How many kilometers should the Volvo XC60 spark plugs be replaced?

2 Answers
McAllison
07/25/25 1:19am
Volvo XC60 spark plugs are generally replaced every 60,000 kilometers. Under normal maintenance conditions, car spark plugs should be replaced after driving 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine. It is recommended to follow the user manual for guidance. The following standards can be referenced for maintenance and replacement: platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000 to 80,000 kilometers. Steps for replacing spark plugs: Open the hood, lift the plastic cover of the engine, and remove the high-voltage ignition wires. Mark each cylinder's position to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. While removing them, check for any external debris such as leaves or dust and ensure they are thoroughly cleaned. Place the new spark plugs into the spark plug holes, hand-tighten them a few turns, and then use the socket to tighten them further. Reinstall the removed high-voltage ignition wires in the firing order and secure the cover plate.
Was this review help?
4
0
Share
McRose
08/10/25 4:05pm
I'm an experienced driver of an XC60, and it's recommended to replace the spark plugs of this car at around 100,000 kilometers. If your daily driving habits are aggressive or you frequently take short trips, the spark plugs may wear out prematurely, leading to poor ignition, engine shaking, or increased fuel consumption. I've inspected many cars, and it's best to check the condition of the spark plugs every 80,000 to 100,000 kilometers. Once severe carbon buildup or enlarged gaps are found, they should be replaced immediately. Delaying replacement can degrade engine performance and even cause other faults, making it unwise to spend more on repairs later. During routine maintenance, the technician will remind you, and following the user manual is the most reliable approach. Developing a habit of regular maintenance can extend your car's lifespan and give you peace of mind while driving.
Was this review help?
13
2
Share
Expand All
More Forum Discussions

What is the difference between GLE and ML?

There is no difference between ML and GLE. The Mercedes-Benz GLE is the successor model to the Mercedes-Benz ML. Relevant information is as follows: 1. The Mercedes-Benz GLE is positioned as a mid-to-large-size SUV. Its body dimensions are 4930mm in length, 1950mm in width, and 1787mm in height, with a wheelbase of 2995mm. Some ML and GLE models have dimensions of 4941mm in length, 2018mm in width, and 1782mm in height. 2. In terms of power, there are two options: one is equipped with a 2.0-liter inline 4-cylinder turbocharged engine, paired with a 9-speed automatic transmission, delivering a maximum power of 190KW and a maximum torque of 370Nm. The other is equipped with a 2.0-liter inline 6-cylinder turbocharged engine, paired with a 9-speed automatic transmission, delivering a maximum power of 270KW and a maximum torque of 500Nm. The driving mode for all models is full-time four-wheel drive, and the fuel supply method is direct injection.
3
0
Share

What is the tire size of the Highlander?

The tire model size of the Highlander is 245/55-R19. Below is relevant information about tire specifications: 1. Tire specifications are commonly represented by a set of numbers, where the first number indicates the tire section width, and the latter denotes the rim diameter in inches. For example, 165/70-R14 represents a radial tire with a section width of 165 millimeters, an aspect ratio of 70, and a rim diameter of 14 inches. Some tires may include additional letters or symbols with special meanings: "X" indicates a high-pressure tire; "C" denotes a reinforced type; "B" represents a bias-ply tire; and "-" signifies a low-pressure tire. 2. M and S are abbreviations for Mud and Snow in English, indicating that the tire is suitable for use on snowy and muddy roads. Some tires have arrows or the word OUTER-SIDE marked on the sidewall, indicating the tire's rotation direction. If a small umbrella symbol is depicted on the sidewall, it means the tire is suitable for driving in rainy or slippery conditions.
6
1
Share

Why is there abnormal noise when driving?

Driving with abnormal noise can be caused by the following reasons: 1. The engine temperature is too low. When the car is cold-started, the engine temperature is too low for it to work properly, which is a normal phenomenon. Just wait a while until the engine temperature rises to a normal level. 2. The car's three-way catalytic converter expands due to heat. If there is abnormal noise when the car is just started, but it disappears after a while, it is caused by the expansion of the three-way catalytic converter due to heat, which is also a normal phenomenon and does not need attention. 3. Transmission failure. The internal gears of the transmission rub against each other, causing abnormal noise. This situation is more complicated and requires professionals at a repair shop or 4S store to inspect it. 4. Wear of the engine belt or chain. Wear of the engine belt or chain causes friction when the vehicle is started or idling, resulting in abnormal noise. For safety reasons, it is recommended to directly replace the engine belt or chain.
13
4
Share

What is a Joint Venture Car?

Joint venture cars refer to projects established through collaboration between Chinese and foreign investors. Below is an introduction to the investment methods of joint venture cars: 1. The Chinese side provides land and factory usage rights, as well as capital. 2. Foreign investors contribute brands, technology, capital, and talent. Below is extended information on the differences between domestic cars and joint venture cars: 1. Price: Due to core technologies being held by foreign companies, joint venture cars are often more expensive. 2. Investment method: Domestic cars are designed and manufactured entirely by Chinese entities; joint venture cars involve Chinese parties providing land, factory usage rights, and capital, while foreign investors contribute brands, technology, etc., to jointly manufacture the vehicles. 3. Brand: Domestic cars are self-owned brands; joint venture cars are produced through Sino-foreign collaborations.
15
0
Share

Is it allowed to make a U-turn at a double solid yellow line?

U-turns are not allowed at double solid yellow lines. Double solid yellow lines indicate that overtaking and U-turns are prohibited for vehicles. Making a U-turn at a double yellow line will result in a 3-point penalty and a fine. Other situations where U-turns are prohibited include: U-turns are prohibited where there is a 'No U-turn' sign or 'No Left Turn' sign: If there is a sign prohibiting U-turns, then U-turns are not allowed at that intersection. The action of making a U-turn is an extension of a left turn, so if there is a sign prohibiting left turns at an intersection, U-turns are also prohibited there. U-turns are prohibited when there is no left-turn lane: Even if you are in the leftmost lane, if there is no sign permitting left turns, U-turns are not allowed. U-turns are prohibited in the second left-turn lane: When a vehicle is in the second left-turn lane, it cannot make a U-turn. In the absence of any signs, vehicles can only make U-turns in the innermost left-turn lane. U-turns are prohibited on highways: Making a U-turn by crossing the central divider on a highway is illegal and will result in a fine and a 12-point penalty. If you miss an exit on the highway, continue to the next exit to leave the highway, and never attempt an illegal U-turn.
4
2
Share

What to Do When the Wuling Zhiguang Car Key is Locked Inside the Vehicle?

Solutions for when the key is locked inside the car are as follows: 1. Spare key: When the main key is accidentally locked inside the car, try to retrieve the spare key. This is the simplest and least costly method. 2. Break the window: It is recommended to choose the front door window, as replacing it is easier, has less impact on the seal, and the price is acceptable. 3. Locksmith company: Contact a locksmith company to avoid damaging the vehicle itself. 4. Call 110: For safety reasons, it is advised to directly call the local 110 to seek police assistance in recommending a locksmith company, avoiding illegal locksmith companies with malicious intent.
19
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.