How many kilometers should the transmission oil be changed for the XT5?

1 Answers
DePeyton
07/29/25 2:25pm
XT5 transmission oil replacement cycle is every two years or 40,000 kilometers, with a replacement capacity of 6L. Below is the relevant introduction about XT5 transmission oil: 1. Introduction: The Cadillac XT5 is a luxury SUV under the Cadillac brand, globally debuted at the Dubai International Motor Show in November 2015 and launched in China on April 12, 2016. The Cadillac XT5 is positioned as a mid-size luxury SUV, with main competitors including the Mercedes-Benz GLC, BMW X3, Volvo XC60, and Lexus RX. 2. Powertrain: The Cadillac XT5 can be equipped with two differently tuned 2.0T turbocharged direct-injection engines, with maximum power outputs of 184kW and 198kW respectively, both offering a peak torque of 400Nm. The engine is paired with an 8-speed automatic transmission featuring Start/Stop energy-saving technology.
Was this review help?
2
2
Share
More Forum Discussions

What is the compression ratio of the Tharu engine?

The compression ratio of the Tharu engine is 9:1, which is a turbocharged engine. The Tharu offers two powertrain models, equipped with 1.4T and 2.0T turbocharged engines respectively. The 1.4T engine delivers a maximum power of 110 kW and a maximum torque of 250 Nm, while the 2.0T engine provides a maximum power of 137 kW and a maximum torque of 320 Nm. Here are some details about the Tharu: 1. Dimensions: The Tharu is a vehicle launched by SAIC Volkswagen, with a length, width, and height of 4453mm, 1841mm, and 1632mm respectively, and a wheelbase of 2680mm. 2. Exterior: The Tharu adopts the Rock Cutting design concept. The raised lines on the backbone-style hood enhance the sense of power, while the wide-body dual U-shaped full LED headlights tilt upwards, with the grille strips extending to the headlights.
17
4
Share

Where is the handbrake module located in the Subaru Outback?

Subaru Outback's handbrake module is located at the lower left side of the steering wheel, below the exterior rearview mirror adjustment buttons. Below are the working principle and function of the handbrake. Working principle of the handbrake: Mechanical handbrake: It connects to the rear wheel brake calipers through steel cables or similar mechanisms. When the handbrake is pulled, the calipers press against the brake pads to achieve the parking function. Electronic handbrake: By activating the parking switch, the motor drives the steel cables or similar mechanisms to connect with the rear wheel brake calipers, pressing the brake pads to achieve the parking function. The handbrake is an extremely important component of the vehicle's braking system. Proper use of the handbrake can effectively prevent the vehicle from rolling and reduce the danger caused by rolling when parked. Function of the handbrake: When parking, it provides resistance to the vehicle to prevent it from rolling. The parking brake, also known as the handbrake or the parking gear in automatic transmissions, locks the drive shaft or rear wheels. The parking brake has much less force than the service brake, just enough to prevent the vehicle from rolling on a slope. Generally, the parking brake is used when parking is needed. At traffic lights, you can also shift to neutral and use the parking brake, i.e., the handbrake.
1
2
Share

What Causes Incorrect Fuel Tank Ventilation in Volkswagen?

Incorrect fuel tank ventilation in Volkswagen may be caused by a clogged activated charcoal canister or charcoal canister solenoid valve. Introduction to the fuel tank: The fuel tank is a container for storing fuel in aircraft or automobiles, and it is also a specialized container for storing hydraulic oil or hydraulic fluid in hydraulic systems. Fuel tanks can be divided into two types: open tanks and closed tanks. The fuel tank must have a sufficiently large volume. To maintain oil cleanliness, the tank should have a sealed cover with an air filter installed on it. The bottom of the tank should be at least 150mm above the ground, and sufficient attention should be paid to the anti-corrosion treatment of the inner surface of the tank. Calculation of fuel tank volume: The fuel tank volume is calculated using the formula length x width x height. Taking a regular rectangular fuel tank as an example, with a width of 58cm, height of 58cm, and length of 110cm, the tank capacity = 58 x 58 x 110 = 370,040 cubic centimeters. Since 1 liter = 1,000 cubic centimeters, the capacity is approximately 370 liters. The standard fuel tank volume indicated in the vehicle specifications is not the maximum fuel tank capacity. According to international standards, L (liter) is used as the unit of measurement for automobile fuel tank capacity, and different countries and regions also have corresponding standards for automobile fuel tank capacity.
18
4
Share

