How many seats does the Leapmotor S01 have?

1 Answers
LeRachel
07/30/25 9:01am
Leapmotor S01 is a 4-seater. In terms of power, the Leapmotor S01 is equipped with its self-developed permanent magnet synchronous motor, with a maximum output power of 170 horsepower and a maximum torque of 250 Nm. The 0 to 100 km/h acceleration time is 6.9 seconds. In terms of range, under comprehensive conditions, it takes 8 hours to charge to 80%. In terms of exterior design, the Leapmotor S01 adopts a Coupe design, with a unique shield-shaped front face decorated with black paint, giving the entire front a very technological appearance. For the interior, the Leapmotor S01 uses a combination of leather and piano black paint, with materials and details that give a sense of luxury and refinement. The integrated seats are sporty enough, and the red and black interior of the high-end models is particularly eye-catching.
Was this review help?
19
4
Share
More Forum Discussions

Where is the handbrake of the Buick business car?

Buick business car handbrake is at the far left underfoot. The functions of the car handbrake are as follows: 1. Prevent sliding on slopes: The handbrake is pulled up when parking to keep the car stationary and prevent sliding on slopes. 2. Achieve drifting effect: When driving, turning and pulling up the handbrake can create a drifting effect. Shift to neutral before pulling the handbrake, otherwise the car will stall. 3. The handbrake can be used as a brake in emergencies: Long-term use of the handbrake will cause plastic deformation of the steel wire. Since this deformation is irreversible, long-term use will reduce effectiveness and increase the handbrake's travel distance.
20
3
Share

How to Skillfully Drive a Manual Transmission Car?

Here are three driving tips for manual transmission vehicles: 1. Press the clutch and release the accelerator. The possible issue is jerking. The reason for jerking is the incorrect sequence of pressing the clutch and releasing the accelerator. 2. When driving in urban areas, keep the engine speed at or below 2000 RPM. 3. If you find the clutch won't engage, shift back to neutral, release the clutch slightly, and then try engaging again. Forcing it too hard can damage the transmission. 4. Master the timing of gear shifting. Shift gears when the engine speed is around 2000 RPM. First press the accelerator and then the clutch, so the clutch won't be forced to disengage, and then shift gears.
10
1
Share

What are the reasons for the Ford Escort's air conditioning not cooling?

Reasons for car air conditioning not cooling: 1. Insufficient or low refrigerant: A common reason for car air conditioning not cooling is insufficient or low refrigerant, likely due to minor leaks. Solution: Observe through the sight glass on the top of the dryer tank. During normal operation, if there are continuous slow bubbles in the sight glass, it indicates insufficient refrigerant. If obvious bubble flipping occurs, it means the refrigerant is severely insufficient. If the refrigerant is insufficient or too low, the solution is to add refrigerant. However, note that if adding from the low-pressure side, do not invert the refrigerant bottle; if adding from the high-pressure side, do not start the engine. 2. Excessive refrigerant: Too much refrigerant can also cause the air conditioning not to cool. The proportion of refrigerant in the air conditioning system is critical. If the proportion is too high, it will affect heat dissipation. Similarly, adding too much cooling oil during maintenance will also reduce the heat dissipation of the system. Solution: Observe through the sight glass on the dryer tank. If no bubbles are seen during operation and none appear after the compressor stops, it indicates excessive refrigerant. If the pressurized cooling oil is excessive, turbid bubbles can be seen in the sight glass during normal operation. If the refrigerant is indeed excessive, slowly release some from the low-pressure side maintenance port. 3. Loose compressor drive belt: Car cooling relies on refrigerant, which is transported by the air conditioning compressor, and the drive belt is a crucial moving part. If the belt is loose, the compressor may slip during operation, reducing transmission efficiency, lowering compressor speed, and decreasing refrigerant delivery, leading to no cooling. Solution: If the compressor drive belt is too loose, tighten it. If it cannot be turned by hand, it is too tight and should be slightly loosened. If tightening is ineffective or the belt is cracked or aged, replace it with a new one. 4. Substandard refrigerant and cooling oil: Excessive impurities in the refrigerant and cooling oil can clog the car air conditioning filter, increasing resistance and reducing refrigerant flow to the expansion valve, leading to insufficient cooling. Solution: Use qualified refrigerant for maintenance, as it plays a key role in car air conditioning. 5. Moisture in the refrigeration system: If moisture enters the car air conditioning refrigeration system, it can cause insufficient or no cooling. Solution: Replace the desiccant or dryer tank in the car air conditioning, and then evacuate the system and refill it with the appropriate amount of new refrigerant.
8
5
Share

Can the scheduled driving test (Subject 3) be canceled?

Subject 3 can be canceled after successful scheduling. To cancel after confirmation, you must do so three working days before the scheduled test date. Bring your original ID card (non-local residents need a residence permit) or have the driving school staff go to the vehicle management office's test service window for cancellation. Here are the relevant details: Methods to cancel a scheduled Subject 3 test: 1. Online cancellation: The driving test center's information platform allows cancellation of Subject 3 tests, with the latest cancellation time being 12:00 PM the day before the scheduled test. 2. In-person cancellation: To cancel a Subject 3 test, you must personally bring your ID card and a copy to the vehicle management office. Write "I voluntarily cancel the Subject 3 test scheduled for [date] at [driving school]" on the copy, along with your name, contact information, and date. 3. Proxy cancellation: If you cannot come in person, the proxy must bring their own ID card and copy, along with the canceler's ID card and copy, and write the above statement, including the proxy's name.
13
2
Share

How to test if your ETC is working?

When the ETC staff installs it, they will activate the ETC. In fact, the activation process is also a test for signal availability. If it can be activated correctly, it indicates that the signal is normal and the vehicle can pass through the ETC lane smoothly. Here is some information about ETC: 1. ETC Non-stop Toll System: It is currently the most advanced road and bridge toll collection method in the world. Through dedicated short-range microwave communication between the onboard electronic tag installed on the vehicle's windshield and the microwave antenna in the ETC lane at the toll station, the system can identify the vehicle, write information (entry), and automatically deduct the corresponding funds from the pre-bound IC card or bank account (exit) when the vehicle passes through the toll station. This is an electronic toll collection system for roads, bridges, and tunnels that is being actively developed and promoted internationally. 2. Advantages of the ETC Toll System: This system takes less than two seconds to collect tolls per vehicle, and its toll lane capacity is 5 to 10 times that of manual toll lanes. It is one of the service functions of the intelligent transportation system, allowing passing vehicles to achieve automatic toll collection without stopping at the crossing.
13
0
Share

Do You Need to Pay Purchase Tax When Buying a New Energy Vehicle?

Buying a new energy vehicle does not require paying purchase tax, provided the following conditions are met: 1. The vehicle must be a pure electric vehicle, plug-in hybrid vehicle, or fuel cell vehicle that is licensed for sale in China. The power battery used must not include lead-acid batteries; 2. For plug-in hybrid commercial vehicles, the comprehensive fuel consumption (excluding fuel consumption converted from electricity) must be less than 60% of the corresponding limit in the current national standard for conventional fuel consumption; 3. For plug-in hybrid passenger vehicles, the comprehensive fuel consumption (excluding fuel consumption converted from electricity) must be less than 60% of the corresponding target value in the current national standard for conventional fuel consumption.
16
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.