How many points are deducted for forgetting to use the turn signal in Subject 2?

1 Answers
StAllie
07/29/25 4:12am
Failure to use the turn signal or incorrect use of the turn signal will result in a deduction of 10 points each time. The specific regulations are as follows: Not using or incorrectly using the turn signal before starting, turning, changing lanes, overtaking, or parking will result in a deduction of 10 points. Turning the steering wheel within less than 3 seconds after turning on the turn signal before starting, turning, changing lanes, overtaking, or parking will result in a deduction of 10 points. There are 6 instances in Subject 2 where the turn signal must be used, which are: Turn on the left turn signal when starting the vehicle; Turn on the left turn signal when starting on the slope; Turn on the right turn signal when the vehicle passes the side parking spot and prepares to park alongside, stopping 30 cm from the edge before reversing; Turn on the left turn signal before shifting into reverse gear during side parking, as the steering wheel will be turned fully to the right during reversing, causing the front of the vehicle to shift left; Shift into drive gear and turn on the left turn signal before exiting the side parking spot, and turn it off promptly after exiting; Turn on the left turn signal when entering the right-angle turn area, and turn it off promptly after completing the turn. The full score for Subject 2 is 100 points, with evaluation criteria set for failing, deducting 20 points, deducting 10 points, and deducting 5 points. The test is considered passed if the following conditions are met: ① For applicants of large passenger vehicles, trailers, city buses, medium-sized passenger vehicles, and large trucks, a score of 90 or above is required; ② For other vehicle types, a score of 80 or above is required. The test items for small vehicles C1 and C2 include reversing into a parking space, side parking, slope parking and starting (canceled for C2), right-angle turns, and curve driving (commonly known as S-curves) as the five mandatory items (some regions also include a sixth item, high-speed card collection). The test items for large vehicles A1, A2, A3, B1, and B2 include stake test, slope parking and starting, side parking, single-plank bridge, curve driving, right-angle turns, passing through a limited-width gate, passing through continuous obstacles, driving on bumpy roads, narrow road U-turns, as well as simulated highway driving, continuous sharp mountain curves, tunnels, rain (fog) conditions, slippery roads, and emergency handling.
Was this review help?
7
3
Share
More Forum Discussions

How to reset the maintenance light on the JAC Refine S3?

The method to reset the maintenance light on the JAC Refine S3 is: 1. Press the reset button and turn off the ignition switch; 2. Hold the reset button until the mileage is no longer displayed; 3. Hold the reset button and restart the ignition to reset. The purpose of the maintenance light is: 1. To record the mileage of important components; 2. To remind the owner to perform maintenance. The JAC Refine S3 is a compact SUV with body dimensions of: length 4345mm, width 1765mm, height 1640mm, wheelbase 2560mm, and a fuel tank capacity of 45 liters. It is equipped with a 1.5L naturally aspirated engine, delivering a maximum power of 85kW at 6000 rpm.
12
2
Share

What is the reason why the engine fault light sometimes turns on and sometimes off?

The reason why the engine fault light sometimes turns on and sometimes off is: there is a fault in the engine. When it does not affect normal driving, the engine fault light will turn off, and when there is a fault, it will light up yellow or red. The methods to eliminate the engine fault light are: 1. Disconnect the negative terminal of the engine battery, wait for 30 seconds, and then reconnect it to eliminate the fault; 2. Go to a 4S shop for detection and elimination. The methods to maintain the engine are: 1. Use high-quality engine oil; 2. Use qualified coolant; 3. Regularly clean the water tank scale; 4. Regularly remove carbon deposits from the car; 5. Replace the car's three filters on time; 6. Maintain a reasonable engine speed.
14
2
Share

What is the rhyme for adjusting the car body when reversing?

There are principles for reversing into a garage; the car body should be straight and aligned front and back. There are tricks for reversing into a garage to the right; turning early is better than turning late. Below is an introduction to reversing: 1. Precautions: Whether you are a novice or an experienced driver, this is a must-notice point. Not only should you not press the accelerator when reversing, but you should also not half-press the brake. Especially for novices, the speed should be slower than idle speed when reversing. This allows more time to observe the surroundings. 2. Basic essentials: When parking in a parking lot, first, estimate the width of the parking space, check for any obstacles behind, whether there are cars parked on both sides, and whether the length fits your car model. If visibility is poor at night, step out to observe the exact position before reversing.
9
3
Share

How to Clear the Yellow Engine Light?

Methods to clear the yellow engine light: 1. The owner can try starting and turning off the vehicle three times in a row; 2. Turn off the engine, disconnect the negative terminal of the battery, wait for 30 seconds, reconnect it, and then try to start the engine; 3. After completing the above steps, check if the engine warning light on the dashboard is still on. Note: When the engine warning light on the dashboard is illuminated, it cannot be manually cleared. Typically, the issue needs to be diagnosed and resolved at a 4S shop using a fault detection tool before the light can be turned off. Below are the common reasons for the yellow engine light on the dashboard: 1. Sensor issues; 2. Maintenance problems; 3. Fuel quality issues; 4. Poor combustion of the air-fuel mixture; 5. Air intake problems.
16
4
Share

Is it possible to buy a used car with a title but without transferring ownership?

Used cars with titles but without ownership transfer can be purchased under certain conditions. Here is an introduction to used cars: 1. Definition: Refers to vehicles that have not yet reached the national scrapping standard, have been registered with the public traffic management authorities, and can be traded with ownership transfer. 2. Content: Includes three-wheeled motor vehicles, low-speed trucks (originally agricultural vehicles), trailers, and motorcycles. 3. Significance: The definition of used cars directly relates to the scope of vehicles involved and, to some extent, affects the scientific nature of the used car evaluation system and the standardization of market transactions, making it necessary to provide a clear definition.
14
4
Share

Where to Check the Vehicle Identification Number in a Car?

In a car, the locations to check the Vehicle Identification Number (VIN) are: 1. The lower right corner of the front windshield; 2. On the door hinge pillar or door lock pillar; 3. In the engine compartment; 4. On the left side of the dashboard; 5. In the frame number column on the vehicle registration certificate. The VIN digits represent: 1. The 1st digit indicates the country or region of production; 2. The 2nd digit represents the car manufacturer's code; 3. The 3rd digit denotes the vehicle type code; 4. Digits 4 to 8 represent vehicle characteristics; 5. The 9th digit is a check digit; 6. The 10th digit indicates the model year; 7. The 11th digit represents the assembly plant; 8. Digits 12 to 17 denote the production serial number.
2
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.