How many points are deducted for stopping midway during curve driving?

2 Answers
DiPeter
07/24/25 4:24pm
If any wheel presses against the road edge line, 100 points will be deducted (previously, squeezing the edge line would deduct 20 points, and crossing the line would deduct 100 points. The new standard has increased the penalty for squeezing the edge line to 100 points). Stopping midway will also deduct 100 points. Guidelines for curve driving: when turning left, stay to the right; when turning right, stay to the left. The steering angle should generally be controlled around 90 degrees, avoiding large adjustments. Maintain a steady speed throughout, not too fast, and do not stop midway. The vehicle body can brush the line but must not press it. The entire process should be completed in 1st gear at a steady speed. Below are some parking precautions: 1. When waiting at a red light, shift to N gear, not D gear while pressing the brake: Many people keep the gear in D and press the brake for convenience while waiting at a red light or in traffic. This is incorrect as it increases fuel consumption and, more importantly, if a rear-end collision occurs, the car may lurch forward, potentially damaging the transmission if the gear is in D. Therefore, if the wait is long, shift to N gear and engage the handbrake, which saves fuel and allows your foot to rest. 2. When accelerating to overtake, do not keep pressing the accelerator: Continuously pressing the accelerator will delay gear downshifting. The correct approach is to press the accelerator to raise the RPM to between 2000 and 2500, then briefly release it, which will prompt the gear to downshift. If the car has an S gear, it's even simpler—just shift to S gear when overtaking, as the transmission will respond more sensitively, providing faster acceleration.
Was this review help?
16
0
Share
McAndres
08/11/25 9:04am
To be honest, I've checked the traffic regulations about how many points are deducted for stopping midway on a curve. Generally, it's 3 points. Because visibility is poor on curves, stopping can easily cause rear-end collisions or rollover accidents. Under centrifugal force, the vehicle is hard to control, posing significant risks to both yourself and vehicles behind. Once when I was driving, I accidentally stopped on a mountain curve and was penalized 3 points plus a 200-yuan fine. Luckily, nothing serious happened. Now whenever I approach a curve, I slow down in advance to find a safe area to stop. Never make an abrupt stop on a curved section—safety comes first, far more important than points. Developing good driving habits helps avoid unnecessary trouble.
Was this review help?
6
3
Share
Expand All
More Forum Discussions

How to Perform Transmission Memory Reset on the Passat?

With the ignition on, press the accelerator pedal all the way down, lightly tap the start switch to turn off the power, and do not release the accelerator. After power is off, release the accelerator and wait for a few minutes. The transmission will automatically complete the reset. Detailed steps for transmission memory reset: When the engine is cold, lightly tap the start switch to turn on the ignition. With the ignition on, press the accelerator pedal all the way down and hold for 5-10 seconds. Lightly tap the start switch to turn off the power, and do not release the accelerator during the power-off process. After power is off, release the accelerator and wait for a few minutes. The transmission will automatically complete the reset. About the Passat: The Passat (PASSAT) is a mid-size sedan designed by Volkswagen AG of Germany. It is classified as a B-segment car in Volkswagen's lineup. Since its debut in 1973, the Volkswagen Passat has swept the global automobile market with its high safety standards, classic design, and top-tier manufacturing quality over the past 40-plus years, with more than 20 million units produced and sold.
13
4
Share

What type of gasoline should be used for the Mercedes-Benz GLC?

The Mercedes-Benz GLC requires a minimum of 95-octane gasoline, as recommended in the user manual. Of course, using 98-octane gasoline is also acceptable. Generally, it is not advisable to use gasoline with a lower octane rating than what the manufacturer specifies or recommends. Long-term use of incorrect gasoline octane ratings can have the following effects: Using a higher octane gasoline in a vehicle designed for lower octane will not cause damage, but the increase in octane can alter the fuel's ignition point, leading to delayed combustion in the engine. This results in reduced engine power output and thermal efficiency, with the practical effect being poorer performance. Using lower octane gasoline in a vehicle designed for higher octane can cause engine knocking. This occurs because the significantly lower octane rating reduces the fuel's ignition point, causing premature ignition during the compression stroke. If combustion occurs before the spark plug fires, resistance is created during the upward stroke. This resistance makes the engine run very unevenly. If the knocking is mild, it may only increase noise without significant engine damage. However, noticeable knocking indicates severe engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring.
18
0
Share

Where is the key sensing area of Qoros car?

The key sensing area of Qoros car is located inside the glove box on the passenger side. The car remote key operates using coil induction technology. During the unlocking process, the vehicle's radio frequency transceiver verifies whether the key matches to determine if the engine can be safely started. Taking the 2021 Qoros 3 3S Sedan 1.5T CVT Leading model as an example, in terms of power, it is equipped with a 1.5-liter turbocharged engine, with a maximum power of 115 kW and a maximum torque of 230 Nm. Its dimensions are 4627 mm in length, 1839 mm in width, and 1445 mm in height, with a wheelbase of 2702 mm, a curb weight of 1425 kg, and the body structure is a 4-door 5-seater sedan.
12
5
Share

How to Use P, R, N, D, and S Gears?

The usage of P, R, N, D, and S gears is as follows: P gear is used when parking and turning off the engine; N gear is used for short stops without turning off the engine; D gear is used for driving forward; R gear is used for reversing; S gear is used for aggressive driving or overtaking. P stands for Park, R for Reverse, N for Neutral, D for Drive, and S for Sport mode. An automatic transmission car does not require the driver to manually shift gears; the vehicle automatically selects the appropriate gear based on driving speed and traffic conditions. The correct method to start an automatic transmission car is: 1. Connect the power and then start the car; 2. After ignition, press the brake, shift to D gear, release the handbrake, and gently press the accelerator to start; 3. After starting, accelerate appropriately according to road conditions.
7
2
Share

What is the fuel consumption of the Civic?

The 2021 Civic HATCHBACK 220TURBO manual transmission model, for example, has a fuel consumption of 6.4 liters per 100 kilometers. It is a compact 5-door, 5-seat hatchback equipped with a 6-speed manual transmission and a top speed of 210 kilometers per hour. The dimensions of this car are 4517mm in length, 1799mm in width, and 1434mm in height, with a wheelbase of 2700mm. It features a 5-door, 5-seat hatchback body structure, a top speed of 210 kilometers per hour, a maximum engine torque of 226 Newton-meters, and a maximum torque speed range of 1800 to 5500 revolutions per minute.
1
3
Share

Is the Engine Ticking Sound Indicative of Cylinder Scoring?

Engine ticking is not necessarily indicative of cylinder scoring. The causes of engine ticking can include aging or loosening of engine mounts, excessively rich air-fuel mixture, or malfunction of the high-pressure fuel pump. For engines with high mileage, excessive clearance between the camshaft and hydraulic lifters can also produce such sounds. An engine is a machine capable of converting other forms of energy into mechanical energy. It can refer to either a power generation device or the entire machine including the power unit. Types of engines include internal combustion engines, external combustion engines, gas turbines, and electric motors. The basic structure of an automotive engine consists of components such as the water pump housing, connecting flange or pulley, water pump shaft and bearings or integrated bearing units, water pump impeller, and sealing devices, making it a fundamental part of the automobile.
20
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.