How many liters of engine oil should be added to the Changan CS75PLUS?

Can ETC be used without sticking to the windshield?

ETC can be used without being attached to the windshield. Installing ETC on the upper part of the windshield is to minimize obstruction of the driver's view and to ensure better recognition by the equipment at highway toll stations. If you prefer not to install it on the windshield, place it in an open area where it can still be seen through the windshield. The installation position for ETC in small cars is generally in the upper middle part of the front windshield, while for large vehicles like trucks and buses, it is installed in the middle to lower part. The suitable installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with factory-installed or aftermarket explosion-proof film, which may affect the signal transmission of the microwave communication link, ETC should be installed in the microwave window area. Here are some considerations for installing ETC: Do not obstruct the view; it is best to install it behind the rearview mirror: Many car models have windshields with a significant rearward tilt, which can reduce the driver's field of vision. If ETC is installed without considering this, it may increase the driver's blind spots. Installing it behind the rearview mirror on the right side can help avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement because it has a built-in solar panel for self-charging. Therefore, during installation, avoid the blackened areas on the windshield and positions that may block the solar panel. Once installed, do not remove it arbitrarily: The button in the middle of the adhesive is an anti-removal lever connected to a switch. After installation, the windshield will press the anti-removal lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing range is 8 meters. To prevent issues caused by the ETC device of the vehicle in front malfunctioning, maintain a distance of more than 10 meters from the vehicle ahead to avoid automatic payment for the wrong vehicle. The speed limit for ETC lane recognition is 20 km/h; driving too fast may result in failure to read the vehicle's device information, leading to payment failure. When using a debit card linked to ETC, insufficient balance may also cause payment failure.

11

3

Share

How to Replace the Cabin Air Filter in a Haval H6?

Method for replacing the cabin air filter in a Haval H6: 1. Use a flat-head screwdriver to remove the glove compartment. 2. After removing the glove compartment, you will see the cabin air filter cover. 3. Press the clips with your fingers to remove the filter cover. 4. Open and take out the old filter, then install the new filter according to the arrow indicators. The functions of the cabin air filter are as follows: 1. Ensures the filter fits tightly against the housing, preventing unfiltered air from entering the cabin. 2. Separates solid impurities such as dust, pollen, and abrasive particles from the air. 3. Prevents condensation on car windows, ensuring clear visibility for drivers and passengers, thereby enhancing driving safety. 4. Maintains clean air in the passenger compartment, preventing bacterial growth and creating a healthy environment.

2

0

Share

What Causes the Engine Malfunction Indicator Light to Flash?

The reason the engine malfunction indicator light flashes is due to an abnormal air-fuel ratio detected by the oxygen sensor in the vehicle. When the engine malfunction light flashes, three scenarios may occur: 1. The warning light is on, but there are no noticeable driving issues. This might indicate a faulty sensor, and you can continue driving temporarily, preferably at low speeds. 2. The engine malfunction light is on, and the vehicle can still be driven, but with severe shaking or lack of acceleration power. In this case, roadside assistance is needed. 3. The car cannot start, which might be caused by a faulty fuel pump or ignition components. In this situation, you should call for emergency assistance.

13

5

Share

What technology is used in the Binrui engine?

Binrui employs turbocharged engine technology. The Binrui is equipped with 1.0T and 1.4T turbocharged engines. Below are the specific details: 1. The 1.4T engine delivers a maximum power of 98kw and a maximum torque of 215 Nm; the 1.0T engine provides a maximum power of 100kw and a maximum torque of 205 Nm. 2. The 1.0T engine is a three-cylinder engine, while the 1.4T engine is a four-cylinder engine. 3. In terms of the transmission system, the engines are paired with three types of gearboxes: a 6-speed manual transmission, a 6-speed dual-clutch transmission, and a CVT continuously variable transmission.

12

4

Share

What colors does the Teramont come in?

The Teramont is available in 6 colors: Black Metallic, Iceland Silver, Aurora White, Velvet Brown, Mountain Brown, and Desert Gold. Taking the 2022 Teramont as an example, here are its specifications: 1. Body dimensions: Length 5039mm, width 1989mm, height 1773mm, with a wheelbase of 2980mm. 2. Suspension: Front suspension is MacPherson strut independent suspension, and the rear suspension is multi-link independent suspension. 3. Powertrain: Equipped with a 2.0T turbocharged engine, delivering a maximum horsepower of 186PS, maximum torque of 320Nm, and maximum power of 137kW, paired with a 7-speed dual-clutch transmission.

17

2

Share

Which brand does the Patrol belong to?

Patrol is an imported SUV under the Nissan brand, and this vehicle belongs to the rugged off-road category. It is equipped with two types of engines: 1. A 4.0-liter naturally aspirated engine. The 4.0-liter naturally aspirated engine has a maximum power output of 205 kW, a maximum torque of 394 Nm, a maximum power speed of 5600 rpm, and a maximum torque speed of 4000 rpm. This engine features direct fuel injection technology. It is paired with a 7-speed automatic transmission. 2. A 5.6-liter naturally aspirated engine. The 5.6-liter naturally aspirated engine has a maximum power output of 293 kW, a maximum torque of 555 Nm, a maximum power speed of 5800 rpm, and a maximum torque speed of 4000 rpm. This engine also features direct fuel injection technology. It is paired with a 7-speed dual-clutch transmission.

5

3

Share

How many liters of engine oil should be added to the Changan CS75PLUS?

Can ETC be used without sticking to the windshield?

How to Replace the Cabin Air Filter in a Haval H6?

What Causes the Engine Malfunction Indicator Light to Flash?

What technology is used in the Binrui engine?

What colors does the Teramont come in?

Which brand does the Patrol belong to?

Where to place ETC in the car?

What is the 0-100 km/h acceleration time of the Hongqi HS5?

Can parallel imported cars be serviced at 4S stores?

Is the Wuling Hongguang rear-wheel drive?