How many kilometers can a Corolla travel on a full tank of gas?

How to Reset and Adjust the Tire Pressure of Mitsubishi Outlander?

To reset the tire pressure of GAC Mitsubishi Outlander, first turn on the instrument power, then press and hold the reset button until the low tire pressure warning light goes off. Press and hold the reset button again until the low tire pressure warning light flashes three times and then goes off. Here is some related information about tire pressure: 1. Introduction to Tire Pressure: Strictly speaking, it refers to the air pressure inside the tire. Tire pressure is closely related to the performance of the car, such as comfort and load capacity, and also affects the lifespan of the tire. 2. Hazards of Low Tire Pressure: Low pressure will increase the deformation of the tire body, leading to cracks on the sidewalls and causing flexing movements. This results in excessive heat, accelerating rubber aging, fatigue of the cord layer, and breakage of the cords. It also increases the tire's contact area with the ground, speeding up wear on the tire shoulders. 3. Hazards of High Tire Pressure: Excessive pressure will overstretch and deform the tire cords, reducing the elasticity of the tire body. This increases the load on the car while driving, and impacts may cause internal cracks or blowouts. High pressure also accelerates wear on the tire tread and reduces its resistance to puncture.

5

4

Share

Steps to Replace Car Brake Fluid

Here are the steps to replace car brake fluid: 1. Place the vehicle on a pit or lift it with a jack. 2. One person should be under the car, remove the rubber dust cap from the drain port, attach both ends of a transparent hose to the drain port and the waste oil collection bottle, then use a wrench to loosen the drain port screw counterclockwise. Meanwhile, the person inside the car should repeatedly press the brake pedal. At this point, brake fluid will spray out from the drain port. Pay attention to the fluid level in the brake fluid reservoir and add new brake fluid as the level drops. Once the fluid coming out is clear, tighten the drain port screw. 3. The person inside the car should repeatedly press the brake pedal to its highest point and hold it there without releasing. The person under the car should loosen the drain port screw. Once the brake fluid is completely drained, tighten the screw and notify the person inside the car to release the pedal. Repeat this operation several times until no air bubbles are seen in the drained brake fluid. Keep an eye on the fluid level in the brake fluid reservoir and add new brake fluid as the level drops to prevent air from entering the brake system. 4. Repeat steps 1 to 3 for each wheel until all the brake fluid is replaced.

13

2

Share

What tires are used in the Classic Sylphy?

The Classic Sylphy uses Maxxis MA-202 tires with a tire size of 185/65/R15. Maxxis International is one of the largest and most respected tire companies in the world. It continuously provides tire products for passenger cars, light trucks, bicycles, motorcycles, ATVs, trailers, go-karts, and lawn mowers, selling to more than 170 countries with business operations across Asia, Europe, and the Americas. For the Classic Sylphy's tires in daily use, pay attention to the following points: Regularly check the tire surface for cracks, deformations, or other defects. Due to driving wear, the tread grooves of the tires gradually become shallow. If the tread is worn flat, it will lose its drainage and anti-skid functions, significantly reducing the car's performance. Small cracks may seem minor but can be a hidden danger for tire blowouts at high speeds. Additionally, promptly remove pebbles from the grooves. Try to park on flat ground. Avoid parking on roads with thick, sharp, or pointed stones. Do not park the car near or in contact with petroleum products, acids, or other materials related to rubber deterioration. After parking, the driver should not turn the steering wheel, as this action will accelerate tire wear. Do not splash water to cool down. In hot weather or during high-speed driving, tires are prone to overheating, and the air pressure will increase. In such cases, stop to allow the tires to cool down naturally. It is strictly forbidden to release air to reduce pressure or splash water to cool down, as this may cause abnormal aging of the tread rubber. Avoid sudden braking. Try to minimize frequent use of brakes and sudden stops to prevent accelerated tread wear caused by dragging between the tires and the ground.

5

3

Share

Can National 5 Vehicles Be Licensed in Nanjing?

National 5 vehicles cannot be licensed in Nanjing. Here is the relevant information: 1. Purchasing from other regions: Taxes must be paid in Nanjing, and the vehicle must meet the National 6 emission standards. 2. Nanjing residency: If you are a Nanjing resident and the vehicle meets Nanjing's emission standards, it can be transferred to Nanjing. 3. Policy: For specific policies, you can consult the Nanjing Vehicle Management Office. Below is an introduction to National 5 and National 6 standards: 1. Meaning: The higher the number, the more environmentally friendly the vehicle's emissions, and the later the release date, the stricter the energy-saving and emission-reduction requirements. 2. Pollution: National 1 has the highest pollution, while National 6 has the lowest, generally classified by year. 3. Engine: The biggest difference between National 5 and National 6 vehicles is that National 6 vehicles use a more efficient three-way catalytic converter, allowing the engine's emissions to meet National 6 standards. 4. Upgrade: The National 6 emission standard is an upgraded version of the National 5 standard, imposing stricter and more scientific requirements on vehicle tailpipe emissions.

2

5

Share

How to Choose a Dash Cam?

Here are the selection methods for choosing a dash cam: 1. Lens: Glass lenses are better than resin lenses. 2. Chip: The main chip of a dash cam is the Ambarella A7 series. 3. Image sensor: The parameters of image sensors are often exaggerated. Currently, the mainstream image sensors are the OV4689 and AR0330. The OV4689 is generally used in higher-end products and is usually paired with the A70, making it the best top-tier configuration available. 4. A 32GB memory card is most suitable. Below is additional information: 1. Dash cam: It is an instrument that records images, sounds, and other related information during vehicle travel. 2. Function: The main role of a dash cam is to record the entire process of driving, including video and sound, providing evidence for traffic accidents. It also records time, speed, and location in the video, functioning like a black box. 3. Fraudulent claims: With fraudulent claims becoming increasingly rampant today, dash cams are particularly important.

4

2

Share

What does the maintenance light of Zotye mean?

The maintenance light of Zotye means to remind the owner that maintenance is needed. Taking Zotye T600 as an example, the following is the specific introduction of Zotye T600: 1. Model positioning: Zotye T600 is positioned as a mid-size SUV, with a length of 4631mm, a width of 1893mm, a height of 1694mm, and a wheelbase of 2807mm. 2. Power: Zotye T600 is equipped with a 1.5L turbocharged engine, adopting continuous variable valve timing technology, with a maximum output power of 162 horsepower (119kW)/5500rpm and a peak torque of 215 N·m/2000-4000rpm. The whole series is matched with a 5-speed manual transmission. 3. Suspension: Zotye T600 adopts the front MacPherson independent suspension and the rear multi-link plus lateral stabilizer bar independent suspension.

12

4

Share

How many kilometers can a Corolla travel on a full tank of gas?

How to Reset and Adjust the Tire Pressure of Mitsubishi Outlander?

Steps to Replace Car Brake Fluid

What tires are used in the Classic Sylphy?

Can National 5 Vehicles Be Licensed in Nanjing?

How to Choose a Dash Cam?

What does the maintenance light of Zotye mean?

What is the difference between D gear and S gear in automatic transmission cars?

What is the fuel consumption of the Yuexiang?

Should the throttle be released when upshifting during acceleration?

What kind of engine oil should be used for the new Bora?