How Many Kilometers Should Engine Oil Generally Be Changed?

1 Answers
MilesAnn
08/26/25 3:38am
Lubricating oils are categorized into full synthetic oil, semi-synthetic oil, and mineral oil. These three types of engine oils differ in quality and, consequently, in their service intervals. Generally, full synthetic oil should be changed within 10,000 kilometers, semi-synthetic oil within 7,500 kilometers, and the lowest-grade mineral oil requires replacement within 5,000 kilometers. Here is some information about engine oil: 1. Engine oil is the lubricant used in engines, composed of base oil and additives. 2. With a density of approximately 0.91×10³ (kg/m³), engine oil serves to lubricate and reduce friction, assist in cooling, seal against leaks, prevent rust and corrosion, and cushion shocks, earning it the nickname "the blood of the car."
Was this review help?
9
0
Share
More Forum Discussions

Is There Any Benefit to Occasionally Using 95 Octane Gasoline for Your Car?

Occasionally using 95 octane gasoline offers the following benefits for your car: Higher Efficiency: 95 octane gasoline is purer and of better quality, containing more isooctane. As a result, vehicles using 95 octane gasoline exhibit significantly better anti-knock performance, allowing the gasoline to burn more completely and efficiently. Environmental Protection: It helps reduce pollutant emissions from motor vehicles. New vehicles can see reductions in nitrogen oxide and particulate emissions by 25% and 80% respectively, while in-use vehicles can achieve an overall emission reduction of 10%-15%. This plays a significant role in protecting the environment and improving air quality.
10
2
Share

Can S gear and D gear be switched freely?

Automobile S gear and D gear can be switched freely, but safety precautions should be taken. Relevant information is as follows: Transmission aspect: Lower gears allow the transmission to output greater torque (power). When switching to S gear while driving and accelerating, the computer will immediately control downshifting to obtain greater torque output. Engine aspect: Generally, for naturally aspirated engines, the maximum torque occurs around 4000 rpm. Delaying the shift point allows the engine to always operate within the maximum torque speed range, similar to what is seen in racing movies where drivers don't release the throttle during shifts to prevent engine speed from dropping, thus avoiding the need for a speed climb after shifting. Long-term use of S gear: The powerful performance of S gear comes at the cost of significantly increased fuel consumption. Prolonged use of S gear can also lead to accelerated wear of the engine and transmission, reducing their service life. Therefore, it is not recommended to use S gear for extended periods.
18
4
Share

What is the horsepower of an Isuzu engine?

Isuzu engine has a maximum output power of 97kW, rated speed of 3000rpm, maximum horsepower of 132hp, maximum torque of 320N.m, maximum torque speed range of 1600-2400rpm, full-load minimum fuel consumption rate of 210g/kW.h, and net engine weight of 220kg. The model introductions of Isuzu engines are as follows: 1. Introduction 1: The 4JB1 is installed in Isuzu 100P vehicles and some pickup truck models, with a horsepower of 95 and fuel consumption of approximately 11 in the 100P. 2. Introduction 2: The 4KHI is installed in Isuzu 600P vehicles with 130 horsepower and fuel consumption of approximately 13, while the 4HK1 is installed in Isuzu 700P vehicles with 175 horsepower and fuel consumption of approximately 15. 3. Introduction 3: The 4ZE3 is installed in Isuzu pickup trucks and is a gasoline engine. 4. Introduction 4: The 6HK1 is installed in Isuzu F-type vehicles.
9
3
Share

How Many Points Will Be Deducted for Speeding from 80 to 120 km/h?

Driving at 120 km/h in an 80 km/h zone constitutes a 50% speed violation. According to the calculation formula: Speed violation = (120 - 80) / 80 = 50%. As stipulated by the Road Traffic Safety Law, exceeding the speed limit by more than 20% but less than 50% will result in a 6-point deduction and corresponding fines. The penalties for traffic speed violations are as follows: 1. Exceeding the speed limit by less than 10%: Fine and 3-point deduction. 2. Exceeding the speed limit by more than 10% but less than 50%: Fine and 3-point deduction. 3. Exceeding the speed limit by more than 50% but less than 70%: Fine and 6-point deduction. 4. Exceeding the speed limit by more than 70% but less than 100%: Fine and 6-point deduction, with possible license suspension. 5. Exceeding the speed limit by 100%: Fine and 6-point deduction, with possible license suspension.
13
2
Share

What are the levels of road bike groupsets?

Road bike groupset levels are as follows: Claris series (R2000): Designed for relaxed sports, long-distance touring, urban cruising in casual attire, shopping, and daily commuting, available in both drop-bar shifter and flat-bar shifter versions. Simply put, it's specifically for grocery-getter bikes, only meeting the most basic "having gears" requirement. Sora series (R3000): Commonly found on entry-level complete road bikes, it incorporates technologies trickled down from higher-end groupsets, making it very suitable for beginners in road cycling or budget-conscious new users, and can be considered a quasi-sport-level groupset. Tiagra series (4700): Adopts many technologies from higher-tier groupsets, offering a user experience close to the 105 level, and comes at a very attractive price point.
15
3
Share

What is the difference between d1s and d3s?

d1s and d3s differ as follows: Configuration: d1s is equipped with a mercury-containing starter, while d3s uses a mercury-free starter. Voltage: d1s operates at 85V, whereas d3s operates at 45V. Brightness: d1s is significantly brighter than d3s, and its color temperature is whiter. Additional information on xenon headlights is as follows: Classification: Based on bulb types, they can be divided into three main categories: 900 series; H series; D series, with the D series also known as the lens series. Models: Among all vehicle lighting systems, the most commonly used bulbs are H1, H4, H7, 9005, 9006, and 9007, with an average lifespan of around 250 hours. Therefore, vehicle owners need to replace them promptly to avoid bulb failure during driving, which could pose a hazard.
9
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.