···
Log in / Register

How Many Kilometers Can 100 Liters of Diesel Run?

4 Answers
RowanLee
07/28/25 7:56pm
100 liters of diesel can allow small vehicles (such as sedans, pickup trucks, SUVs, etc.) to run approximately 100 to 200 kilometers, while large trucks can run from 30 to 100 kilometers. Below is relevant information about fuel consumption per 100 kilometers: 1. Introduction: Fuel consumption per 100 kilometers refers to the amount of fuel a vehicle consumes when driving a hundred kilometers at a certain speed on the road. It is a theoretical indicator for vehicles. The fuel consumption per 100 kilometers is a value obtained by manufacturers under objective conditions using a dynamometer installed on the vehicle's chassis, converted into speed parameters, and then calculated by specifying the speed to derive the theoretical experimental fuel consumption data per 100 kilometers for the vehicle model. 2. Calculation Method: Calculation Method: (Refueling Amount ÷ Fuel Price) ÷ Kilometers Driven × 100 = Fuel Consumption (Liters). Most vehicles now display the fuel consumption per 100 kilometers.
Was this review help?
19
2
Share
LeLillian
08/11/25 11:43pm
From my daily driving experience, my diesel family car has an average fuel consumption of around 7 liters per 100 kilometers, so 100 liters of fuel can roughly cover 1430 kilometers (calculated as 100 divided by 7 multiplied by 100). However, this is just an average. For instance, in city traffic jams, fuel consumption can soar to over 10 liters, reducing the range to just over 1000 kilometers. On the highway, maintaining a steady speed can lower consumption to 6 liters, allowing nearly 1670 kilometers. Also, don't forget weather factors—cold starts in winter increase fuel consumption. It's advisable to regularly check tire pressure and air filters to ensure the fuel system is unobstructed. These small details can help you get a few extra kilometers per liter, especially during long trips. Personally, I believe developing good driving habits, like avoiding sudden acceleration and braking, is more effective than any high-tech solutions. My car has been running for five years with stable fuel consumption, and it's common for 100 liters to cover over 1400 kilometers.
Was this review help?
19
1
Share
Expand All
AdalineFitz
09/30/25 6:25am
When driving a diesel truck on long-distance trips, I've personally experienced that the fuel consumption typically ranges around 15 liters per 100 kilometers. It consumes even more when fully loaded, with 20 liters being quite common. Calculating based on 15 liters, 100 liters of diesel can only cover about 667 kilometers (100 divided by 15 multiplied by 100). When climbing hills on mountain roads, each liter of fuel covers less distance, while cruising at 80 km/h on flat roads can save some fuel. Vehicle load is crucial; for us hauling goods, the difference between empty and fully loaded is significant. Tire wear and engine condition also have a big impact. I make it a habit to check tire pressure monthly to avoid deformation, which increases fuel consumption. If you encounter a situation where 100 liters of fuel only covers 600-plus kilometers, don't panic—check the chassis lubrication and exhaust pipe, especially in older vehicles where carbon buildup can easily lead to higher fuel consumption. From experience, planning routes wisely to avoid congestion can save a considerable amount of money over a year.
Was this review help?
13
2
Share
Expand All
Tony
11/13/25 8:17am
I prioritize eco-friendly and fuel-efficient driving. During tests on good road conditions with steady cruising, I managed to achieve a minimum fuel consumption of 5 liters per 100 kilometers, meaning 100 liters of fuel could easily cover 2000 kilometers. Of course, real-world conditions vary—factors like using air conditioning or city stop-and-go driving can increase consumption to 7 liters, reducing the range to around 1400 kilometers. The key lies in economical driving: gentle acceleration, minimal hard braking, and regular oil changes. Through app tracking, I found these practices can boost mileage by 10%-15%. Don’t overlook vehicle weight—full loads increase fuel consumption. Regularly cleaning the fuel system ensures more complete diesel combustion, often adding over 100 kilometers per 100 liters, which also benefits the environment in the long run.
Was this review help?
12
3
Share
Expand All
More Forum Discussions

Is Wheel Alignment Necessary After Changing Tires?

Wheel alignment is not necessary after changing tires; only wheel balancing is required. Situations that do require wheel alignment include: 1. When the vehicle's steering wheel feels heavy, shakes, pulls to one side, is off-center, or doesn't return to position while driving; 2. Uneven tire pressure and tread wear; 3. Wheel vibration or wobbling; 4. The vehicle pulling to one side. The benefits of wheel alignment are: 1. Enhanced driving comfort; 2. Extended tire lifespan; 3. Improved straight-line stability; 4. Reduced wear on chassis suspension components; 5. Increased driving safety. The principle behind wheel alignment is to adjust the vehicle's four-wheel parameters to ensure optimal driving performance and reliability.
3
5
Share

What are the handling methods for a tire blowout on the highway?

