How many liters of engine oil should be added to a Volkswagen Polo?

2 Answers
AlexisDella
07/29/25 11:39pm
Volkswagen POLO requires approximately 3.5L of engine oil. To confirm whether the amount of oil added is sufficient, you can check the oil dipstick after adding the oil. There are two marks on the dipstick: a maximum mark and a minimum mark. The normal oil level should not exceed the maximum mark or fall below the minimum mark; it should be between these two marks. Additional information: 1. Method for checking the oil level: After adding the oil, start the vehicle and then turn it off. Wait for 3 minutes before checking the oil level. This is because when changing the oil, the oil filter is also replaced, and the new oil filter initially contains no oil. After starting the vehicle, oil will flow into the oil filter. Waiting for 3 minutes allows the oil to settle into the oil pan, ensuring a more accurate reading. Remember not to check the oil level on a slope, as the vehicle's tilt will cause the oil in the oil pan to tilt as well, leading to an inaccurate measurement. 2. Effects of too much or too little oil: Overfilling with oil can interfere with the normal operation of the crankshaft and increase the vehicle's fuel consumption. Insufficient oil will reduce the effectiveness of the lubrication cycle, accelerating wear on internal engine components. Therefore, it is essential to maintain the oil level within the specified range.
Was this review help?
16
0
Share
ArcherDella
08/16/25 2:47am
I've been driving a Volkswagen Polo for several years, and doing my own maintenance has been quite enjoyable. Changing the oil, I find it quite simple: the amount varies slightly depending on the engine model, but generally, adding around 3.8 to 4.0 liters is about right. My 1.4L engine, as per the manual, requires 3.8 liters. When buying oil, I choose full synthetic with VW 502 00 specification, like 5W-30, and just pour it into the oil pan. Beginners should remember to check with the dipstick and not exceed the Max line, or the engine could wear out. By the way, don't skimp on the oil change interval; changing every 5,000 kilometers or every six months protects the car better. I've saved quite a bit by doing it myself.
Was this review help?
7
0
Share
Expand All
More Forum Discussions

How Many Times Can You Take the Subject 2 Test Each Month?

Generally, a driving school will coordinate with the vehicle management office to arrange 1-2 tests per month. Here are specific tips for the Subject 2 driving test: 1. Slow speed: Keeping the speed slow is the fundamental rule for practicing Subject 2. Ensure the vehicle doesn't stall while keeping the speed as slow as possible—the slower, the better. A slow speed allows ample time to adjust each operation. 2. Adjust the rearview mirrors: After getting in the car, always adjust the rearview mirrors properly, which is especially crucial for reverse parking and parallel parking. 3. Master the three-point alignment method: The three points are the driver's eyes, a reference point on the car, and a reference point on the ground. During the Subject 2 test, you must accurately identify and observe these points to perform precisely. 4. Pay attention to the four corners of the car: The front corner is prone to crossing the outer line during reverse parking, while the rear corner may scrape the side lines of the parking space. The front corner can easily go out of bounds during curve driving and right-angle turns. For parallel parking, the front corner may scrape the outer line or the left front corner of the parking space, while the right rear corner may scrape the right parking line. Therefore, always be mindful of the four corners and the outer boundary lines.
19
2
Share

What Causes the Steering Wheel to Wobble and Feel Loose on Bumpy Roads?

Steering wheel wobble on bumpy roads occurs because the vehicle's steering system moves with the suspension's height changes as the shocks absorb road irregularities. These movements are transmitted directly to the steering wheel, which is tightly connected to the steering system. Solutions for driving on bumpy roads include: 1. Road undulations: Extreme road surface variations cause the steering wheel to move with the tires. The safest method is to hold the wheel with fingers following its natural motion. 2. Wrist position: Avoid placing fingers inside the wheel or gripping it backwards to prevent finger or wrist injuries.
7
3
Share

What Causes a Cigarette Lighter to Stop Working?

The reasons for a cigarette lighter malfunction are as follows: 1. Poor contact: If it doesn't fit tightly, the power supply of the cigarette lighter usually isn't damaged, but prolonged disuse may cause poor contact. Try inserting the plug all the way in and then twisting it. 2. Fuse: Open the fuse box, locate the cigarette lighter fuse, remove it, and replace it if you have a spare fuse in the fuse box. 3. Cigarette lighter: Test with another car's cigarette lighter by pressing it down to see if it pops back up when it turns red. If it pops up, it indicates the original lighter is damaged. 4. Navigation or external appliance connection: You can slightly bend the contacts inside the cigarette lighter socket for better connection, but be careful not to short-circuit them, as this could blow the fuse.
5
3
Share

Can I Master Subject 2 in Half a Month?

Half a month is sufficient to master Subject 2. Subject 2 is not difficult. In Subject 2, as long as you accurately identify reference points, handle the clutch well, and perform normally during the test, you can generally pass. In summary, during Subject 2, it's essential to drive as slowly as possible—only by going slow can you make adjustments. If the speed is too fast, there won't be enough time to adjust. Below are some key points to note for the Subject 2 test: 1. Fasten your seatbelt: Buckle up immediately after getting in the car. Make sure not to fasten it backward or on the passenger side, as the system will directly deem the test failed. Do not unfasten the seatbelt at any point during the test. 2. Adjust the seat and mirrors: After getting in the car, adjust the seat, mirrors, fasten the seatbelt, turn on the left turn signal, shift into first gear, and release the handbrake. These six steps are indispensable. Ensure all preparations are complete before starting. 3. No stopping during the test: There is no time limit for reversing into the parking space, but it's crucial not to stop during the process. If the wheels remain stationary for 3 seconds, the system will judge it as an intermediate stop. Therefore, controlling the speed is key. 4. The time limit for hill starts is 30 seconds: The time limit for hill starts is 30 seconds, with the system providing a voice reminder every 10 seconds. Exceeding 30 seconds will result in an automatic failure.
8
0
Share

What are the characteristics of Dunlop tires?

Dunlop tires have the following characteristics: 1. Good handling performance: The overall performance is relatively balanced, and the service life is also relatively long. Although the performance in terms of sportiness, quietness, and wear resistance is not the best, it is definitely first-class. The wear resistance is relatively good, and the tire material is also quite hard, offering high cost performance. 2. Disadvantages of Dunlop tires: When turning at a constant radius, the grip action produces a loud buzzing noise, and the grip is noticeably weaker compared to top-tier brands. The tire noise is relatively high. 3. The biggest characteristic is that it has no outstanding characteristics (compared to other brands): The quietness and comfort are not as good as Michelin and Continental, and the grip is not as good as Pirelli. It is a relatively neutral tire. The price is, of course, exaggeratedly high. For the Chinese market, Dunlop has appropriately lowered the positioning of some smaller tire models to meet the needs of almost all vehicle types, making the price more reasonable.
18
1
Share

What is the manual evaluation in Subject 3 driving test?

During the Subject 3 driving test, in addition to the computer evaluating whether the examinee's operations are correct, the invigilator sitting beside the examinee will also observe if there are any improper operations during the test. This is called manual evaluation. Therefore, even if the computer does not deduct points, failing due to the invigilator's deduction still results in disqualification. Below are the evaluation criteria for Subject 3: 1. Vehicle preparation: Failing to walk around the vehicle counterclockwise to inspect the vehicle's appearance and surrounding environment results in disqualification. 2. Disqualification scenarios: Starting the vehicle with insufficient brake air pressure; starting with doors not fully closed; starting the engine with the gearshift not in neutral; starting without releasing the parking brake and failing to correct it promptly.
16
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.