Where is the BMW 3 Series daytime running light switch?

The BMW 3 Series daytime running light switch is located in the vehicle computer's lighting settings. Here is some related information about daytime running lights: 1. Function: Daytime running lights are installed at the front of the vehicle. Their purpose is to make the vehicle more easily noticeable during daytime driving. Their effect is not to help the driver see the road better, but to let others know that a vehicle is approaching. Therefore, these lights are not illumination lamps but signal lamps. While adding daytime running lights can make a car look cooler and more stylish, their primary benefit lies not in aesthetics but in improving vehicle visibility. 2. Regulations: In foreign countries, using daytime running lights can reduce vehicle accidents by 12.4% and lower the fatality rate in accidents by 26.4%. In short, the purpose of daytime running lights is traffic safety. As a result, many countries have established relevant standards in recent years to ensure that the production and installation of daytime running lights truly enhance safety. The most representative of these is the ECER79 in the ECE Automotive Technical Regulations by the European Economic Commission. China also began implementing the national standard "Photometric Characteristics of Daytime Running Lamps for Motor Vehicles" on January 1, 2010, which was released on March 6, 2009.
6
3
Share

Does the Binyue have a four-cylinder engine?

Geely Binyue does not have a four-cylinder model. This car is equipped with a 1.0t engine and a 1.5t engine, both of which are three-cylinder engines. Three-cylinder engines are the future development trend, and many manufacturers are actively developing small-displacement turbocharged three-cylinder engines. The advantages of three-cylinder engines are as follows: 1. Lighter weight: Compared to four-cylinder engines, three-cylinder engines have one less cylinder, one less piston, one less connecting rod, a shorter crankshaft, one less exhaust manifold, one less intake manifold, one less fuel injector, one less ignition coil, and one less spark plug. The benefit of this is that the overall weight of the three-cylinder engine is lighter. 2. Easier to arrange the motor: The three-cylinder engine has a smaller volume and does not take up too much space in the engine compartment, so car manufacturers can place an electric motor in the engine compartment. 3. More fuel-efficient: Since the three-cylinder engine has one less cylinder than the four-cylinder engine and also has a lower displacement, the three-cylinder engine is more fuel-efficient.
12
5
Share

What is the fuel consumption of the Orlando on the highway?

The average fuel consumption of the Orlando is 8.0L/100km, with a range between 6.5L and 9.0L/100km. Fuel consumption is influenced by various objective factors, such as driving conditions, personal driving habits, whether the air conditioning is on, and the vehicle's load. Therefore, there is no precise or standard answer regarding fuel consumption. Here are some fuel-saving tips for driving: 1. Reduce the vehicle's load: Avoid keeping unnecessary items in the car. Not only do they take up space, but they also increase fuel consumption. A heavier vehicle requires the engine to expend more energy to drive, leading to higher fuel consumption. 2. Avoid sudden braking and accelerating: Especially when starting, sudden braking can significantly increase fuel consumption. 3. Maintain the vehicle within the economical speed range: Every car has an economical speed range, typically between 70KM/h and 90KM/h. Within this range, the car consumes the least fuel. Driving too slowly can also increase fuel consumption. 4. Keep tire pressure at the appropriate level: Tire pressure that is too high or too low increases friction and fuel consumption. Additionally, it can lead to unexpected incidents like tire blowouts, posing safety risks.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.