How many seconds does the Honda XR-V take to accelerate from 0 to 100 km/h?

1 Answers
LeJosiah
07/29/25 7:27pm
According to official data, the Honda XR-V with a 1.5L engine takes 8.1 seconds to accelerate from 0 to 100 km/h. Factors affecting a vehicle's 0-100 km/h acceleration time are as follows: Torque: Torque, in simple terms, represents how much force is available. The greater the torque, the more force is applied to propel the vehicle, naturally resulting in faster acceleration. For comparison, the Beijing Hyundai ix35 in the same class has a maximum torque of 193 Nm and takes 11.20 seconds to reach 100 km/h. The Honda XR-V has torque outputs of 155 Nm and 220 Nm, achieving 0-100 km/h in 8.1 seconds. Transmission efficiency: The transmission acts as the medium for power delivery, inevitably involving power loss. The higher the transmission efficiency, the better the acceleration performance. Generally, transmission efficiency ranks as follows: manual transmission > dry dual-clutch transmission > wet dual-clutch transmission > AT transmission > CVT transmission. The Honda XR-V is equipped with a continuously variable transmission (CVT). Power-to-weight ratio: The relationship between horsepower and vehicle weight is called the power-to-weight ratio (measured in Hp/T). The higher the power-to-weight ratio, the faster the acceleration. For comparison, the Beijing Hyundai ix35 in the same class has a power-to-weight ratio of 114 Hp/T and takes 11.20 seconds to reach 100 km/h. The Honda XR-V has a power-to-weight ratio of 128 Hp/T, achieving 0-100 km/h in 8.1 seconds.
Was this review help?
19
0
Share
More Forum Discussions

Where is the Swift's cabin air filter located?

The cabin air filter of the Swift is located inside the glove compartment on the passenger side, which is where most Japanese cars place their cabin air filters. Steps to replace the cabin air filter: 1. Open the glove compartment on the passenger side. There are clips on both the left and right sides of the compartment. Push both sides inward simultaneously, then pull the glove compartment downward to remove it. 2. After removing the glove compartment, you will see the cabin air filter cover inside. 3. The cover has clips on both sides. Press the clips to open the cover. 4. Once the cover is open, you can see the cabin air filter. Remove the old filter and replace it with a new one. The Swift has a length of 3750mm, width of 1690mm, height of 1510mm, and a wheelbase of 2390mm. The domestic Swift features a stylish and attractive design, complete with comprehensive configurations, and is equipped with a 1.3L engine, making it economical and fuel-efficient.
10
1
Share

Will the battery be damaged if the positive and negative terminals are reversed?

Reversing the positive and negative terminals of the battery will not damage the battery itself, but it can cause damage to the vehicle's electronic components. Here is some related information about reversing the battery terminals: 1. Remedy: Immediately turn off all electrical devices in the car, close them completely, and reconnect the terminals correctly. For cars with computer board control systems, the computer board remains powered on at all times. If the terminals are reversed, these circuits will be the first to burn out. Many other electrical components may also be damaged, and the extent of damage is unpredictable. 2. Inspection: Start with the fuses. After checking the battery voltage, install the battery correctly. Once powered on, observe the car's dashboard and check all electrical appliances. During the inspection, if any components show signs of malfunction, promptly visit a 4S store or repair shop for professional inspection and repair by qualified personnel.
4
3
Share

What Causes the Car Wiper to Not Turn Off?

If the car wiper cannot be turned off, it is likely that the automatic mode is activated, and there is water falling on the windshield, causing the wiper to keep working. If the automatic mode is not activated and the wiper still cannot be turned off, then there is an issue with the wiper switch, and the wiper switch assembly needs to be replaced in such cases. The rubber of the wiper can adhere closely to the windshield, allowing it to remove dirt and water from the windshield during its back-and-forth motion. However, rubber products can age over prolonged use. Aged rubber tends to harden, and hardened rubber cannot maintain close contact with the windshield, leading to ineffective wiping and even causing unusual noises during the wiping process. Wipers need to be replaced periodically, but there is no strict usage period for wipers. They should be replaced as soon as issues like ineffective wiping or unusual noises occur.
9
1
Share

What Causes the Engine Yellow Light to Illuminate After Filling Up a Full Tank of Gas?

After filling up a full tank of gas, the engine yellow light may illuminate due to poor quality of the engine oil. The emission system is highly sensitive to fuel quality, so it is advisable to refuel at reputable large gas stations. Below is detailed information about engine oil: 1. Overview: Engine oil, also known as engine lubricant, is referred to as Engine-oil in English, with a density of approximately 0.91×10³ (kg/m³). It serves to lubricate and reduce friction, assist in cooling, seal against leaks, prevent rust and corrosion, and cushion shocks in the engine. 2. Composition: Engine oil consists of base oil and additives. The base oil is the main component of the lubricant, determining its fundamental properties. Additives are used to compensate for and improve any deficiencies in the base oil's performance, providing certain new characteristics, making them an essential part of the lubricant.
2
5
Share

What is the freezing point of antifreeze that can be used?

Antifreeze with freezing points of -15°C, -25°C, -30°C, and -40°C can be used. When selecting antifreeze, it is generally advisable to choose one with a freezing point at least 10°C lower than the lowest temperature in your region. Can different antifreeze brands be mixed: You must use antifreeze from the same brand. Different brands of antifreeze may have varying production formulas, and mixing them could lead to chemical reactions between additives, rendering them ineffective. How to determine if antifreeze is low: Observe the antifreeze warning light on the dashboard. If it lights up, it may indicate low antifreeze levels, though it could also be due to excessively high engine temperature. Check the antifreeze reservoir. If the fluid level is below the minimum mark (MIN), do not continue driving and promptly add antifreeze. Check the water level scale on the antifreeze bottle. The antifreeze level should normally be between the maximum and minimum marks. If it is below the minimum mark, it indicates a shortage of antifreeze.
2
2
Share

What are the reasons for rapid consumption of car coolant?

There are several main reasons for the rapid consumption of car coolant: 1. Poor design of the cooling system. 2. Leakage. 3. Poor circulation leading to fast consumption. 4. Coolant entering the cylinder and being burned. Below is some relevant information: 1. Coolant, also known as antifreeze, is a liquid composed of antifreeze additives, additives to prevent metal corrosion, and water. It has properties such as antifreeze capability, corrosion resistance, thermal conductivity, and non-deterioration. Currently, antifreeze primarily composed of ethylene glycol, along with anti-corrosion additives and water, is commonly used. 2. The engine cooling system of internal combustion vehicles is a liquid-cooled closed-loop system consisting of cylinders, jackets, and radiators. The working condition of the cooling system directly affects the normal operation of the vehicle and its service life.
6
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.