How many kilometers should the spark plugs of a Volkswagen car be replaced?

How to Install a Beam Wiper Blade?

Beam wiper blade installation steps are as follows: 1. The wiper and U-bar must form a 90-degree angle to remove the old wiper blade. Lift the wiper upwards until it is perpendicular to the windshield, then pull out the U-bar. 2. After removing the old wiper, install the new beam wiper blade. Gently press the "buttons" on both sides of the slot with your fingers, and the middle cover will open. 3. Insert the U-bar, snap the cover into place, and smooth it out to complete the installation. Related introduction to beam wiper blades: A beam wiper blade consists of four components: the wiper rubber, beam wiper steel strip, wiper cover, and plastic parts. The bracket is made of stainless steel, the steel strip is carbon steel with a length between 10-28 inches, a thickness of 0.80~0.90 mm, and a width generally between 7.00~14.00 mm.

19

5

Share

Can You Turn on the Wiper During Driving Test Subject Two in the Rain?

You can turn on the wiper. Here are some precautions for driving test subject two on rainy days: 1. Adjust your mindset: The most important thing for a rainy day test is your mindset. When encountering rain during the test, you must not have negative emotions or be overly nervous. Therefore, candidates must adjust their mindset during the test, maintain an optimistic mood, and not let the weather affect them. 2. Preparations before getting in the car: The rearview mirror may become blurry in the rain, so candidates must wipe the rearview mirror clean before getting in the car to avoid unclear visibility during the test. Before getting in the car, candidates should shake off mud and water from their feet to prevent slipping when stepping on the pedals. Driving in the rain makes the wheels prone to skidding. Therefore, during the test, candidates should control the speed of the car, which should be slower than during normal training. 3. Braking: Brake pads are prone to skidding in the rain, so when braking, you should apply slightly more force than usual. 4. Turning on the wiper: Generally speaking, not turning on the wiper does not have a significant impact on the test. However, it should be noted that before stopping at the designated point on the slope, turn on the wiper to clean the rainwater on the front windshield, then turn it off to prepare for the designated stop.

14

2

Share

Does stalling outside the test items result in point deduction in Subject 2?

Stalling outside the test items will not result in point deduction. Below are the examination contents for Subject 2: 1. Large vehicles: large buses, tractors, city buses, medium-sized buses, and heavy trucks: test items include stake test, hill start, parallel parking, single-plank bridge, curve driving, right-angle turn, narrow gate, continuous obstacles, bumpy road driving, narrow road U-turn, as well as simulated highway, continuous sharp turns on mountain roads, tunnels, rainy (foggy) conditions, slippery roads, and emergency handling. 2. Small vehicles: small cars, small automatic transmission cars, small automatic transmission cars for disabled people, and low-speed trucks: test items include reverse parking, hill start, parallel parking, curve driving, and right-angle turn. 3. Three-wheeled vehicles: three-wheeled cars, ordinary three-wheeled motorcycles, ordinary two-wheeled motorcycles, and mopeds: test items include stake test, hill start, and single-plank bridge; the test contents for wheeled self-propelled machinery, trolleybuses, and trams are determined by the provincial traffic management department of the public security organ.

12

2

Share

What are the five items in Subject 2?

Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment and is the abbreviation for the field driving skills test. For small cars (C1/C2), the test items include five mandatory components: reversing into a garage, parallel parking, stopping and starting on a slope, right-angle turns, and curve driving (commonly known as S-curves). In some regions, there is a sixth item: high-speed card collection. Below are related details: 1. Large vehicle test items: These include pole testing, stopping and starting on a slope, parallel parking, crossing a single-plank bridge, curve driving, right-angle turns, passing through a width-restricted gate, navigating continuous obstacles, driving on bumpy roads, narrow-road U-turns, as well as simulated highway driving, continuous sharp turns on mountain roads, tunnels, rain (fog) conditions, slippery roads, and emergency handling. 2. Notes: If you fail the Subject 2 test, you can retake it once. If you do not take the retest or fail the retest, the current test session ends, and the applicant must reschedule the test after ten days. Within the validity period of the driving skills test permit, the number of rescheduled tests for Subject 2 and Subject 3 road driving skills tests must not exceed five. If the fifth rescheduled test is still failed, the results of other previously passed subjects will be invalidated.

10

1

Share

How to Use ETC for Toll-Free Highway Access?

ETC lane entry and ETC lane exit: No fee deducted. Manual lane entry and manual lane exit: No fee deducted. Manual lane entry and ETC lane exit: No entry information, exit barrier won't lift. ETC lane entry and manual lane exit: Passable without fee deduction. ETC Working Principle: Through dedicated short-range communication between the on-board electronic tag installed on the vehicle's windshield and the microwave antenna in the ETC lane at the toll station, combined with computer networking technology for backend bank settlement, vehicles can pass highway or bridge toll stations without stopping to pay fees. Benefits of Installing ETC: Saves time by eliminating the hassle of waiting in queues. Environmentally friendly: Vehicles pass toll stations without stopping, reducing noise and exhaust emissions, thus minimizing pollution. Reduces wear and saves costs by decreasing the frequency of vehicle starts and brakes, lowering wear and fuel consumption. Users also enjoy a 5% discount on toll fees. Improves efficiency: ETC lanes can theoretically increase vehicle passing efficiency by 2-3 times, making traditional ETC updates faster and more high-tech. Compared to license plate payment, ETC technology is more mature and advantageous.

9

1

Share

What is the ideal idle speed for an automatic transmission car?

For automatic transmission vehicles, the general idle speed range is between 500 and 850 RPM. When the vehicle speed reaches 20 km/h, you can shift to 2nd gear at 1500-2000 RPM, and when the RPM exceeds 2000, shift to 3rd gear, bringing the vehicle close to 30 km/h. Similarly, shift to 4th gear when the speed reaches 50 km/h. This is because shifting at 2000 RPM can easily cause carbon buildup, so the fuel-efficient RPM range is between 1500-2000 RPM. Car idle speed is the minimum RPM set to ensure the engine doesn't stall and runs smoothly. As long as these two conditions are met, the lower the idle speed, the better. As long as the engine runs smoothly without shaking or stalling, it's acceptable. A lower idle speed saves more fuel because the vehicle is stationary at idle, meaning no fuel is consumed for movement. A higher idle speed has only one drawback: increased fuel consumption. Most cars have an idle speed between 600-850 RPM, with 700-800 RPM being the most common. Different car models have different engine speeds and idle values due to variations in engines. Generally, the idle speed ranges from 500 to 850 RPM, while the idle speed during a cold start can be around 1500 to 2000 RPM. Once the engine coolant temperature returns to 90 degrees, the idle speed stabilizes within the specified range.

3

1

Share

How many kilometers should the spark plugs of a Volkswagen car be replaced?

How to Install a Beam Wiper Blade?

Can You Turn on the Wiper During Driving Test Subject Two in the Rain?

Does stalling outside the test items result in point deduction in Subject 2?

What are the five items in Subject 2?

How to Use ETC for Toll-Free Highway Access?

What is the ideal idle speed for an automatic transmission car?

Subject 2: Should You Pull the Handbrake or Shift Gears First When Getting Out of the Car?

What are the reasons for failing the review of Subject 2 training hours?

How Long Does It Usually Take to Practice for Subject 2?

Is Gear Shifting Required in Subject 2?