How many points will be deducted for speeding between 10% and 20%?

1 Answers
MacJustin
07/25/25 2:49am
For motor vehicles exceeding the speed limit by more than 10% but less than 20%, different penalties are imposed depending on the circumstances: 1. On roads with a speed limit below 50 km/h, exceeding the speed limit by more than 10% but less than 20% results in a fine and 3 penalty points; 2. On roads with a speed limit between 50 km/h and 80 km/h, exceeding the speed limit by more than 10% but less than 20% results in a fine and 3 penalty points; 3. On roads with a speed limit between 80 km/h and 100 km/h, exceeding the speed limit by more than 10% but less than 20% results in a fine and 3 penalty points; 4. On roads with a speed limit above 100 km/h, exceeding the speed limit by more than 10% but less than 50% results in a fine and 3 penalty points.
Was this review help?
2
5
Share
More Forum Discussions

What are the techniques for opening the fuel tank cap of a large truck?

The fuel tank cap of a large truck requires a key to open. Insert the key and turn it counterclockwise once, then grasp the fuel tank cap and turn it counterclockwise to open it. The direction for opening the fuel tank cap varies among different vehicles. Sometimes when refueling, you might forget whether the fuel tank cap is on the left or right side of the vehicle. Determining the location of the fuel filler is not difficult. Most new vehicles have an arrow indicator on the fuel gauge of the dashboard. The side the arrow points to is where the fuel filler is located. Below is an introduction to gasoline compression ratios: 1. 90-octane gasoline: Suitable for gasoline vehicles with an engine compression ratio below 8.5. 2. 92-octane gasoline: Suitable for gasoline vehicles with an engine compression ratio between 8.6 and 9.9. 3. 95-octane gasoline: Suitable for gasoline vehicles with an engine compression ratio between 10.0 and 11.5. 4. 98-octane gasoline: Suitable for gasoline vehicles with an engine compression ratio above 11.6.
11
3
Share

What does twin-turbo mean?

Twin-turbocharging is one of the turbocharging methods. To address the turbo lag phenomenon in exhaust gas turbocharging, two turbochargers are used in series (one large and one small) or in parallel (two identical ones). At low engine speeds, a smaller amount of exhaust gas can drive the turbocharger to rotate at high speed, generating sufficient intake pressure and reducing the turbo lag effect. Here is an introduction to twin-turbocharging: 1. When the engine operates with the combined effect of two turbochargers, the intake efficiency is significantly improved, the boosting effect becomes more pronounced, and the power performance is greatly enhanced. 2. At low engine speeds, only a low-speed turbocharger is working. At this time, a smaller amount of exhaust gas can drive this turbocharger to rotate at high speed to generate sufficient intake pressure. When the engine speed increases, the high-speed turbocharger continues to work, entering a high-boost state and providing a consistent and powerful performance.
6
3
Share

How to reset the maintenance light on Chery Ant?

Maintenance light reset method requires using the universal specialized diagnostic tool Tech2. 1. Purpose of maintenance light: The maintenance light functions like a counter, similar to a stopwatch in a race. Of course, the maintenance reminder system monitors multiple aspects, operating in both time-based and mileage-based modes. It constantly calculates the maintenance interval based on factors like oil cleanliness, viscosity, water content, and impurity levels. After each maintenance service, previous records must be cleared and reset to enable new calculations. 2. Routine vehicle maintenance: Neglecting routine maintenance can not only cause unnecessary damage to the vehicle but also jeopardize driving safety. For example, insufficient lubrication may lead to cylinder scoring and bearing failure, while malfunctioning vehicle components may cause traffic accidents. Conversely, careful attention to routine maintenance can keep the vehicle in like-new condition while allowing monitoring of all components' technical status, preventing both mechanical failures and traffic accidents.
14
0
Share

How to Maintain a Car in Winter?

Here are the methods for winter car maintenance: 1. Wiper Blades and Windshield: Due to weather conditions, wiper blades often stick to the windshield in winter. Do not force them off. Instead, turn on the car's air conditioning, set it to blow air towards the windshield to raise its temperature. This also helps check if the heating system is functioning properly. Regularly clean the heating system to ensure good air quality inside the car. 2. Body and Chassis: The car's exterior inevitably gets damaged while driving, and even when parked. In winter, with rain and snow, the car's exterior is prone to corrosion. Roads are often salted to quickly melt snow, and the tires can splash salt-laden snow water onto the chassis, causing rust. Therefore, before winter arrives, thoroughly inspect the car's body, repair any scratches promptly, and apply wax in early winter to protect the paint. Waxed surfaces are less prone to moisture, and ice formation on the body is significantly reduced. Also, perform anti-rust maintenance on the vehicle's chassis to extend its lifespan.
8
0
Share

How to Remove the Spark Plugs on a Haval M6?

Steps for replacing the spark plugs on a Haval M6: Open the engine hood, lift off the plastic engine cover, and remove the high-voltage distributor wires. Mark each cylinder's position to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. While removing them, check for any external debris like leaves or dust and ensure everything is cleaned thoroughly. Place the new spark plug into the spark plug hole, hand-tighten it a few turns, and then use the socket to tighten it further. Reinstall the high-voltage distributor wires in the correct firing order, then snap the cover back into place. If a spark plug is damaged, it can directly cause issues such as electrical leakage in the ignition system, increased fuel consumption, reduced power, and most notably, difficulty starting the engine, affecting the vehicle's normal operation. Severe spark plug erosion—indicated by pitting, damage, or melted electrodes—means the spark plug is worn out and should be replaced.
3
4
Share

What is the fuel consumption of the Benelli 752s?

The fuel consumption of the Benelli 752s is approximately 5 liters per 100 kilometers. Here is an extended introduction: 1. Factors affecting fuel consumption: There are many objective factors that can influence fuel consumption. For example, individual driving habits, usual road conditions, vehicle load, etc., can all significantly impact a car's fuel consumption. 2. Power: It is equipped with a twin-cylinder water-cooled electronic fuel injection engine, with a compression ratio of 11.5:1 and an actual displacement of 745cc. It is matched with a slipper clutch, with a maximum power of 56KW (76Ps)/8000rpm and a top speed of 200km/h. 3. Tires: The front tire model is 120/70-17, and the rear tire is 180/55-17. 4. Body dimensions: The wheelbase is 1460mm, the fuel tank capacity is 14.5L, the minimum ground clearance is 180mm, and the curb weight is 228kg.
19
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.