···
Log in / Register

How many liters of oil does a Ford Edge need for an oil change?

3 Answers
MadelineMarie
08/29/25 6:49am
Ford Edge requires approximately 5 liters of oil for an oil change. After adding the oil, you can use the dipstick to measure and check if the level is appropriate. Taking the 2020 Ford Edge as an example, it belongs to the midsize SUV category with the following dimensions: length 4878mm, width 1925mm, height 1734mm, wheelbase 2850mm, fuel tank capacity 69l, and curb weight 1850kg. The 2020 Ford Edge features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 2.0L turbocharged engine that delivers a maximum horsepower of 245PS, maximum power of 180kW, and maximum torque of 390Nm, paired with an 8-speed automatic transmission.
Was this review help?
3
0
Share
LeJesse
09/11/25 4:25am
I've changed the oil for my Ford Edge many times before, and experience tells me that most models like the 2.0L or 2.7L engines require about 5.7 liters of oil. This capacity is clearly stated in the manual, but during actual operation, I have to be careful not to add too much or too little, as unstable oil pressure can damage the engine. I prefer using full synthetic oil like Mobil 5W-30 because it offers better high-temperature protection, especially for SUVs like the Edge that often go on long trips. The recommended oil change interval is every 5,000 to 7,500 miles, and remember to check if the oil filter is dirty—replacing it can extend the engine's lifespan. If you're doing it yourself, having a clean funnel and measuring cup is essential to avoid spills that are hard to clean up. After changing the oil, I always start the engine and let it run for a few minutes before checking the oil level again to ensure everything is safe and smooth. Spending a little on regular maintenance saves you from costly major repairs in the future.
Was this review help?
17
5
Share
Expand All
DiAlivia
10/25/25 5:16am
I've changed the oil in my Edge several times myself and found it usually takes around 5.7 liters, depending on the engine model. For example, the 2.0L requires about this amount. DIY oil changes are super simple - first drain the old oil from the oil pan, replace the filter, then slowly add new oil without rushing. Once I added a bit too much which caused engine vibration, but using the dipstick to precisely maintain the middle level fixed it. I recommend buying a 6-liter jug of oil - something like Shell's 5W-30 works perfectly, leaving some extra just in case. I change oil every 6,000 miles - it's cost-effective and saves dealership trips. While at it, I check tire pressure and battery condition for efficient maintenance. Always wear gloves and goggles for safety to prevent skin contact with oil that might cause irritation.
Was this review help?
5
0
Share
Expand All
More Forum Discussions

What Causes Oil Leakage in a New Motorcycle Engine?

New motorcycle engine oil leakage can be attributed to the following reasons: Poor Quality: Inferior quality of products (accessories) and materials, poor craftsmanship, and structural design issues. Improper Assembly and Adjustment: Unclean mating surfaces, damaged or displaced gaskets, or installation not performed according to operational specifications. Uneven Tightening Torque of Nuts: Thread stripping, broken fasteners, or loosening and falling off leading to operational failure. Excessive Wear of Sealing Materials: Sealing materials worn beyond limits after prolonged use, aging, deterioration, or deformation failure. Oil-related Issues: Excessive lubrication oil, high oil level, or incorrect oil type used. Part Deformation: Warping or deformation of part mating surfaces, or casing damage causing oil leakage.
19
1
Share

What is a Motorcycle Rocker Arm?

Rocker arm is a component located on the cylinder head of a motorcycle, responsible for pushing the valves open at the appropriate time to intake and exhaust air. Here is some extended information: 1. The rear rocker arm of a motorcycle, also known as the rear swingarm, refers to the part that connects the rear wheel to the motorcycle frame. It serves to secure the rear wheel, bear the pressure of the frame, and maintain stability. Different types of rear rocker arms significantly impact the bike's performance. 2. The difference between a double-sided rocker arm and a single-sided rocker arm lies in the connection points to the frame. A double-sided rocker arm is fixed on both sides, while a single-sided rocker arm is fixed on one side only. 3. A motorcycle rear wheel with two connection supports is a double-sided rocker arm, whereas one with a single connection support is a single-sided rocker arm. This design allows for quicker tire changes during races and reduces vehicle weight for enhanced performance.
13
1
Share

Will running a red light on a motorcycle be captured by electronic surveillance?

Running a red light will be captured by electronic surveillance because motorcycles are classified as motor vehicles. According to Article 2 of the "Scoring Standards for Road Traffic Safety Violations," running a red light results in a 6-point deduction and a fine of 200 yuan. Running a red light refers to the act of a motor vehicle violating traffic signal instructions by crossing the stop line and continuing to drive when the red light is on and passage is prohibited. Determining a red-light violation requires at least three pieces of photographic evidence: the vehicle has not left the stop line when the red light is on; the vehicle passes through the intersection when the red light is on; the vehicle has crossed the line and continues to move forward when the red light is on. Common scenarios of running a red light: When the red light is on, the front wheel touches the stop line. If the vehicle stops immediately, it is not considered running a red light; if it continues to move, it is counted as running a red light. After the red light is on, the vehicle completely crosses the stop line and stops on the pedestrian crossing. This is not considered running a red light but is classified as crossing the stop line, which incurs a 2-point deduction and a fine of 100 yuan. If the vehicle moves noticeably on the pedestrian crossing or obstructs pedestrian traffic, it will be judged as running a red light. If the front wheel crosses the stop line and then reverses back behind the stop line when the red light is on, this constitutes illegal reversing, which also incurs a fine of 20-200 yuan. If it causes a traffic accident with a rear vehicle, the driver will bear primary responsibility. After the red light is on, if the vehicle crosses the stop line and the pedestrian crossing and reaches the opposite intersection, this is considered running a red light. Ways to avoid running a red light: Follow arrow signals if available; otherwise, follow the circular light. When the red light is on, the front of the vehicle must not cross the stop line. When the yellow light is on, the front of the vehicle must not cross the stop line. When the green light just starts flashing, if you are close and moving fast, you should proceed, as braking may not stop you in time to avoid crossing the stop line. If you are far away, moving slowly, or the intersection is congested, you should stop. When driving in the city, develop the habit of looking for traffic lights whenever you see a pedestrian crossing or stop line at an intersection.
20
2
Share

