How many liters of engine oil should be added to a Volvo S60L?
3 Answers
Volvo S60L requires 3.6 liters of engine oil. The method for adding engine oil is as follows: 1. Lift the vehicle, remove the underbody panel, and place a container of about 10 liters under the oil drain plug; 2. Unscrew the oil drain plug, use an air gun to blow for two minutes at the oil filler port, then tighten the oil drain plug after draining and wipe it with a tissue to check for leaks; 3. Reinstall the underbody panel and lower the vehicle, then use a funnel to add engine oil through the oil filler port. Taking the 2021 Volvo S60L as an example, it belongs to the mid-size car category, with body dimensions of: length 4761mm, width 1850mm, height 1437mm, a wheelbase of 2872mm, and a trunk capacity of 391 liters.
I've been driving a Volvo S60L for several years, and during each maintenance session, I've noticed that the oil quantity usually ranges between 5.0 to 5.5 liters, depending on your engine model. For example, a 2.0T engine typically requires around 5.5 liters. Why so much? Because too little oil can lead to insufficient lubrication of engine components, causing overheating and wear, while too much oil increases resistance and fuel consumption. When changing the oil, don't fill it all at once. Start by pouring in about 4.5 liters, then start the engine and let it run for a few minutes to circulate the oil. After turning off the engine, wait a few minutes and check the dipstick—that little rod—to ensure the oil level is between the MIN and MAX marks, which is ideal. I also recommend using the manufacturer-recommended oil, such as 5W-30, with an oil change interval of about every six months or 5,000 kilometers. Regular checks ensure peace of mind and safety. I remember once adding too much oil myself, almost causing a leak—a lesson learned the hard way. Now, I always use a funnel and add oil slowly to avoid mistakes.
As a DIY enthusiast, I add 5.0 to 5.5 liters of oil when changing the oil for my Volvo S60L, but it needs to be done step by step. First, park the car on level ground, pull out the dipstick to check the old oil level, and replace it directly if it's below MIN. Don't rush when pouring in new oil: start with about 4 liters from the first bottle, then start the engine for two minutes to let the oil circulate fully; turn it off, wait a bit, and check the dipstick again. If it's insufficient, add a little at a time—0.1 liter each time—and check again to avoid overfilling, which could cause overflow or excessive oil pressure. I buy large-capacity oil containers to save costs. The process is simple, but be sure to use a funnel and clean any stains in the engine bay. After changing the oil, take a short test drive to confirm there are no leaks, and check the oil level monthly to ensure safety. This amount is optimal for the engine's design, as it relies on proper lubrication and cooling. Getting it wrong can damage the engine, and the joy of DIY lies in taking control with your own hands.
