How many kilometers should the Mazda Atenza's transmission fluid be replaced?

What are the differences between the Izoa and the CHR?

The differences between the Izoa and the CHR are: 1. Different manufacturers: the Izoa is produced by FAW Toyota; the CHR is produced by GAC Toyota. 2. Different original tires: the Izoa is equipped with Dunlop Enasave tires; the CHR is equipped with Michelin Primacy 4 tires. The body dimensions of both the Izoa and the CHR are 4405mm in length, 1795mm in width, and 1565mm in height, with a wheelbase of 2640mm, a fuel tank capacity of 50 liters, and a trunk capacity of 295 liters. Both the Izoa and the CHR are equipped with a 2.0L naturally aspirated engine, with a maximum horsepower of 171ps, a maximum power of 126kw, a maximum torque of 203nm, and both are matched with a 10-speed continuously variable transmission.

10

0

Share

What is the method for removing the taillights of a Cadillac CT5?

The method for removing the taillights of a Cadillac CT5 is as follows: 1. Use a screwdriver to release the fixed clips; 2. Remove the inner lining cotton; 3. Locate the three nuts securing the rear taillight and remove them; 4. Disconnect the wiring harness plug of the rear taillight to complete the removal. The Cadillac CT5 has a body length, width, and height of 4924mm, 1883mm, and 1453mm respectively, with a wheelbase of 2947mm, a fuel tank capacity of 66 liters, and a trunk capacity of 384 liters. The Cadillac CT5 is equipped with a 2.0L turbocharged engine, delivering a maximum horsepower of 237PS, a maximum power of 174kW, a maximum torque of 350Nm, and is paired with a 10-speed automatic transmission.

20

3

Share

What kind of engine oil is used for Changan CS55?

Changan CS55 uses 5W40 full synthetic engine oil or 0W40 full synthetic engine oil. The steps for changing the engine oil are: 1. Lift the car, remove the protective plate, and place a container of about 10L under the oil drain screw; 2. Unscrew the oil drain screw, use an air gun to blow for two minutes at the oil filler port, tighten the oil drain screw after draining, and wipe it with a tissue to check for oil leakage; 3. Install the protective plate and lower the car, then use a funnel to add engine oil into the oil filler port. The length, width, and height of the Changan CS55 are 4500mm, 1855mm, and 1690mm respectively, with a wheelbase of 2650mm and a fuel tank capacity of 58L.

16

2

Share

What are the solutions for beginners stalling the car?

Solutions for beginners stalling the car are: 1. When starting, control the clutch properly and only release it after the vehicle begins to move; 2. While controlling the clutch, apply the throttle gently when releasing the clutch; 3. Use the handbrake to prevent rolling back and stalling; 4. Find the right time to shift gears to avoid driving at high gears with low speed. The reasons for beginners stalling are: 1. Nervousness and tension; 2. Insufficient mastery of the clutch; 3. Incoherent control of the clutch and throttle; 4. Lack of understanding of gear positions, leading to wrong gear selection; 5. Only stepping on the brake without the clutch during emergency braking.

20

5

Share

What car has a star-like logo?

The car with a star-like logo is the Dongfeng Venucia. Venucia models include: Venucia Star, Venucia T60, Venucia T70, Venucia T90, Venucia E30, etc. Taking the 2020 Venucia T70 Deluxe Edition as an example, its body dimensions are: length 4614mm, width 1786mm, height 1653mm, with a wheelbase of 2630mm, a fuel tank capacity of 65 liters, and a trunk capacity of 534 liters. The 2020 Venucia T70 Deluxe Edition is equipped with a 2.0L naturally aspirated engine, delivering a maximum horsepower of 150PS, a maximum power of 110kW, a maximum torque of 198Nm, and is paired with a continuously variable transmission.

17

2

Share

What are the reasons for the failure of tire pressure monitoring sensors?

The reasons for the failure of tire pressure monitoring sensors are: 1. Malfunction of the tire monitoring system; 2. Short circuit of the tire pressure sensor. The solutions for the failure of tire pressure monitoring sensors are: 1. Inspect and repair the tire pressure monitoring system; 2. Replace the tire or tire pressure sensor. The functions of tire pressure monitoring sensors are: 1. Prevent accidents; 2. Extend the service life of tires; 3. Reduce wear and tear on vehicle components. The working principle of tire pressure monitoring sensors is that the sensors installed on the tires monitor the pressure and temperature of the tires in real time, transmit the data wirelessly to the receiver, display the data changes on the display to alert the driver, and issue an alarm when there is a tire leak or the pressure changes exceed the safety limit.

7

1

Share

How many kilometers should the Mazda Atenza's transmission fluid be replaced?

What are the differences between the Izoa and the CHR?

What is the method for removing the taillights of a Cadillac CT5?

What kind of engine oil is used for Changan CS55?

What are the solutions for beginners stalling the car?

What car has a star-like logo?

What are the reasons for the failure of tire pressure monitoring sensors?

At what mileage is a major car maintenance due?

What is the correct method to start a manual transmission car?

What is the normal idle speed of a car?

What are the reasons for an automatic transmission car failing to start?