Be mindful not to overfill the reservoir. The method for adding windshield washer fluid is as follows: 1. Open the front hood and locate the windshield washer fluid reservoir; 2. Open the packaging of solid windshield washer fluid and place it into the reservoir; 3. Add clean water until the reservoir is full; 4. Wait for the solid windshield washer fluid to completely dissolve.
18
1
Share

How to remotely start the CT6?

The method to remotely start the CT6 is: 1. Press the lock button on the remote key; 2. Immediately hold the start button for more than 4 seconds. Remote start means starting the engine remotely through the remote key. When using it, the owner should pay attention to the following: 1. The vehicle must be within a 50-meter range for remote start; 2. After the vehicle is remotely started, you need to open the door and wait for a while to let the stale air circulate out. The CT6 is a mid-to-large-sized car with the following dimensions: length 5223mm, width 1879mm, height 1492mm, wheelbase 3109mm, fuel tank capacity 72L, trunk capacity 503L, and curb weight 1695kg.
1
0
Share

What are the causes of the panoramic sunroof rattle in the Highlander?

The causes of the panoramic sunroof rattle in the Highlander are: 1. Loose sunroof movement axis; 2. Aging sunroof components; 3. Lack of lubrication in the sunroof. Taking the 2020 Highlander as an example, its body dimensions are: length 4890mm, width 1925mm, height 1715mm, wheelbase 2790mm, and fuel tank capacity 72.5l. The 2020 Highlander features a MacPherson strut front suspension and an E-type multi-link rear suspension. It is equipped with a 2.0L inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 220ps, maximum power of 165kw, and maximum torque of 350nm, paired with a 6-speed automatic transmission.
4
3
Share

How to Match a Car Key After Duplication?

Car key matching method after duplication is as follows: 1. Use the spare key to turn on the ignition switch; 2. Outside the door, turn the key toward the lock direction and hold it; 3. Press the unlock button on the remote once; 4. After five seconds, press the unlock button again, and the door lock will automatically open, completing the key setup. The functions of a car key include: 1. Automatically closing windows after turning off the engine; 2. Conveniently locating the car in a parking lot; 3. Automatically opening the trunk; 4. Remotely opening windows. Precautions for replacing car key batteries are: 1. Wrap the tip of the screwdriver with cloth when disassembling the key to prevent damage; 2. Avoid exposing the disassembled key and circuit board to water and keep them as dry as possible; 3. Do not touch the components on the circuit board; 4. Ensure the new battery model matches the old one.
9
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.