How many kilometers can a Fit run on a full tank of gas on the highway?

What to Do When Rubber Components in a Car Age?

When rubber components in a car show signs of aging, they need to be replaced with new ones. Here is more information about rubber components: 1. There are many rubber components in a car: windshield wipers, body sealing strips, tires, chassis bushings, CV joint boots, shock absorber top mounts, engine mounts, etc. Aging components can affect the driving feel and ride comfort of the vehicle. 2. Several methods to prevent aging of car rubber parts: (1) Use physical protection methods such as applying coatings and protective films, like dipping in anti-aging agent solutions, painting, or metal plating. (2) Use chemical protection by adding anti-aging agents during the rubber processing, such as adding UV stabilizers, mildew inhibitors, or heat stabilizers to the vulcanized rubber formula. 3. Signs of rubber aging: Cracking, stickiness, hardening, softening, powdering, discoloration, and mold growth are all signs of rubber aging.

13

4

Share

Why does the Corolla jerk and shake?

Corolla jerking and shaking is a normal phenomenon. The following are the reasons for car shaking: 1. Dirty throttle or excessive carbon deposits on the fuel injector: After the car starts, the gasoline adsorbed on the carbon deposits will be sucked into the cylinder by the engine's vacuum suction for combustion, which enriches the air-fuel mixture. The combustible mixture in the engine becomes alternately lean and rich, causing idle shaking after a cold start. Solution: Clean the fuel system and check if the idle control valve has carbon deposits that need cleaning. 2. Ignition system issues: Check the condition of the spark plugs, high-voltage wires, and ignition coils. Poor performance of the ignition system or inadequate spark plug firing can also cause such symptoms. 3. Unstable fuel pressure: It is recommended to visit a 4S shop to check the fuel supply pressure and the intake pressure sensor for normal operation. If the fuel pump's supply pressure is abnormal or the intake pressure sensor values are incorrect or malfunctioning, it can cause the car body to shake.

19

1

Share

How many liters of transmission fluid are needed for an Envision 28T transmission fluid change?

If it is a manual fluid change (gravity drain), four to six liters are required; if a fluid exchange machine is used, approximately nine to twelve liters are needed. The methods for changing transmission fluid are as follows: Loosen the drain plug at the bottom of the transmission to drain the fluid, then refill. Remove the transmission oil pan directly to drain and refill the fluid: This method is more thorough than the previous one, as it removes impurities from the bottom of the oil pan. Use a transmission fluid exchange machine for automatic transmission fluid changes: A smart exchange machine can perform dynamic fluid changes, filtering and cleaning sludge and impurities inside the automatic transmission. Hazards of not changing transmission fluid for a long time: 1. Damage to the transmission's shift control mechanism; 2. Abnormal wear of gears and clutch plates inside the transmission; 3. Affects the normal operation of the transmission, leading to damage to the transmission valve body.

19

4

Share

What does the 'lim' mean on a BMW?

The 'lim' button on a BMW is the speed limit button. It is used for the speed limit function. After setting the speed value, the speed will be limited to a certain value, and even if you press the accelerator, the speed will not increase. This can be used to prevent speeding. The usage method is: 1. Press the 'lim' button once to turn on the 'lim' function. 2. Press it again to turn off the 'lim' function. Additional information: If the vehicle speed exceeds the set speed limit, the system will issue a warning. When reaching or exceeding the set speed limit under conditions such as downhill driving, the active braking mode will not be activated. If a speed limit lower than the current speed is set during driving, the vehicle will coast until the speed is below the limit. Since the system allows exceeding the speed limit under certain special circumstances, the driver can exceed the speed limit as needed, and in this case, the system will not issue an audible warning.

6

5

Share

Is It Necessary to Apply Film to a Car Sunroof?

Generally, it is not recommended to apply film to a car sunroof for the following reasons: 1. Sunroof glass usually already has UV protection and heat insulation functions. Applying film again would not only result in a certain degree of resource waste but could also affect the overall quality of the vehicle. For example, after applying film to the sunroof, the increased thickness of the glass might, if not installed properly, lead to difficulties in opening and closing the sunroof smoothly. 2. Large panoramic sunroofs have a greater heat absorption area, allowing two to three times more sunlight into the car compared to smaller sunroofs, which might necessitate applying film to control the interior temperature. However, not all panoramic sunroofs are suitable for film application. If the car's sunroof glass is already tinted, it is advisable to avoid colored films to maintain the vehicle's overall aesthetic appeal. 3. Additionally, whether to apply film to the vehicle's windows or sunroof should not only be based on the owner's preference but also involve consulting professionals for advice.

14

5

Share

Why Won't the Car Start After Being Parked for a Long Time?

The reasons why a car won't start after being parked for a long time are as follows: 1. The battery is dead due to prolonged inactivity, preventing the car from starting. The car battery is a crucial component that powers all electronic devices in the vehicle and is responsible for starting the engine. When the engine is off, the battery supplies power to the car's electronic devices. Once the engine is running, the alternator takes over powering the electronic devices. 2. The battery is a wear-and-tear part, with a typical lifespan of 3 to 4 years. However, many car batteries fail before reaching this lifespan due to improper usage habits. Avoid listening to music for extended periods, turning on headlights, or using the air conditioning when the engine is off, as these actions can shorten the battery's life. 3. When the car is not in use for an extended period, you can disconnect the negative terminal of the battery to prevent it from discharging. If the battery remains in a discharged state for too long, its lifespan will be reduced.

17

2

Share

How many kilometers can a Fit run on a full tank of gas on the highway?

What to Do When Rubber Components in a Car Age?

Why does the Corolla jerk and shake?

How many liters of transmission fluid are needed for an Envision 28T transmission fluid change?

What does the 'lim' mean on a BMW?

Is It Necessary to Apply Film to a Car Sunroof?

Why Won't the Car Start After Being Parked for a Long Time?

What Causes the Turtle Light to Illuminate in New Energy Vehicles?

What chassis suspension does the Volkswagen Touran use?

Is the newly launched Volkswagen Tayron from SAIC or FAW?

How to Turn Off the Daytime Running Lights on the T-Roc?