How many points deducted from the driver's license require retaking the test?

1 Answers
StGabrielle
07/29/25 11:11pm
If the points deducted exceed 12 but are less than 24, you must attend the subject one training and test. However, if the penalty points reach 24 or more within one scoring cycle, in addition to the subject one test training, you must also retake the subject three test. Below is the relevant introduction: 1. Road driving skills test content: preparation for getting on the car, simulated lighting test, starting, driving straight, shifting gears, changing lanes, parking by the roadside, going straight through intersections, turning at intersections, meeting cars, overtaking, turning around, night driving, etc. Different types of driving licenses have different test contents. 2. Safe and civilized driving common sense test content: safe and civilized driving operation requirements, safe driving knowledge under bad weather and complex road conditions, and disposal knowledge after traffic accidents, etc.
Was this review help?
4
0
Share
More Forum Discussions

What Causes Bearing Seizure and Crankshaft Locking?

Bearing seizure and crankshaft locking occur due to: 1. Poor quality of crankshaft and bearings with inadequate surface finish on journal and bearing surfaces: During cold starts under heavy load, the engine oil's high viscosity at low temperatures prevents sufficient lubrication, causing metal fusion and seizure. 2. Improperly rebuilt engines: Incorrect installation of main or connecting rod bearings may lead to improper clearance adjustment, resulting in bearing seizure. Additional information about bearing seizure: 1. Overview: Bearing seizure represents one of the most severe engine failures. 2. Mechanism: This phenomenon occurs when severe wear develops between the crankshaft and main/connecting rod bearings due to absent oil film protection, causing extreme surface temperatures that lead to mutual sintering and locking between crankshaft journals and bearings, rendering the engine inoperable.
2
4
Share

What are the reasons for the inability to turn off the engine with one-button start?

There are several reasons why the engine cannot be turned off with one-button start: 1. Different models, different operations: The operation varies among different car models. Some models require a long press to turn off the engine, while others need to be pressed twice—once to turn off the engine and again to cut off the power to the entire vehicle. Some models only require a single press to turn off the engine. 2. Key not detected: Sometimes, strong nearby magnetic fields can cause interference, preventing the key from being detected. Solution: Align the key with the one-button start. 3. Battery issues: The engine may also fail to turn off if the battery is dead or its voltage is below 12V. In such cases, a long press can turn off the engine.
2
0
Share

How often should the transmission fluid be changed for a Camry?

Camry requires transmission fluid changes every two years or 40,000 kilometers. Transmission fluid has cleaning properties, resists low temperatures, and provides highly effective lubrication even in cold conditions, helping to lubricate and prolong the lifespan of the transmission components. The Camry's body dimensions are: length 4900mm, width 1840mm, height 1455mm, with a wheelbase of 2825mm and a fuel tank capacity of 60 liters. The Camry is equipped with a 2.0L naturally aspirated engine, delivering a maximum power of 131kW and a maximum torque of 210Nm, paired with a CVT continuously variable transmission. It features a front suspension type of MacPherson independent suspension and a rear suspension type of E-type multi-link independent suspension.
7
1
Share

Does the X-Trail have a break-in period?

The X-Trail does have a break-in period. The break-in period refers to the initial driving distance after the vehicle leaves the factory, during which the engine components wear in smoothly. The break-in mileage ranges from 1,000 to 3,000 kilometers, with the first maintenance typically around 5,000 kilometers. The X-Trail's body dimensions are: length 4,675mm, width 1,820mm, height 1,722mm, wheelbase 2,706mm, and minimum ground clearance 208mm. The X-Trail is equipped with a 2.0L naturally aspirated engine, delivering a maximum power of 111kW and a maximum torque of 194Nm, paired with a CVT continuously variable transmission.
10
1
Share

What Causes the Abnormal Noise When Accelerating Uphill?

Abnormal noise when accelerating uphill can be caused by the following reasons: 1. The noise only occurs at idle or low speed: Possible causes include: Excessive clearance between the piston and cylinder wall; Over-tight piston pin or connecting rod bearing assembly; Excessive clearance between the tappet and its guide hole; Wear of the camshaft profile; Loose starter causing pulley noise (more noticeable during speed changes). 2. The noise becomes chaotic at a certain speed, and short sounds are heard during rapid deceleration: Possible causes include: Cracked camshaft timing gear or loose fixing nut; Broken crankshaft; Loose piston pin bushing; Excessive axial clearance of the camshaft or loose bushing.
1
5
Share

How to turn off the rear wiper of GAC Trumpchi GS4?

The method to turn off the rear wiper of GAC Trumpchi GS4 is: locate the rear wiper switch and lift the wiper lever upward to turn it off. Taking the 2021 GAC Trumpchi GS4 as an example, its body dimensions are: length 4545mm, width 1856mm, height 1668mm, wheelbase 2680mm, minimum ground clearance 190mm, and fuel tank capacity 55l. The 2021 GAC Trumpchi GS4 is equipped with a 1.5T turbocharged engine, with a maximum power of 124kW and a maximum torque of 265Nm, matched with a 6-speed manual transmission. It adopts a front suspension type of MacPherson independent suspension and a rear suspension type of multi-link independent suspension.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.