···
Log in / Register

How many liters of engine oil does the Edge require?

3 Answers
LeHazel
07/24/25 4:08pm
Ford Edge requires approximately 5 liters of engine oil. After adding the oil, you can use the dipstick to check if the level is appropriate. It's important to note that you should wait three minutes after turning off the engine before checking the oil level with the dipstick. This three-minute wait allows the oil to flow back into the oil pan, ensuring a more accurate measurement. Here is more information about the Ford Edge: 1. The vehicle dimensions are: length 4680mm, width 1930mm, height 1700mm, with a wheelbase of 2824mm. 2. It is equipped with a 2.0L EcoBoost inline-four direct injection engine, which delivers a maximum power of 243 horsepower and a maximum torque of 345N·m. Additionally, the 3.5L V6 engine has been retained due to significant improvements in fuel economy achieved through recalibration, producing a maximum power of 288 horsepower and a maximum torque of 336N·m.
Was this review help?
10
5
Share
IsabelleLynn
08/10/25 7:38am
I've been driving the Edge for almost three years now. According to maintenance data, an oil change typically requires about 5.7 liters for standard engine types like the 2.0T engine. It's recommended to check the dipstick level before changing oil, and after refilling, let the engine idle for a few minutes before measuring again to ensure accuracy. It's best to use synthetic oil with a 5W-30 specification, which can enhance engine lifespan and fuel efficiency. Regular oil changes every 6,000 to 8,000 kilometers help prevent carbon buildup issues. Overall, maintenance costs aren't expensive, but they shouldn't be neglected.
Was this review help?
4
4
Share
Expand All
ReaganFitz
09/25/25 8:01am
I've changed the oil several times myself. For models like the Edge, the standard is around 6 liters. In practice, preparing one 5L and one 1L bottle of oil is just enough. When changing the oil, remember to drain the old oil, add the new oil, then start the engine for 30 seconds before turning it off to check that the oil level is in the middle of the dipstick. Adding too much oil may cause leaks, while too little can lead to engine overheating and damage. Also, remember to replace the oil filter to avoid clogging issues.
Was this review help?
11
3
Share
Expand All
More Forum Discussions

How to open the fuel tank cap of the Atenza?

The fuel tank cap switch of the Atenza is located on the left side of the driver's seat, below the small storage compartment. There are two switches: one for the engine hood and the other for the fuel filler cap. Pull the switch outward to open the fuel tank cap. This vehicle uses Mazda's specialized fully synthetic engine oil, 5W40, with an approximate filling volume of 4.5L. The Atenza has dimensions of 4870mm in length, 1840mm in width, and 1450mm in height, with a wheelbase of 2830mm. It features a front-engine, front-wheel-drive layout and a trunk capacity of 463L. In terms of power, the car is equipped with two engines: a 2.0L naturally aspirated engine and a 2.5L naturally aspirated engine.
8
5
Share

How Many More Years Can the World's Gasoline Last?

World's currently proven gasoline reserves are estimated to last for about 50 more years. If including newly discovered oil fields, this duration could be even longer. Below is relevant information about automotive gasoline: 1. Overview: Automotive gasoline is a liquid fuel refined from petroleum, primarily used for cars and motorcycles. 2. Classification: In China, automotive gasoline is divided into unleaded and leaded types. Unleaded gasoline comes in three octane ratings: 90, 93, and 95 RON (Research Octane Number). Leaded gasoline also has three octane ratings: 90, 93, and 97 RON. Among these, the lead content in 90-octane gasoline does not exceed 0.35g/L, while 93 and 97-octane gasoline have lead content not exceeding 0.45g/L.
17
5
Share

What is the penalty for overloading a minibus with 3 extra passengers?

Penalty ranges from 200-500 yuan with 3 demerit points. If exceeding 20% of the rated passenger capacity or violating cargo regulations, the fine increases to 500-2,000 yuan. Overloaded passengers must disembark before continuing the journey. Overloading refers to exceeding the vehicle's maximum allowable load limit. Below are relevant details about overloading: 1. Definition: Overload (Overload) means the actual load exceeds the approved maximum limit. For freight vehicles, it typically refers to cargo weight surpassing the vehicle's total authorized load capacity. 2. Hazards: Research shows when axle load doubles the standard, one trip equals 256 standard vehicle trips on asphalt roads or 65,536 trips on concrete roads. Larger vehicles cause exponentially more damage - China has recorded single rear axle loads reaching 24 tons. One trip by such vehicles equals 1.21 million standard vehicle trips on concrete roads.
12
2
Share

How to Deal with Low-Speed Jerking in BMW X3?

BMW has a slight jerking feeling is normal, usually if the feeling is particularly obvious, it should be due to clogged fuel lines, abnormal ignition, and internal stubborn dirt and impurities, timely maintenance and repair can solve the problem. Other reasons for jerking feeling: 1. Upshift jerking: The transmission response speed is not fast enough, the upshift speed cannot keep up with the throttle pedal speed, so at the moment of transmission shifting, a jerking feeling will occur. 2. Downshift jerking: Due to the intervention of the energy recovery system, once the driver releases the throttle pedal or steps on the brake pedal, the generator will immediately start working, which will burden the engine, affect the engine speed, causing the engine speed to be out of sync with the clutch plate speed, and then a jerking feeling will occur.
19
5
Share

Is Emergency Braking Hand Brake or Foot Brake?

Emergency braking is the hand brake. Below are specific details about emergency braking: 1. Introduction: Emergency braking refers to the situation when a driver quickly and correctly applies the brakes in the event of an emergency while driving, bringing the vehicle to a stop in the shortest possible distance. This braking method is only used in sudden situations and is an extreme form of braking. 2. Function: Emergency braking is essentially slamming on the brakes. When encountering an emergency while driving, the driver must correctly and swiftly apply the brakes to stop the vehicle in the shortest distance possible. Simply put, it's a sudden stop, but emergency braking isn't just about stomping on the brake pedal as hard as possible. The correct method of emergency braking is also crucial, and it's not suitable for use in all situations.
15
1
Share

What are the marking criteria for Subject 3?

There are three marking criteria in the Subject 3 examination: deducting 5 points, deducting 10 points, and deducting 100 points. Below are the relevant details regarding the marking criteria for Subject 3: 1. Deducting 100 points: (1) Before stopping, failing to observe the traffic conditions behind and to the right through the interior and exterior rearview mirrors. (2) After the examiner issues the command to pull over, failing to stop within the specified distance. (3) After stopping, the vehicle body exceeds the right edge of the road or the sidewalk edge. (4) After stopping, failing to turn the head to observe the traffic conditions to the side and left before opening the door. (5) Failing to close the door after exiting the vehicle. 2. Deducting 10 points: (1) After stopping, the vehicle body is more than 30cm away from the right edge of the road or the sidewalk edge. (2) After stopping, failing to tighten the parking brake. (3) Releasing the foot brake pedal before tightening the parking brake. 3. Deducting 5 points: Failing to turn off the engine before exiting the vehicle.
20
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.