How many liters of transmission fluid does the Cadillac ATSL require?

Does the handbrake generally brake the front or rear wheels?

Automobile handbrakes typically control the rear wheels, usually connected to the rear brake shoes via a steel cable linkage. Their function is to control the braking of the rear wheels, not the front wheels, primarily to prevent the vehicle from rolling when parked. Here are some precautions for using the handbrake: 1. Always remember to engage the handbrake when parking and turning off the engine. Especially on slopes, shift into gear, engage the handbrake, and wait for the vehicle to stabilize before exiting. 2. The handbrake is often used in conjunction with neutral gear. When briefly stopping at a red light, do not forget to engage the handbrake while in neutral. This not only prevents rolling but also allows the right foot to release the brake pedal for a brief rest. 3. Do not pull the handbrake too tightly. Many modern handbrakes operate with a spring mechanism and usually have multiple positions. The higher the handbrake is pulled, the tighter the spring becomes, so it should be pulled just enough to prevent the car from shaking.

15

3

Share

How to Jump Start a Start-Stop Battery?

To jump start, you need to find two jumper cables and connect the positive terminals of both car batteries together, as well as the negative terminals. The car being jump-started can then start the engine. Here are the detailed steps: 1. Position the rescue vehicle and the rescued vehicle facing each other, close enough, open both engine hoods, and prepare two charging cables. 2. Connect the red end of the charging cable to the positive terminal of the rescued car's battery, and the black end to the negative terminal of the rescued car's battery, then you can start the ignition. Below is some relevant information about the battery: 1. When the engine is not running, the battery powers all the electronic devices in the car and is responsible for starting the engine. 2. When starting the engine, the starter motor, ignition system, and fuel supply system all require electricity. If there is no power in the battery, the engine cannot start normally.

16

1

Share

What is the difference between 5w40 and 10w40 engine oil?

5w40 and 10w40 differ in grade, applicable temperature range, and technology. Below are detailed explanations of the differences between 5w40 and 10w40: Different grades: 5W-40 is synthetic engine oil, which must meet SN grade (the highest standard). 10W-40 is all-season oil with a grade lower than SN, and it doesn't have SN grade certification. Different applicable temperatures: 5W-40 oil can be used at minimum temperatures as low as -25°C. 10W-40 oil can only be used down to -15°C. Different technologies: 5W-40 adopts synthetic technology, being chemically synthesized engine oil that can adjust various components according to different applications. 10W-40 is conventional lubricating oil composed of base oil and additives.

3

2

Share

How many liters of engine oil should be added to the Edge?

The recommended amount of engine oil to be added is approximately 5 liters. After adding the oil, you can check the oil level using the dipstick. Since this engine is equipped with a turbocharger, it is necessary to use fully synthetic oil. This is because the turbocharger operates under high temperatures and high-speed conditions, which demand superior lubrication from the oil. More details are as follows: 1. After adding the oil, start the vehicle and then turn it off. Wait for 3 minutes before checking the oil level. This is because when changing the oil, the oil filter also needs to be replaced. The newly installed oil filter initially contains no oil, and the oil will flow into the filter after the vehicle is started. 2. Waiting for 3 minutes allows the oil to flow back into the oil pan, ensuring a more accurate measurement. It is important not to check the oil level on a slope, as the vehicle's tilt will cause the oil in the oil pan to be uneven, leading to an inaccurate reading.

16

0

Share

What is the reason why the spare tire of the Lynk & Co 03 cannot be taken out?

The spare tire of the Lynk & Co 03 is generally fixed with screws in the groove under the rear trunk expansion board. If it cannot be taken out, it may be due to stripped screws or rust caused by prolonged inactivity, making it impossible to unscrew. Therefore, if the screws cannot be loosened to remove the spare tire, you can seek help from a repair shop to use an impact socket to loosen them, allowing the spare tire to be taken out. Below is relevant information: 1. Method to remove the spare tire of the Lynk & Co 03: (1) Lift the rear trunk floorboard; (2) Unscrew the fixing device; (3) Remove the spare tire. 2. Hidden spare tires are the easiest to remove and do not require tools. Applicable models: Most sedans and five-seater urban SUVs; Advantages: Easy and quick to remove and reinstall; Disadvantages: Spare tire rubber is prone to aging in enclosed spaces. There are strict requirements for the rotation of original tires, and spare tires should not participate in rotation. Tire rotation itself involves balancing wear in different areas, and it is no longer recommended to swap left and right tires. In fact, there are also differences in wear between front and rear tires. Due to wear issues, involving spare tires in rotation increases safety risks.

12

3

Share

What documents are required for replacing the supplementary page of a vehicle license?

The documents required for replacing the supplementary page of a vehicle license include: the original valid identity proof of the vehicle owner; the original vehicle license with full annotations; if an agent is handling the process, a signed power of attorney from both parties and the original identity proof of the agent must also be submitted. When a vehicle license is lost, missing, or illegible, the vehicle owner must follow the specified regulations and procedures to apply at the vehicle management office, submitting the following documents and presenting the vehicle for inspection: Fill out the "Application Form for Replacement or Renewal of Vehicle License Plates and Certificates"; the identity proof of the vehicle owner; the "Vehicle License"; a rubbing of the Vehicle Identification Number (VIN) and engine number; if the "Vehicle Registration Certificate" is illegible, the illegible certificate must be returned. For vehicles that have been legally confiscated and auctioned by administrative law enforcement agencies, or legally arbitrated by arbitration institutions, or mediated, adjudicated, or ruled by a court, and the current vehicle owner has not obtained the "Vehicle Registration Certificate", the owner must provide proof issued by the administrative law enforcement agency, arbitration institution, or court, or the "Notice of Assistance in Execution" issued by the court. For vehicle owners who cannot personally apply for the replacement of the "Vehicle Registration Certificate" due to reasons such as death, overseas travel, severe illness or disability, or force majeure, relevant proof must be provided.

17

3

Share

How many liters of transmission fluid does the Cadillac ATSL require?

Does the handbrake generally brake the front or rear wheels?

How to Jump Start a Start-Stop Battery?

What is the difference between 5w40 and 10w40 engine oil?

How many liters of engine oil should be added to the Edge?

What is the reason why the spare tire of the Lynk & Co 03 cannot be taken out?

What documents are required for replacing the supplementary page of a vehicle license?

Where to Find the Vehicle Identification Number?

What to Do If Your Car Gets Scratched?

What is the fuel tank capacity of the Chevrolet Cruze?

What is the fuel consumption of the BJ40?