How many points will be deducted for turning into the wrong-way lane?

2 Answers
DeRichard
07/29/25 7:38am
Turning into the wrong-way lane by accident is a traffic violation and will result in a deduction of 3 points. Traffic behavior is no small matter, especially when driving, as it is closely related to the life and property of oneself and others. There is no excuse for carelessness; one should always be cautious and abide by traffic laws. More relevant information is as follows: Right-side driving: Motor vehicles and non-motor vehicles should drive on the right side. Driving on the left side of the road is considered wrong-way driving. Based on the description, turning into the wrong-way lane during a turn is considered wrong-way driving. Situations that result in a 3-point deduction: Driving a passenger vehicle (excluding buses) or school bus with more passengers than the approved number, but less than 20% over the limit.
Was this review help?
18
5
Share
VanLeila
08/12/25 10:54am
That day I was driving in the city, took a sharp turn without noticing the roadside signs, and accidentally ended up in the wrong lane—my heart sank. This kind of violation would cost me 3 points, as according to traffic regulations, driving against traffic is one of the most common offenses. I later checked the information and found that besides the points, there’s often a fine of 200 yuan. What worried me most was the safety risk—driving the wrong way increases the chance of a head-on collision, especially at night when visibility is poor. Before making a turn, it’s crucial to slow down, observe carefully, check the road signs and arrows, and avoid impulsive driving. If caught by a camera, you’d get a ticket in no time, and it could also mess with your insurance premiums. Remember, don’t follow my careless example—safety comes first, above all else.
Was this review help?
17
2
Share
Expand All
More Forum Discussions

Is it a violation to drive over the left-turn guide dotted line?

Crossing the dotted guide line at an intersection will not result in penalty points. The intersection guide line does not have an arrow, and there is no stop line ahead, which is somewhat different from the left-turn waiting area. The intersection guide line assists vehicles in driving and turning, existing in the form of white dotted lines. The following is an introduction to guide lines: 1. Introduction one: The guide lane line is a lane marking that indicates direction, used to instruct vehicles to drive in the indicated direction at the entrance of an intersection. 2. Introduction two: The variable guide lane means that after entering the lane, there is more than one lane direction, such as some intersections allowing right turns and going straight, where right turns and going straight are combined into one lane, or U-turns and left turns are combined into one lane, generally used for the left lane. 3. Introduction three: The variable guide lane has flexibility, unlike ordinary lane indication lines, where once you enter the lane, going straight means going straight, and turning left means turning left.
2
2
Share

Where is the ignition keyhole of the Roewe RX5?

The key ignition socket of the Roewe RX5 is located below the steering wheel. The following are the reasons and solutions for the one-button start not working: 1. Steering wheel lock: When the car is turned off, turning the steering wheel from the straight position to a certain angle in one direction will lock the steering wheel. Solution: Turn the steering wheel left and right while pressing the engine start button to release the tension and unlock the steering wheel. 2. Gear not in P position: For automatic transmission vehicles, the manufacturer will specify this in the manual. Solution: Ensure the gear is in the P position when starting. 3. Smart key battery dead: When the smart key battery is dead, the key's transmission power is very low, making it difficult for the car's sensor to detect it, and the one-button start cannot complete ignition. Solution: Generally, smart keys come with a mechanical key that can be directly inserted into the keyhole for starting. 4. New car not stepping on the brake before one-button start: Solution: Step on the brake first, then use the one-button start.
9
2
Share

What could be the issue when an automatic transmission cannot engage a gear?

It could be a malfunction inside the gear shift lever assembly, or the P-gear lock solenoid valve inside the gear shift lever may have failed. A damaged brake light switch can also prevent the gear from moving. Related explanations are as follows: 1. During the use of the car's gear shift lever, shifting gears requires looking down at the transmission lever. Driving in low gear for extended periods is not recommended, as high gear is more fuel-efficient than low gear. Therefore, it is advisable to shift up promptly after starting. If the clutch pedal is not fully depressed when shifting gears, it may cause gear damage. Additionally, when the clutch is not in use, the foot should not rest on the clutch pedal, as this can lead to excessive wear of the release bearing. 2. If a gear fails to engage at first, avoid forcing it. When the gear shift lever is in neutral, it should not be shaken back and forth, as this can cause unnecessary wear on components and affect the timing of gear shifts. Skipping gears when upshifting is not recommended; upshifting should be done step by step to prevent a loss of power continuity in the car. Downshifting, however, can skip gears. Avoid engaging reverse gear before the vehicle comes to a complete stop, as this can easily cause gear damage.
19
3
Share

Why won't my Chevrolet Cruze start?

