How Many Liters of Engine Oil Should Be Added to the BYD Qin?
4 Answers
BYD Qin should be filled with 4 liters of engine oil during maintenance. The following is a detailed introduction about BYD Qin: 1. Overview: The BYD Qin is a high-performance sedan independently developed by BYD Co., Ltd., featuring the second-generation DM technology (switching between pure electric and hybrid modes). Since partnering with Germany's Daimler, BYD's vehicle manufacturing process has significantly improved. 2. Others: The wheelbase is 2670mm. The vehicle dimensions are 4740mm × 1770mm × 1480mm. The trunk capacity is 300L. The fuel consumption is 1.6L/100km (hybrid mode). The fuel tank capacity is 50L. The engine type is a 4-cylinder 1.5T direct fuel injection and electric drive. The top speed is 185km/h. The drive type is front-engine, front-wheel drive.
As a BYD Qin owner for several years, I find engine oil level quite crucial. During oil changes, adding around 4.2 liters is usually sufficient, but always check the manual for model variations - my hybrid version maintains stable levels. Overfilling causes fuel waste and smoke, while underfilling is worse as it may lead to excessive friction and part damage. I make it a habit to check the dipstick every 5,000 km: pull it out when cold, wipe clean, reinsert, and ensure the level stays between markers. 0W-20 full synthetic oil perfectly suits Qin's energy-efficient design - durable yet affordable. Don't delay oil changes; I service mine every six months for smooth engine performance. Once I slightly overfilled and experienced drastic fuel consumption spikes - a memorable lesson. New owners often make mistakes, so I recommend visiting 4S shops for professional measurement.
From a technical perspective, the engine oil capacity of the BYD Qin is a precise science, with its hybrid engine design specifically requiring approximately 4.2 liters as the standard volume. Engine oil acts like the lifeblood of the engine—getting the amount right can enhance fuel efficiency and prolong engine life. It's recommended to add oil when the engine is cold for more accurate measurement. After adding, start the engine for a few minutes and then check the dipstick to ensure the oil level is between the MAX and MIN marks. Using 0W-20 synthetic oil is suitable for the Qin's cold starts; avoid incorrect viscosity to prevent unnecessary expenses. For DIY oil changes, make sure to fully drain the old oil before adding new oil, and replace the oil filter simultaneously to prevent contamination. Common issues from incorrect oil levels: too much oil increases the risk of high oil pressure and leaks, while too little accelerates wear and may even cause engine seizure. I perform maintenance every 6,000 kilometers and keep a record of the data.
When I first started driving, I paid attention to engine oil. The BYD Qin manual states that the general oil capacity is 4.2 liters. Too little oil leads to rapid engine wear from dry friction, while too much can overflow and pollute the environment. Don’t try to measure it yourself—just go to the 4S shop for peace of mind; they’re professionals and will get it right. Checking the oil level with the dipstick is simple: park on level ground, turn off the engine, wait a bit, pull out the dipstick, and check if the oil mark is at the correct position. Choose 0W-20 type oil for durability, fuel efficiency, and hybrid use. The maintenance cycle is roughly every 8,000 kilometers—don’t skip it to save money in the long run.
