How many kilometers should the Reiz transmission fluid be replaced?

Reasons for Rapid Rise in Car Engine Temperature

Here are the specific reasons for rapid engine temperature rise: 1. Insufficient coolant: Coolant leakage or low coolant level will cause engine temperature to rise. In this case, check the coolant level and top up if necessary. Recheck after a few days to see if the level drops significantly, and locate any leaks if present. 2. Cooling fan malfunction: During high-speed operation, heat cannot be effectively transferred to the antifreeze, affecting heat dissipation and causing antifreeze temperature to rise, potentially leading to boiling issues. 3. Water pump failure: Common pump failures include seized bearings or damaged impellers. While bearing seizure is rare, impeller damage (such as cracks or detachment from the pump shaft) can slow coolant circulation, easily causing engine overheating. 4. Thermostat malfunction: The thermostat automatically adjusts the amount of water entering the radiator based on coolant temperature, altering the circulation range to regulate the cooling system's capacity and maintain proper engine operating temperature. A faulty thermostat may prevent the cooling system from entering full circulation mode, resulting in elevated water temperature.

12

0

Share

Where is the car air conditioning cooling button located?

The blue button on the left side of the car represents the air conditioning cold air. Below are detailed introductions to the components of the car air conditioning system: 1. Air conditioning pressure sensor: Usually installed after the dryer, it is used to detect the hydraulic pressure of liquid refrigerant flowing through the expansion valve. Three wires: detect high pressure and low pressure. When a car collision causes refrigerant leakage and compressor oil loss, to prevent compressor damage due to lack of oil, once low pressure is detected, the compressor power is quickly cut off. When high pressure is detected, the compressor power needs to be reduced to avoid wasted work. 2. Air conditioning temperature sensor: Usually installed inside the temperature sensing package, it is the evaporator temperature sensor. When the temperature drops to a certain level, the compressor needs to be shut down. Further cooling would cause frosting, eventually leading to ice blockage. 3. Air conditioning compressor relay: Usually installed on the compressor, it is used to control the compressor's start, stop, and power switching functions.

8

0

Share

How Long Does It Take for an Imported Car to Be Considered a Stock Car?

An imported car is considered a stock car if it has been in storage for more than half a year. Here is a related introduction to stock cars: 1. Definition of a stock car: Parallel imported cars take up to 3 months to arrive at the port from the factory abroad, depending on the location of the foreign factory, such as the United States, Canada, Europe, or the Middle East. However, delays in customs clearance at the port can prolong this time. Therefore, if an imported car has been in storage for more than 6 months from the date of manufacture, it is considered a stock car. 2. Tips for identifying a stock car: The manufacturing date marked on the engine compartment nameplate indicates the actual storage time of the car. An imported car with a storage time exceeding 6 months can be classified as a stock car. Additionally, if there are obvious signs of aging on parts such as the wipers, engine belts, or tires, the car can also be considered a stock car.

14

1

Share

What does traffic law code 1345 mean?

Traffic violation code 1345 refers to the illegal act of a motor vehicle driving in violation of prohibition signs or prohibition line instructions. Below is a detailed introduction to traffic violation codes: 1. Meaning of violation codes: Traffic violation codes are a set of encoding regulations established by the Ministry of Public Security for traffic violations committed by motor vehicles and pedestrians. 2. First digit code: The behavior code consists of numbers 1 to 5 and 7, 8. 1 indicates motor vehicle passage, 2 indicates non-motor vehicle passage, 3 indicates pedestrian or passenger passage, 4 indicates highway passage, 5 indicates other regulations, 7 indicates implementation rules of provinces, autonomous regions, or municipalities directly under the central government, and 8 indicates local regulations of cities (regions, autonomous prefectures, or leagues). 3. Second digit code: The point deduction classification code consists of numbers 0, 1, 2, 3, 6, and 7. 0 indicates no points deducted, 1 indicates 1 point deducted, 2 indicates 2 points deducted, 3 indicates 3 points deducted, 6 indicates 6 points deducted, and 7 indicates 12 points deducted.

17

5

Share

What to Do When the Clutch and Throttle Are Not Well Coordinated?

Engine power is transmitted from the clutch to the wheels, with the reaction distance on the clutch pedal being only about 1 cm. Therefore, after depressing the clutch pedal and engaging the gear, when lifting the clutch pedal to the point where the clutch friction plates begin to make contact, the foot should pause briefly at this position while simultaneously applying the throttle. Once the clutch plates are fully engaged, the clutch pedal can be completely released. Below is an introduction to the clutch and throttle: 1. Clutch: The clutch is located within the flywheel housing between the engine and the transmission. The clutch assembly is secured to the rear plane of the flywheel with screws, and the output shaft of the clutch serves as the input shaft of the transmission. During driving, the driver can depress or release the clutch pedal as needed to temporarily separate or gradually engage the engine and transmission, thereby cutting off or transmitting the engine's power to the transmission. 2. Throttle: The throttle, also known as the 'accelerator' or 'throttle valve,' is the control device that regulates the engine's power (thrust). In piston aircraft engines, the throttle controls the carburetor's throttle opening to regulate the cylinder's filling volume, thereby determining the engine's output power.

15

3

Share

What does the yellow P light mean?

The yellow P on the car dashboard indicates that the parking brake is engaged, meaning the handbrake is in the braking position. Below are the specific reasons why the P light remains illuminated in yellow: 1. Handbrake not fully released: Some drivers forget to release the handbrake or do not release it completely, causing the handbrake light to turn on. 2. Brake fluid leakage: It is necessary to check the brake fluid, as leakage or insufficient brake fluid may cause the handbrake light to illuminate. The braking system mainly consists of energy supply devices, control devices, transmission devices, and brakes. The primary function of the braking system is to slow down or stop a moving car, maintain a stable speed for a car going downhill, and keep a parked car stationary. Using a fault detection device for inspection can quickly and accurately locate the fault and identify the cause step by step. 3. Worn brake discs: Accompanied by body vibration or abnormal noises when braking, it is likely due to thinning brake discs or foreign objects entering the brake pads. Uneven surfaces on the brake discs can cause sharp metal friction sounds when braking, as well as insufficient braking force, longer braking distances, and softer braking.

19

1

Share

How many kilometers should the Reiz transmission fluid be replaced?

Reasons for Rapid Rise in Car Engine Temperature

Where is the car air conditioning cooling button located?

How Long Does It Take for an Imported Car to Be Considered a Stock Car?

What does traffic law code 1345 mean?

What to Do When the Clutch and Throttle Are Not Well Coordinated?

What does the yellow P light mean?

What materials are required for vehicle inspection in 2021?

What do the first, second, third, and fourth gears mean?

Should the Negative Terminal of the Car Battery Be Disconnected When the Car Is Not Used for a Long Time?

How to Handle Traffic Violations with 0 Points and 0 Fine?