Highway tire blowout handling methods are: 1. Maintain control of the steering wheel and gradually reduce speed; 2. Gradually move the vehicle to the right and stop; 3. Quickly place a warning triangle 100 meters behind the vehicle; 4. Replace with the spare tire and promptly exit the highway. Causes of tire blowouts include: 1. Tire leakage; 2. Excessive tire pressure; 3. Insufficient tire pressure; 4. Severe tire wear. Tire maintenance methods include: 1. Regularly remove debris from tire treads; 2. Periodically check tire pressure; 3. Inspect tire wear and replace when necessary; 4. Promptly repair punctures; 5. Immediately stop and check tire condition if abnormal tire conditions occur while driving.
14
0
Share

What causes abnormal engine noise after an oil change?

The reasons for abnormal engine noise after an oil change are: 1. Overfilling of engine oil; 2. Using oil with inappropriate viscosity. The procedure for changing engine oil is: 1. Start the engine to warm up and bring the transmission to operating temperature; 2. Remove the drain bolt to collect the old oil from the transmission; 3. After draining the old oil completely, remove the oil pan to replace the transmission filter; 4. Reinstall the oil pan and tighten the drain plug; 5. Add new transmission oil; 6. Start the vehicle and shift through all gears; 7. Check the automatic transmission fluid level and adjust if necessary. Precautions for oil change include: 1. Perform the change when the engine is warm to ensure complete drainage of old oil; 2. Add the correct amount of new oil; 3. After adding oil, start the engine to check for leaks, then run the engine for 3 minutes to confirm the oil level reaches the normal mark.
3
5
Share

What is the car depreciation rate?

Car depreciation rates are typically 11% for the first 3 years, 10% from the 4th year onward, and 9% for the subsequent 3 years. Below are the specific details about car depreciation rates: 1. Regulations: The depreciation rate is 11% for the first 3 years, 10% from the 4th year onward, and 9% for the subsequent 3 years. For the first 3 years, the annual depreciation rate is 11%, resulting in a total depreciation of 33% over 3 years. From the 4th year onward, the annual depreciation rate is 10%, leading to a total depreciation of 40%. For the subsequent 3 years, the annual depreciation rate is 9%, resulting in a total depreciation of 27%. According to tax regulations, the depreciation period for passenger cars is 5 years, with a residual value rate of 5%. 2. Impact: The higher the depreciation rate, the worse the vehicle's condition and the lower its residual value.
17
5
Share

What is Section Speed Measurement?

Section speed measurement refers to a method of detecting the average speed of motor vehicles passing through a road section (speed measurement section) between two adjacent speed monitoring points. Functions of the section speed measurement system: By setting up two cameras at two adjacent monitoring points on the same road section, a monitoring and snapshot system is established. This system conducts real-time monitoring and snapshots of vehicles passing through the checkpoint area twice to obtain information such as vehicle speed, traffic flow, license plate number, color, approximate physical dimensions, and driver characteristics. The collected information is then transmitted through a network to the database of the public security traffic command center and traffic control sub-center for data storage, query, comparison, and other processing. Advantages of section speed measurement: High measurement accuracy, stable and reliable speed detection, more comprehensive recorded data. Due to detector limitations, single-point checkpoint devices cannot guarantee 100% image capture of passing vehicles. It offers high measurement efficiency and diverse speed measurement capabilities.
4
1
Share

What is the real reputation of the Haval M6 Plus?

Haval M6 Plus is a car with strong overall performance and balanced capabilities, without any obvious shortcomings. Here is a detailed introduction to the Haval M6 Plus: 1. Largest in-class space: If comparable models are like one-bedroom apartments, then the Haval M6 is a two-bedroom apartment. This analogy is not an exaggeration. Due to adopting the chassis of the first-generation H6, the M6 has a body length of 4664 mm, which is generally more than 12 cm longer than comparable models. 2. Luxurious configurations: Equipped with a wet dual-clutch transmission and double-wishbone independent suspension. It also features practical configurations such as tire pressure display, 360-degree panoramic imaging, auto hold, hill start assist, hill descent control, keyless entry, steering wheel-mounted paddle shifters, and OTA upgrades.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.