How many total training hours are required for Subject 2?

2 Answers
JaxsonRose
07/28/25 7:46pm
Subject 2 requires 24 training hours, consisting of 2 hours of theoretical instruction and 22 hours of practical operation. Below are the key points to note for the Subject 2 test: 1. Reverse Parking: The main deduction points for reverse parking include running over lines, failing to enter the parking space, exceeding the time limit, and not following the designated route. After the new regulations, reverse parking now has a time limit of 210 seconds; exceeding this time results in failure. During the test, perform right-side reverse parking first, followed by left-side reverse parking. Not following this sequence will result in failure. Pay attention to maintaining a 30cm margin from the side. 2. Parallel Parking: The main deduction points for parallel parking involve turn signals, maintaining a 30cm margin, and running over lines. When entering the test area, steer right in advance and align the highest point of the windshield wiper with the roadside line to adjust the 30cm margin. During reverse parking, remember the first right full-lock point, straightening the wheels, then left full-lock, parking in the space, and activating the left turn signal. When exiting, observe the rearview mirrors to prevent the wheels from running over the lines. 3. 90-Degree Turn: The main deduction points for the 90-degree turn involve turn signals and running over lines. Activate the turn signal upon entering the test area and turn it off after the voice prompt. Incorrect turn signal operation deducts 10 points. After entering the 90-degree turn, adjust the vehicle to maintain a 30cm margin from the side line, similar to parallel parking. When performing the full-lock turn, slightly release the clutch to prevent stalling or stopping midway. Straighten the vehicle only after the rear wheels exit the turn to prevent
Was this review help?
20
1
Share
VonEleanor
08/12/25 12:39am
I just finished my Subject 2 driving test recently, and I remember the required training hours are quite fixed, usually at least 16 hours. However, these 16 hours aren't just about practicing randomly—they must be allocated according to regulations: 4 hours for reverse parking, 4 hours for hill start and stop, and the remaining 8 hours divided among parallel parking, right-angle turns, and curve driving. When I was clocking in at the driving school, I also noticed that every student had to record their training hours via facial recognition, and the system was extremely strict—even one minute short wouldn't count. I suggest you ask the driving school clearly when signing up if they offer a package that covers training hours. Some schools provide extra practice time, as 16 hours might not be enough for beginners, especially for mastering basics like clutch control. During actual practice, the instructor will arrange flexibly based on your progress. For example, my cousin, who learned to drive an automatic, had 2 hours less hill practice.
Was this review help?
3
3
Share
Expand All
More Forum Discussions

How to Activate Cruise Control in the Tiguan L?

The cruise control switch for the Tiguan L is located in the functional area on the right side of the steering wheel. To activate cruise control, move the switch to the "ON" position; to deactivate it, move the switch to the "OFF" position. Please use cruise control under the premise of ensuring driving safety, typically on highways, sparsely populated areas, or well-developed suburban road networks. Precautions when using cruise control: 1. Braking by the driver: Cruise control requires the driver to manually apply the brakes; adaptive cruise control will automatically brake. 2. Cruise control deactivates upon braking: The set speed value is still retained, and cruise control can be manually restored. 3. Situations where cruise control should not be activated: Using cruise control on winding, steep, bumpy, slippery roads, or in heavy traffic can be dangerous. Always turn off cruise control to avoid potential hazards.
2
5
Share

How to Choose Between Wuling Rongguang New Truck 1.5 and 1.8?

The 1.8L version of the Wuling Rongguang New Truck is better compared to the 1.5L version. The details are as follows: 1. Performance: The main differences between the Wuling Rongguang New Truck 1.5 and 1.8 lie in the engine displacement, rated power, and maximum torque. Comparing these three aspects, the 1.8L version outperforms the 1.5L version. Therefore, if you have to choose between the two, the 1.8L is the better option. 2. Budget: When selecting a vehicle, it's essential to consider all factors. If your budget is sufficient, opting for the 1.8L engine model is undoubtedly better, as it offers superior power performance. Additionally, consider the amount of cargo you typically transport. If your budget is limited and you usually carry light loads, the 1.5L engine model is sufficient. Choosing the one that best suits your needs is the optimal decision.
12
5
Share

Why does it prompt 'No Training Attended' after completing the required hours for Subject 1?

Insufficient hours for Subject 1 have resulted in the inability to make a normal appointment. According to the new regulations on driving skill training, driver training must be clocked in. Students must insert their IC card into the driving training management recorder and press their fingerprint to start learning, which will then be counted as valid training hours. Only after completing the required hours and passing all subject exams can one obtain a driver's license. This system is designed to ensure teaching quality and prevent students and instructors from cutting corners. Additional information: Motor vehicle driving is a complex skill, and countries around the world have set entry barriers for motor vehicle drivers. In China, the 'Motor Vehicle Driving Teaching and Examination Syllabus' issued by the Ministry of Transport and the Ministry of Public Security specifies the required hours for corresponding vehicle types. Reduced training time makes it difficult to master driving skills proficiently, not only affecting students' exam pass rates but also potentially creating 'road killers,' seriously endangering the personal safety of drivers and others.
5
1
Share

How to reset the tire pressure monitoring for the Ant?

Turn on the ignition and press the MENU button on the combination switch on the right side of the steering wheel to bring up the system settings main menu. Select Tire Pressure and press the OK button. Choose Settings, then select Spare Tire to proceed to the next step. Select Tire Repair Setting. Start the vehicle and drive for a few minutes. When the instrument panel prompts to confirm the tire repair setting, select Yes to complete the reset.
17
5
Share

How to Install a Diesel Engine Oil Pump?

First, clean the electronic oil pump of the diesel vehicle. Apply a small amount of sealant onto the gasket. Apply sealant on the oil pump mating surface. Install the oil pump assembly smoothly onto the crankshaft. Tighten all the surrounding fixing screws to complete the installation.
18
0
Share

How to Adjust the Idle Speed of a Underbone Motorcycle?

Tighten the idle adjustment bolt, then loosen it by 1.5-2.0 turns. Slowly loosen the throttle bolt to reduce the engine speed to a very low level, almost to the point of stalling. Adjust the bolt to raise the engine speed to its highest point. Repeat this process 2-3 times until adjusting the idle bolt no longer increases the engine speed. The engine speed should reach the required range (800-1000 RPM). Accelerate and then release the throttle to check if the engine stalls. If it doesn't stall, it means the idle speed has been properly adjusted.
9
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.