The reasons why a Chevrolet Cruze won't start are as follows: 1. Check if the Chevrolet Cruze's battery has power. It may be due to a drained battery from leaving headlights on for too long or the battery's lifespan expiring. It is generally recommended to replace the battery every 2 years. Additionally, installing xenon headlights, high-power audio systems, or DVD players can also cause vehicle circuit failures. Checking for a dead battery is simple—just press the horn to see if it sounds. 2. Check if there is fuel. If the fuel gauge shows below the red line, the car naturally won't start. Also, pay attention to the quality of the fuel. It is advised to refuel only at reputable gas stations. When traveling, you can use a gauze wrap over the fuel nozzle to filter out impurities. 3. The Chevrolet Cruze may lack antifreeze. Some owners use water or low-quality antifreeze, which can cause the entire cooling system to freeze in extremely cold winter conditions, leading to a cracked engine and preventing the water pump from functioning. This not only makes the car unable to start but also damages other engine components. 4. The Chevrolet Cruze may be in the wrong gear. When starting the Chevrolet Cruze, the gear must be in P (Park) or N (Neutral). If it is in R (Reverse) or D (Drive), the car won't start.
10
5
Share

What to Do When the Mechanical Lock Can't Open the Car Door?

Reasons and solutions for the mechanical lock not opening the car door are as follows: 1. The car's central locking system is in an electronically locked state. You need to wait for one to two hours for the lock to be released before attempting to unlock it again. 2. If the door lock cylinder is stuck due to prolonged disuse and cannot be turned, in an emergency, you may resort to forceful methods like breaking the window to open the door. 3. You can contact a 4S shop for repairs. Detailed information about the mechanical lock not opening the car door is as follows: 1. If the mechanical key cannot turn to open the door, it may be due to incorrect operation, a faulty lock cylinder, or a problem with the mechanical key. The reason could be rust inside the lock cylinder. You can try injecting some engine oil into the lock cylinder to lubricate it, then attempt to open it. If this fails, the only solution is to replace the lock cylinder. 2. If the car's door lock or internal mechanical device is damaged, there will be no resistance when using the mechanical key to open the door. This indicates internal disengagement, rendering the mechanical key useless. Some car models enter an anti-theft locked state after locking, not only locking the engine but also the central control system, making the mechanical key ineffective. 3. The car's central locking door structure uses a mechanical latch to secure the door. If the door is not locked, you can simply use the external door handle to open it. Conversely, if the car has an internal unlock button, you need to enter the car and start the vehicle to unlock it. In such configurations, if the door cannot be opened, you may have to break the car window to enter, resulting in significant damage. This method is not recommended.
10
2
Share

What does the yellow exclamation mark on the Accord dashboard mean?

When a yellow exclamation mark appears on the car dashboard, there are 4 possible situations: general malfunction, automatic transmission failure, abnormal tire pressure, and lighting failure. Below is a detailed analysis of these 4 situations: General malfunction: A triangle with an exclamation mark inside indicates that the car's general performance or components and functions have malfunctioned. This mainly includes parking sensor failure, fuel cut-off system intervention or malfunction, external light failure, engine oil pressure sensor failure, etc. It is necessary to go to a 4S shop for inspection to identify the source of the malfunction. Automatic transmission failure: A yellow gear with an exclamation mark inside is the automatic transmission failure warning light, indicating that there is a problem with the transmission or the transmission lubricant is below the normal range. The transmission oil needs to be replaced promptly. Abnormal tire pressure: A horizontal line under a bracket with an exclamation mark in the middle represents the tire pressure monitoring warning light. When the car's tire pressure is too low, this warning light will illuminate. It is necessary to check the car's tire pressure and restore it to the normal range. Lighting failure: A yellow bulb with an exclamation mark is the lighting failure indicator, indicating that a car light has malfunctioned. Solution: Go to a 4S shop for inspection and treatment as soon as possible, or you can check it yourself, focusing on commonly used bulbs such as turn signals, fog lights, and interior lighting, to see where the problem lies. There is also a red exclamation mark inside a circle with a bracket, which represents a warning for the braking system, mainly indicating a malfunction in the braking system or low brake fluid level. The braking system needs to be inspected immediately to avoid accidents.
2
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.