How many kilometers should the Leiling gasoline filter be replaced?

1 Answers
Omar
07/29/25 4:04pm
The Leiling gasoline filter should be replaced every 20,000 to 30,000 kilometers. The replacement method is as follows: 1. Close the inlet valve of the gasoline filter, unscrew the end cover bolts, and open the end cover; 2. Open the drain valve to completely drain the dirty oil; 3. Loosen the tightening nut at the upper end of the gasoline filter and remove the old filter vertically upwards; 4. After replacing the gasoline filter, close the drain valve and tighten the end cover bolts. The Leiling has a body length, width, and height of 4640mm, 1780mm, and 1455mm respectively, with a wheelbase of 2700mm, a fuel tank capacity of 50 liters, and a trunk capacity of 471 liters. It is equipped with a 1.2T turbocharged engine with a maximum torque of 185Nm, a maximum horsepower of 116PS, and a maximum power of 85kW, paired with a 10-speed continuously variable transmission.
Was this review help?
10
0
Share
More Forum Discussions

Does Car Insurance Cover Full Compensation for Water Damage?

If a car is submerged in water and the corresponding insurance has been purchased without performing a secondary start-up operation, the insurance company will provide full compensation. According to the provisions of the Home-use Automobile Loss Insurance Clause, during the insurance period, if the insured or their legally permitted user suffers loss of the insured vehicle due to natural disasters such as rainstorms or floods while using the vehicle, the insurance company will compensate as agreed. Procedure for claiming compensation after a vehicle is submerged in water: Vehicle water damage generally falls into two scenarios: first, when the vehicle is parked on the roadside or in an underground garage and gets submerged due to deep water accumulation; second, when the vehicle is driven into a waterlogged area, leading to water ingress, stalling, and inability to proceed. It is important to remain calm in such situations. Ensure personal safety first, then immediately report the incident by calling the insurance company where the vehicle is insured. Next, take photos. If the insurance surveyor cannot arrive promptly, the owner should take photos of the scene and the vehicle's damage condition safely for assessment and claims. Lastly, arrange for rescue services, either through the insurance company or a professional rescue company.
9
1
Share

What is Subject 2 Simulation Training?

Subject 2 simulation is a practice that mimics the official Subject 2 driving test to improve the pass rate. The simulation covers the same test items as the official exam, serving as a trial run. Below are the relevant details: 1. Overview: Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment and refers to the field driving skills test. 2. Test Items: For car licenses C1 and C2, the test includes five mandatory items: reversing into a garage, parallel parking, stopping and starting on a slope, right-angle turns, and curve driving (commonly known as the S-curve). Some regions may also include a sixth item, such as highway toll card collection. 3. Learning Objectives: Master the basic essentials of driving operations and acquire fundamental vehicle control skills; become proficient in basic methods of field and road driving within the test area; develop the ability to reasonably use vehicle controls and correctly manage the spatial position of the vehicle, ensuring precise control over the vehicle's position, speed, and route.
3
2
Share

Can I renew my driver's license if it has expired for 20 days?

You can renew your driver's license if it has expired for 20 days. According to the regulations, if the license has been expired for less than one year, it can be renewed normally. The renewal and inspection must meet the following conditions: Holders of large passenger vehicle, tractor, city bus, medium-sized passenger vehicle, or large truck driver's licenses must have no demerit points in the current scoring cycle, or holders of other types of driver's licenses must have fewer than 12 demerit points in the current scoring cycle; Holders of large passenger vehicle, tractor, city bus, medium-sized passenger vehicle, or large truck driver's licenses who have demerit points in one scoring cycle, as well as holders of other types of driver's licenses who have been involved in a traffic accident resulting in death and assumed equal or greater responsibility without having their driver's license revoked, must have completed the inspection education; The applicant must have no pending road traffic safety violations or traffic accidents; The applicant's physical condition must meet the driving license requirements; The driver's license must not be under circumstances such as being seized, detained, temporarily suspended, revoked, canceled, or annulled by law.
5
2
Share

What is the difference between diversion and increasing the number of lanes?

Diversion and increasing the number of lanes differ in meaning, arrangement, and purpose. Different meanings: A diversion lane is an auxiliary lane designed for vehicles to complete the diversion process. The basic number of lanes refers to the required number of lanes on a road or a specific section, determined based on traffic volume and capacity requirements. Different arrangements: Diversion points are typically located at the entrance of a level intersection or the exit of a highway (elevated road) ramp. Increasing the number of lanes is applied to wide roads with good traffic conditions and high vehicle flow. Different purposes: Diversion points are measures taken to ensure orderly traffic flow, enhance safety, smoothness, and improve traffic capacity. Increasing the number of lanes aims to achieve balance at the points where the main road merges with or diverges from ramps. A diversion sign is an indication sign, signaling the presence of a diversion lane ahead, and vehicles should proceed straight or exit the main lane as directed by the arrows. Diversion is a traffic engineering term describing the phenomenon where a single traffic flow splits into two or multiple flows.
11
0
Share

What does engine oil FS mean?

Engine oil FS is one of the oil models of Mobil oil, also known as Mobil lubricants, which has many varieties. Mobil gasoline engine lubricants are divided into three major series: Mobil 1 series, Mobil Super series, and Mobil Delvac series. Mobil 1 is a fully synthetic oil, and this series includes Mobil 1 Gold (Gold Mobil), Mobil 1 Silver (Silver Mobil), and Mobil 1 Green (Green Mobil). The Mobil Super series includes Mobil Super 2000 and Mobil Super 1000. The Mobil Super series is quite special because Super 2000 is a semi-synthetic lubricant, while Super 1000 is a mineral oil. The Delvac series includes Mobil Delvac Super and Mobil Delvac, both of which are mineral oils. Main characteristics of Mobil oil FS: The fully synthetic formula contains active cleaning agents that help prevent the buildup of sludge and deposits, keeping the engine clean. Excellent thermal and oxidation stability helps reduce oil aging. Lower oil volatility performance makes the engine more fuel-efficient. Outstanding low-temperature performance ensures quick starts and rapid protection in cold climates, helping to extend engine life. High viscosity index provides overall lubrication and wear protection.
2
5
Share

Which Way to Loosen the Spare Tire Bolt?

For passenger cars, turning the spare tire bolt to the left loosens it, while turning to the right tightens it. For large trucks, the left-side tires follow 'left tightens, right loosens,' whereas the right-side tires follow 'right tightens, left loosens.' When replacing a tire, pay attention to the operation sequence. When tightening the bolts, avoid tightening them in a clockwise or counterclockwise order one by one; instead, follow a diagonal sequence to tighten the bolts. If the tire bolt is too tight to loosen, you can apply a lubricating solvent like diesel to the bolt. Alternatively, you can appropriately use your foot to increase the tightening force on the nut, but avoid reckless kicking, as it can directly damage the nut or bolt and may cause the wrench to suddenly pop out, posing safety risks. A full-size spare tire has the exact same specifications as the other four tires on the vehicle and can replace any temporarily or permanently unusable tire. A non-full-size spare tire has a slightly smaller diameter and width compared to the other four tires, making it suitable only for temporary use. Moreover, it should only be used on non-driving wheels, and the maximum speed should not exceed 80 km/h.
3
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.