What does it mean when the fault light on a Honda motorcycle comes on?

Honda motorcycle fault light illumination may indicate an issue with the fuel injection or electronic control system, requiring retrieval of fault codes at an authorized service center for targeted troubleshooting. However, false alarms sometimes occur with fault lights. If the motorcycle can still start and operate normally, you may ride it to the service center for inspection and consultation. Other potential causes include poor contact in the ignition switch, loose connectors of related electrical components, modified circuits, additional electrical accessories, or installation of alarm systems, which might also trigger the flashing. Below are introductions to some motorcycle brands: Haojue: Established in 1992, a diversified investment company primarily focused on the motorcycle industry, operating one of China's largest Sino-foreign joint venture motorcycle manufacturers. Wuyang-Honda: Founded in 1992 under Guangzhou Automobile Group, a major domestic motorcycle manufacturer integrating R&D, production, and sales. Jianshe-Yamaha: Originating in 1992, a top-ten motorcycle brand and Chongqing famous product, jointly established by Jianshe Industry Co., Ltd. and Japan's Yamaha Motor Co., Ltd. as a large-scale motorcycle enterprise. SUZUKI: Dating back to 1920 under Japan's Suzuki Motor Corporation, a modern enterprise specializing in motorcycle and automotive businesses, encompassing production, manufacturing, distribution, and after-sales services.
10
4
Share

What is the flash point of 92-octane gasoline?

92-octane gasoline has a flash point of -50 to -20°C. The "flash point" of gasoline refers to the temperature at which gasoline heated in a container causes a flash fire when exposed to a flame at the container's opening, but the fire extinguishes immediately afterward. The "ignition point" refers to the higher temperature at which continued heating causes not only a flash fire but sustained combustion. Among petroleum products, kerosene has a flash point above 40°C, diesel between 50-65°C, heavy oil between 80-120°C, and lubricating oil reaches around 300°C. Below is an introduction to 92-octane and 95-octane gasoline: 92-octane gasoline: 92-octane gasoline contains 92% isooctane and 8% n-heptane. 95-octane gasoline: 95-octane gasoline contains 95% isooctane and 5% n-heptane. When the pistons move in the engine cylinders, gasoline and air mix and compress inside the cylinder. If the pressure is too high, knocking can occur.
6
0
Share

Will running a red light on a motorcycle be captured by electronic surveillance?

Running a red light will be captured by electronic surveillance because motorcycles are classified as motor vehicles. According to Article 2 of the "Scoring Standards for Road Traffic Violations," running a red light results in a 6-point deduction and a fine. Running a red light refers to the act where a motor vehicle violates traffic signal instructions by crossing the stop line and continuing to move when the red light is on and passage is prohibited. Determining a red-light violation requires at least three pieces of photographic evidence: the vehicle has not left the stop line when the red light is on; the vehicle has passed through the intersection when the red light is on; the vehicle has crossed the line and continues to move forward when the red light is on. Common scenarios of running a red light: When the red light is on, the front wheel touches the stop line. If the vehicle stops immediately, it is not considered running a red light; if it continues to move, it is counted as running a red light. After the red light is on, the vehicle completely crosses the stop line and stops on the pedestrian crossing. This is not considered running a red light but is classified as stopping beyond the line, which does not result in point deductions. However, if the vehicle moves noticeably on the pedestrian crossing or obstructs pedestrian traffic, it will be judged as running a red light. If the front wheel crosses the stop line and then reverses back behind the stop line when the red light is on, this is considered illegal reversing, which also incurs a fine. If this causes a rear-end collision, the driver will bear primary responsibility for the accident. After the red light is on, if the vehicle crosses both the stop line and the pedestrian crossing and reaches the opposite intersection, this is considered running a red light. Ways to avoid running a red light: When arrow signals are present, follow the arrow lights; otherwise, follow the circular light. When the red light is on, the front of the vehicle must not cross the stop line. When the yellow light is on, the front of the vehicle must not cross the stop line. When the green light starts flashing, if the vehicle is close and moving fast, it should proceed because braking might not stop it in time to avoid crossing the stop line. If the vehicle is far away, moving slowly, or the intersection is congested, it should stop. When driving in the city, develop the habit of looking for traffic lights whenever encountering a pedestrian crossing, stop line, or intersection.
5
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.