How Many Times Can a Vehicle Be Re-inspected If It Fails the Initial Inspection?

2 Answers
BriellaDella
09/05/25 4:56am
Vehicles that fail the initial inspection have a total of three opportunities for re-inspection, and no additional fees are required for re-inspections. Below are the specific details regarding vehicle inspections: 1. Commercial passenger vehicles: Commercial passenger vehicles must be inspected annually within the first 5 years; after 5 years, they must be inspected every 6 months. 2. Large and medium-sized non-commercial passenger vehicles: Trucks and large and medium-sized non-commercial passenger vehicles must be inspected annually within the first 10 years; after 10 years, they must be inspected every 6 months. 3. Non-commercial private vehicles with fewer than 7 seats: Non-commercial private vehicles with fewer than 7 seats are exempt from inspection for the first 6 years; after 6 years, they must be inspected annually; after 15 years, they must be inspected every 6 months. (New vehicles involved in fatal accidents within the first 6 years are not eligible for the exemption.) 4. Motorcycles: Motorcycles must be inspected every 2 years within the first 4 years; after 4 years, they must be inspected annually.
Was this review help?
8
0
Share
DeAyla
09/17/25 5:22am
As a car owner, I've experienced failing a vehicle inspection due to excessive exhaust emissions. The inspector said I could get one free retest within 15 days. After fixing the issue and retesting, I passed. However, if you fail consecutively, you might get one or two more chances depending on local regulations. My neighbor took three attempts to pass because of brake issues, nearly needing part replacements on the final try. The key is to address faults promptly—don't count on unlimited retries. Always check with the inspection center for details, as some places charge for retests and limit attempts. Handling it quickly saves multiple trips in the long run.
Was this review help?
13
4
Share
Expand All
More Forum Discussions

How to Determine if the Windshield is Double-Layered?

Hollow glass usually contains desiccant or is filled with inert gas, with desiccant being more common, while double-layered glass does not have these; The edges of hollow glass are sealed with sealant, typically black in color; double-layered glass lacks this sealing, making it prone to moisture and dust ingress.
15
1
Share

How to Adjust Self-Adjusting Brakes?

On the inner side of the caliper brake pump, you can see a bleeder screw with a cap. Rotate it counterclockwise, and oil will start to leak out. After letting the oil drain for a few seconds, tighten the screw again. Then, repeatedly press the brake pedal in the cabin several times and hold it down. At this point, loosen the bleeder screw again, let the oil drain for a few more seconds, and then tighten it. Repeat this process several times to achieve the desired brake adjustment effect.
11
2
Share

How to Measure the Three Wires of an Automotive Ignition Coil?

Let the starter motor run, and you can use an LED test light to check its signal; the LED test light will blink. You can also use the HZ range of an automotive-specific multimeter to measure its frequency to determine whether the ECU is supplying a signal to the ignition coil.
7
2
Share

How to change the car air conditioner display from 'lo' to temperature?

It indicates maximum cooling; if the system inherently cannot display temperature; then 'LO' signifies the air conditioner is currently in cooling mode rather than heating, with cooling intensity surely adjustable through different gear settings.
5
4
Share

What Causes a Car Air Conditioning Compressor to Lock Up and How to Fix It?

Immediately turn off the power to the compressor clutch and check the system for any leaks. Discharge all the refrigerant from the system, replace the oil relief valve, and clean all valves (POA valve, STV valve, VIR valve, EPR valve).
18
5
Share

Is the Vehicle Management Office Open on Saturdays?

The Vehicle Management Office is open on Saturdays, and basic services such as temporary license plates and license plate replacements can be handled on weekends and holidays, but vehicle registration services are not available. The Vehicle Management Office is primarily responsible for handling vehicle registration, modification, transfer, mortgage, and cancellation, as well as driver's license applications, replacements, renewals, and reviews, along with other related services for vehicles and drivers. When processing vehicle registration, driver examinations, and license issuance, the office must use a workflow record form to document the progress of these procedures. Upon completion of tasks, each department must sign the workflow record form. Supervisory or leadership roles should note clear handling opinions on the form when addressing issues reported by various departments. The workflow record form is then archived in the vehicle and driver records.
2
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.