How many kilometers should the Venucia CVT transmission fluid be changed?

1 Answers
DelAmy
07/29/25 11:17pm
Venucia CVT transmission fluid generally needs to be replaced every two years or after driving approximately 50,000 to 80,000 kilometers. Introduction to the transmission: A device that changes the speed ratio and direction of motion. It is used to alter the torque, speed, and direction of motion transmitted from the driving shaft to the driven shaft under different working conditions. A gear-driven transmission typically consists of a housing and several gear pairs. Function of the transmission: During vehicle operation, to adapt to different working conditions, the driving force and speed of the car need to vary within a certain range. However, the existing engine's torque and speed variation range cannot meet this requirement, hence the transmission is installed.
Was this review help?
5
2
Share
More Forum Discussions

How to Make Car Halogen Headlights Brighter?

Regularly clean the headlight housing to prevent dirt from affecting the brightness of the light. If the light still seems not bright enough, you can choose to replace the halogen bulb with one that has a higher color temperature. Here is some related knowledge about halogen headlights: 1. Definition: Halogen bulbs, also known as halogen lamps or quartz lamps, are a variant of incandescent lamps. 2. Working Principle: The principle involves injecting halogen gases such as iodine or bromine into the bulb. At high temperatures, the sublimated tungsten filament reacts chemically with the halogen. The cooled tungsten then re-solidifies on the filament, forming a balanced cycle that prevents the filament from breaking prematurely. Therefore, halogen bulbs last longer than incandescent lamps.
1
4
Share

What's the Difference Between Dual Clutch and Tiptronic?

The specific differences between dual clutch and tiptronic: 1. In terms of fuel economy: The dual-clutch transmission is equivalent to two automatic clutches, which is generally more fuel-efficient. 2. For power performance: Tiptronic is developed based on traditional automatic transmissions, with relatively slower response speeds. For engine protection, its power performance is somewhat inferior. 3. In terms of cost: Tiptronic is generally used in some mid-to-high-end cars with relatively faster gear shifting, while dual-clutch transmissions are typically used in high-end models and sports cars, with very expensive components. In terms of cost, tiptronic is slightly better. 4. In terms of driving pleasure: Tiptronic is generally more inclined towards automatic transmissions, while dual-clutch transmissions lean more towards manual transmissions, offering better overall driving pleasure.
8
4
Share

What car is represented by a cross and a snake?

A cross with a snake is the emblem of Alfa Romeo. Alfa Romeo (Alfa-Romeo) is a renowned Italian manufacturer of cars and sports cars, established in 1910 and headquartered in Milan. Reputation: From the outset, the company was known for specializing in the production of sports cars and racing cars, designed by famous Italian designers with strong Italian flair, elegant styling, and outstanding performance, enjoying a high reputation in the world automotive arena. Origin of the Logo: In 1910, when Alfa Romeo was founded, the creators combined two symbols of the city of Milan to create a badge: the red cross is part of the coat of arms of Milan, commemorating the medieval Crusader knights, while the man-eating dragon snake (biscione) pattern comes from the family crest of a local ancient noble family (the Visconti family), symbolizing the legend of the ancestors of the medieval Duke of Milan, Visconti, repelling the "dragon snake" that brought suffering to the city's people. The combination of these two symbols, representing Milan's traditions and unrelated in meaning, became one of the most famous logos in the automotive world.
7
1
Share

What are the symptoms of a faulty ABS sensor?

ABS sensor failure affects vehicle driving, and it is recommended not to continue driving. When the ABS light is on, it indicates a fault in the vehicle's anti-lock braking system. During emergency braking, if the wheels lock up, the vehicle may lose control and skid, making it difficult for the driver to slow down or adjust the vehicle's trajectory, posing significant safety hazards. ABS warning light stays on Reason 1: The sensing part of the ABS speed sensor is covered by mud, sludge, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle speed and the wheel slip rate, thus failing to issue appropriate commands to adjust braking. How to fix: Clean the dirt from the speed sensor and adjust the gap between the speed sensor and the signal ring to restore normal function. Reason 2: Loose connections between system lines or poor contact of the ABS relay can cause signal issues leading to system failure. The most common issue is a loose speed sensor connector, which will also show as a speed sensor signal fault in the ABS computer's error memory. How to fix: Check the line connections and reconnect any loose parts. ABS warning light intermittently turns on and off, extinguishing when accelerating Reason: When multiple vehicle electrical devices are in use, the battery voltage may drop below 10.5V. As the engine speed increases, the voltage rises, and the ABS warning light turns off. The ABS system power supply voltage is too low, possibly due to poor contact or grounding issues. How to fix: Check the battery's specific gravity; inspect the charging system; examine the power supply (e.g., voltage relay or poor power contact).
14
4
Share

Is a Car with a Cut C-Pillar Still Worth Buying?

A car with a cut C-pillar is not worth buying. Here is some information about the C-pillar: 1. Function: The C-pillar is used to support the roof and rear windshield. When the rear of the vehicle is impacted, the C-pillar also plays a role in protecting the rear passengers. In terms of appearance, the C-pillar is an important element that ensures the overall smooth and aesthetic lines of the car body. 3. Hazards After Cutting: Cutting the C-pillar affects the vehicle inspection. A car with a cut C-pillar can lead to a series of problems, such as affecting mechanical performance, reducing economic value, doors not closing properly, etc. This already qualifies as a salvage vehicle, and the safety factor of the car will also decrease after cutting.
2
4
Share

Is the Three-Way Catalytic Cleaner Really Effective?

Three-way catalytic cleaner is effective. Here is extended information about three-way catalytic cleaners: 1. Functions of three-way catalytic cleaner: Improves the oxidation-reduction efficiency of the three-way catalytic converter, reduces exhaust emissions, unclogs the three-way catalytic converter pipes, lowers exhaust back pressure, and enhances engine horsepower. It also reduces fuel consumption and extends the service life of the three-way catalytic converter. 2. When a car operates at low temperatures for a long time, the three-way catalytic converter cannot activate: Carbon soot emitted by the engine will adhere to the surface of the catalyst, preventing contact with CO and HC. Over time, this can clog the pores of the carrier, affecting its conversion efficiency. Additionally, if exhaust emissions are obstructed, the engine's power cannot be fully utilized, which is why many vehicles struggle to reach high speeds.
20
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.