How Many Points Are Deducted for Driving Without Wearing Clothes?

What is the method for testing battery voltage?

Testing battery voltage can be done by: 1. Using a voltage tester or multimeter; 2. Using a car charger adapter with a display showing voltage values. Battery maintenance methods include: 1. Regularly cleaning the battery; 2. Avoiding the use of electrical devices when the engine is off; 3. Periodic battery replacement; 4. Regularly starting the car. The functions of a car battery are: 1. Providing power to the starting system, ignition system, and electronic fuel injection system when starting the engine; 2. Supplying power to car electrical devices when the engine is off or at low idle; 3. Assisting in power supply when electrical demand exceeds the generator's capacity; 4. Stabilizing voltage to protect electronic equipment in the car.

14

2

Share

How Often Must a Motor Vehicle Be Driven?

Motor vehicles should be driven at least once every two weeks to provide some maintenance benefits and effectively check the condition of various components. Precautions for long-term vehicle storage include: 1. Park the vehicle on a flat surface to prevent tire compression and wear, or improper functioning of fluids due to imbalance; 2. After starting the car, warm it up for about 10 minutes to allow full lubrication of engine components for proper operation. Maintenance methods for long-term vehicle storage are: 1. If the car is not driven for an extended period, start it every one or two weeks to prevent engine issues; 2. Before long-term storage, clean the exterior and interior thoroughly, as dirt left on the paint for too long can damage it; 3. Keep the battery fully charged and perform regular checks and maintenance to prevent battery discharge.

6

0

Share

How to Determine if a Compressor Starter is Good or Bad?

To determine if a compressor starter is good or bad, follow these methods: 1. Use the resistance setting (R1 ohm range) on a multimeter to measure the resistance between the M and S terminals. The reading should be between ten to twenty ohms. If the resistance is infinite, it indicates the starter is damaged. 2. With the multimeter still set to the R1 ohm range, place the starter vertically with the coil at the bottom. Insert the red and black probes into the M and S terminals. The circuit should show an open state; otherwise, it indicates the starter is damaged. The working principle of a compressor involves drawing refrigerant from the low-pressure area, compressing it, and sending it to the high-pressure area for cooling and condensation. The heat is dissipated into the air through the radiator fins, and the refrigerant changes from a gaseous to a liquid state, resulting in increased pressure.

17

0

Share

What to Do When the EPC Light Comes On in a Car?

When the EPC light comes on in a car, the following solutions can be applied: 1. Check if the intake system has any faults; 2. Use high-quality fuel; 3. Inspect the electronic throttle body for excessive dirt and clean the throttle if necessary; 4. Remove carbon deposits from related components; 5. Rewrite the ECU-related data. The EPC in a vehicle stands for the Engine Power Control system, also known as the electronic throttle. When the EPC light appears, it indicates a fault in the electronic throttle. Possible causes include: 1. Brake light not functioning; 2. Throttle or wiring issues; 3. Damaged brake switch; 4. Faulty clutch switch; 5. Abnormal cylinder pressure leading to poor performance; 6. Leaks or blockages in the intake system; 7. ECU malfunction; 8. Occasional false alarms due to sporadic faults.

19

2

Share

What are the standards for fixed-point parking in Subject 2?

The evaluation criteria for fixed-point parking on the slope in Subject 2 are as follows: 1. Front bumper not aligned with the pole line: If the front bumper is not aligned with the pole line and exceeds 50CM forward or backward after stopping, it results in failure. If the front bumper is not aligned with the pole line but does not exceed 50CM forward or backward after stopping, 10 points are deducted. 2. Distance between the vehicle body and the road edge line: If the vehicle body is more than 30CM but less than 50CM away from the road edge line after stopping, 10 points are deducted. If the vehicle body is more than 50CM away from the road edge line after stopping, it results in failure. 3. Time: Exceeding the specified time for starting results in failure. 4. Parking brake: Failing to tighten the parking brake after stopping results in a 10-point deduction.

14

4

Share

What is the recommended mileage interval for replacing the fuel filter?

Recommended replacement interval: Every 20,000 kilometers driven, but this may vary depending on the road conditions and fuel quality. Extended knowledge: 1. If the car is frequently refueled at small gas stations: Then, the fuel filter (referring to the in-tank filter) should be replaced every 20,000 kilometers, and the external filter should be replaced every 10,000 kilometers. 2. If the car is refueled at major fixed-brand gas stations: The replacement interval can be appropriately extended, with the in-tank filter best replaced at 35,000 kilometers and the external filter best replaced at 15,000 kilometers.

6

4

Share

How Many Points Are Deducted for Driving Without Wearing Clothes?

What is the method for testing battery voltage?

How Often Must a Motor Vehicle Be Driven?

How to Determine if a Compressor Starter is Good or Bad?

What to Do When the EPC Light Comes On in a Car?

What are the standards for fixed-point parking in Subject 2?

What is the recommended mileage interval for replacing the fuel filter?

What car brand is represented by the 'md' logo?

Is the Honda XRV a three-cylinder or four-cylinder engine?

What is the difference between National V and National VI?

How to Reset the Oil Maintenance Indicator on the Vitara?