How many times do you usually negotiate at a 4S store when buying a car?

What engine is used in the FAW Besturn B30?

The FAW Besturn B30 is equipped with a 1.6-liter naturally aspirated engine, delivering a maximum horsepower of 109 hp, a maximum power output of 80 kW, and a peak torque of 155 Nm. This engine provides sufficient power for urban commuting. The advantages of turbocharged engines include stronger power output and higher fuel efficiency. The FAW Besturn B30 measures 4625mm in length, 1790mm in width, and 1500mm in height, with a wheelbase of 2630mm. It features front-wheel drive, a front MacPherson independent suspension, and a rear torsion beam semi-independent suspension.

10

4

Share

Should You Look at the Front Door Handle or Rear Door Handle When Reversing into a Parking Space?

When reversing into a parking space, you should look at the rear door handle. While adjusting the direction, keep the car in reverse gear and maintain the steering wheel at its left-turn limit position, then continue reversing. The driver should observe the left side mirror and adjust the direction to guide the rear of the car into the parking space. Once the car is inside the parking space, the driver should check the right side mirror. As soon as the entire right boundary line of the parking space becomes visible, immediately straighten the steering wheel. Below are some key points to note when reversing into a parking space: 1. Control the driving speed: Maintain a consistent speed throughout using first gear or reverse gear at idle speed. The speed at which you start should be the speed you maintain. 2. Control the timing of steering: During reversing, observe carefully and master the critical points for steering adjustments. 3. Control the driving path: The car's path during the test primarily depends on the speed of steering wheel adjustments and driving speed. When reversing, accurately align with the boundary lines and promptly correct the direction to ensure the car enters the parking space straight.

2

0

Share

Does the 360 Full Coverage Car Mat Include a Trunk Mat?

360 Full Coverage car mats include a trunk mat. Here is an introduction to the 360 Full Coverage car mats: 1. Installation: When installing the 360 Full Coverage car mats, it is necessary to completely remove the seats and disassemble some of the wiring. After reassembly, some issues may arise, which could pose safety hazards during normal driving. 2. Less Prone to Shifting: The 360 Full Coverage mats are installed more thoroughly, so they are less likely to shift during daily use. 3. Coverage: The 360 Full Coverage mats have a wider coverage area, which helps to keep the interior of the car cleaner and tidier. 4. Not Easily Removable: The 360 Full Coverage mats cannot be easily removed for daily cleaning, making them more difficult to clean.

8

1

Share

Can I go straight in a lane with both straight and left-turn arrows?

A lane marked with both straight and left-turn arrows on the ground is a combined straight and left-turn lane. When the straight signal is green, you can proceed straight. According to Article [number] of the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China", lane traffic signals indicate: 1. When the green arrow light is on, vehicles in this lane are permitted to proceed in the indicated direction; 2. When the red cross light or arrow light is on, vehicles in this lane are prohibited from proceeding. Extended information: Article 51 of the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China" states that when motor vehicles pass through intersections controlled by traffic signals, they shall proceed according to the following provisions: 1. At intersections with marked directional lanes, enter the directional lane according to the intended direction of travel; 2. Vehicles preparing to enter a roundabout shall yield to vehicles already inside the intersection; 3. When turning left, turn from the left side of the intersection center point. Turn signals must be activated when turning, and low beams must be used at night; 4. When encountering a green light, proceed in sequence; 5. When encountering a red light, stop in sequence behind the stop line. If there is no stop line, stop before entering the intersection; 6. When turning right and encountering a vehicle in the same lane waiting for a green light, stop and wait in sequence; 7. At intersections without directional signal lights, turning vehicles shall yield to straight-moving vehicles and pedestrians. Right-turning vehicles from the opposite direction shall yield to left-turning vehicles.

7

5

Share

What is the Definition Standard for a Major Accident Vehicle?

Accident vehicle identification standards refer to vehicles that have experienced severe collisions or impacts, prolonged water immersion, severe fires in the engine compartment or passenger compartment with relatively large burn areas, and significant mechanical damage. Additional information: Methods for identifying accident vehicles include: exterior inspection, light inspection, insurance record checks, and interior inspection. Any of the following conditions qualifies a vehicle as an accident vehicle: 1. Vehicles that have been impacted, causing damage to the engine compartment. 2. Vehicles with rear quarter panel impact damage exceeding one-third of the panel. 3. Vehicles with welded, cut, reshaped, or deformed longitudinal beams. 4. Vehicles with welded, cut, reshaped, or deformed shock absorber mounts. 5. Vehicles with welded, cut, reshaped, or deformed A, B, or C pillars. 6. Vehicles whose airbags deployed due to impact. 7. Vehicles with severe welding, cutting, reshaping, or deformation in other non-removable parts. 8. Vehicles with water immersion exceeding half of the body or water entering the cabin. 9. Vehicles with fire damage exceeding 0.5 square meters, posing safety hazards even after repairs.

16

2

Share

Is the BAIC Weiwang S50 an SUV?

The BAIC Weiwang S50 is an SUV, specifically a compact SUV with dimensions of 4654mm in length, 1816mm in width, and 1680mm in height, and a wheelbase of 2670mm. The BAIC Weiwang S50 is equipped with a 1.5-liter turbocharged engine across the entire lineup, providing sufficient power for general urban driving. The front suspension of the BAIC Weiwang S50 uses a MacPherson independent suspension, while the rear suspension employs a multi-link independent suspension. The interior of the BAIC Weiwang S50 features a brown and black color scheme, with some areas incorporating wood-like trim and silver accents. The instrument cluster adopts a dual-dial design. Additionally, the BAIC Weiwang S50 comes with a three-spoke multifunction steering wheel and a 9-inch central touchscreen, which is expected to integrate a smartphone connectivity system.

9

1

Share

How many times do you usually negotiate at a 4S store when buying a car?

What engine is used in the FAW Besturn B30?

Should You Look at the Front Door Handle or Rear Door Handle When Reversing into a Parking Space?

Does the 360 Full Coverage Car Mat Include a Trunk Mat?

Can I go straight in a lane with both straight and left-turn arrows?

What is the Definition Standard for a Major Accident Vehicle?

Is the BAIC Weiwang S50 an SUV?

How Many Copies of the Personal Vehicle Purchase Invoice Does the Owner Receive?

What Does Warning Protection System Malfunction Mean?

What are the road test items?

What are the effects of changing from 265 to 285 tires?