How Many Driver's Licenses Can Be Used to Deduct Points for One Vehicle?

1 Answers
DeClaire
07/29/25 3:43pm
Within one cycle, a maximum of 3 driver's licenses can be used to deduct points for vehicle violations. More details are as follows: 1. Deduction must use a bound driver's license: To reduce the space for buying and selling driver's license points, new regulations stipulate that vehicle owners must use a bound driver's license for point deduction. The same vehicle cannot be bound to more than 3 users simultaneously, and the same user cannot bind more than 3 vehicles at the same time. 2. Penalty regulations: If it is found that more than 3 drivers have handled violations for the same license plate vehicle within one scoring cycle, starting from the fourth driver's license, it will be included in the "blacklist."
Was this review help?
15
0
Share
More Forum Discussions

Does the Volkswagen Lavida have CarPlay connectivity?

Lavida cannot use CarPlay. Introduction to CarPlay: CarPlay is an in-car system launched by Apple, which seamlessly integrates users' iOS devices and iOS user experience with the dashboard system, and is designed specifically for certain car models. CarPlay supported models: Currently, the supported car brands are only Mercedes-Benz, Ferrari, and Volvo. Apple has also stated that it will gradually support brands such as BMW, Toyota, General Motors, Honda, Hyundai, Jaguar Land Rover, Kia, Mitsubishi, Nissan, Peugeot, Subaru, Suzuki, and Ford in the future.
16
1
Share

Does a car in its ninth year require an annual inspection?

A car in its ninth year does not require an annual inspection. Below are the relevant details: 1. Inspection schedule: According to national regulations, for non-commercial small and mini passenger vehicles (excluding minivans) older than 6 years but less than 10 years, the inspection frequency is adjusted from once a year to once every two years. Commercial passenger vehicles must be inspected once a year within the first 5 years; after 5 years, they must be inspected every 6 months. Trucks and large or medium-sized non-commercial passenger vehicles must be inspected once a year within the first 10 years; after 10 years, they must be inspected every 6 months. Small and mini non-commercial passenger vehicles must be inspected once every 2 years within the first 6 years; after 6 years, once a year; and after 15 years, every 6 months. 2. Inspection requirements: The inspection checks whether the vehicle's emissions meet standards and whether the driver has any traffic violation records during the period. Therefore, any traffic violations must be resolved before the inspection; otherwise, the vehicle will not pass. Additionally, the inspection includes checking for damaged lights, whether the vehicle's exterior matches its original condition, any changes to the suspension, as well as the sunroof, tires, etc. Excessive modifications to the vehicle should be avoided, as they may also prevent the vehicle from passing the inspection.
20
1
Share

Is the brake caliper of the Audi A4 located at the front or rear?

Audi A4's brake caliper is positioned at the front, near the front bumper. Brake caliper location: The position of the brake caliper is determined by the suspension arm structure. To avoid interference with the suspension arm, the brake caliper's position is adjusted accordingly. Impact of brake caliper: The front or rear positioning of the brake caliper affects the wheel hub bearing load. One direction increases the bearing load while the other decreases it, with forces varying under different deceleration conditions, though this impact is minimal. It also slightly influences mud/water ingress and heat dissipation, but the effect is negligible as the caliper is never positioned below the axle regardless of its placement.
16
2
Share

What are the reasons why the transmission cannot engage reverse gear?

1. The following are the reasons why the transmission cannot engage reverse gear: 1. Automatic transmission: The inability to shift gears in an automatic transmission may be caused by internal failure of the gearshift assembly, malfunction of the internal control module, or failure of the transmission's gear position switch. 2. Manual transmission: The inability to shift gears in a manual transmission may be due to failure of components in the clutch system, such as the release bearing, friction disc, or pressure plate. It could also be caused by a malfunction in the gearshift assembly. 2. The following are common faults of the transmission: 1. Oil leakage: Oil seeping from the transmission housing or oil pan may be due to aging or poor sealing of the gaskets, or poor manufacturing quality resulting in sand holes in the housing. 2. Engine stalling when engaging gear: Stalling when shifting into D or R may be caused by a faulty lock-up solenoid valve or a stuck lock-up control valve. 3. Locked gear: Incorrect input or output signals from the transmission, or poor condition of components or wiring, can cause this issue. Sometimes, communication problems between the transmission computer and other system computers can also lead to this. 4. No response when engaging gear: After shifting into D or R and releasing the brake, the vehicle does not move. This is often due to damage to the input shaft or reverse clutch, or failure of the D/R brake. 5. Abnormal noise: Unusual sounds from the transmission area while driving are usually caused by worn parts or improper installation of the transmission.
10
4
Share

What does the driver's license education test cover?

The driver's license test consists of: 1. Subject One: Also known as the theoretical test or driver's theory test, it covers fundamental driving theory, road safety laws and regulations, local statutes, and related knowledge. 2. Subject Two: Commonly referred to as the small road test, it is the abbreviated term for the field driving skills test. The test includes five mandatory items: reverse parking, parallel parking, hill start and stop, right-angle turns, and curve driving. 3. Subject Three: Known as the big road test, it assesses road driving skills for motor vehicle drivers. 4. Subject Four: Also called the theoretical test or driver's theory test. After the implementation of the Ministry of Public Security's Order No. 123, Subject Three was divided into two parts: the road test and an additional safe and civilized driving test, commonly known as 'Subject Four'. Below are additional details: 1. Legal basis: Article 24 of the 'Regulations on the Application and Use of Motor Vehicle Driver's Licenses' states that the test subjects are divided into the road traffic safety laws and regulations knowledge test, the field driving skills test, and the road driving skills test. The tests are conducted in the order of Subject One, Subject Two, and Subject Three. Only after passing the previous subject can one proceed to the next. 2. Validity period: The driver's license test is valid for three years, starting from the date of passing Subject One. All remaining subjects must be completed within three years. Otherwise, if the test is not completed within three years, the passed subjects will be invalidated, and the driving school may require additional fees to continue the test.
4
3
Share

What is the difference between red and green coolant?

The difference between red and green coolant lies in their properties: red coolant is G11, while green coolant is G12. Ethylene glycol-based coolant is green, propylene glycol-based coolant is red or orange, and glycerol-based coolant is blue. The color is due to dyes added to the liquid, serving only to distinguish it from other liquids without any other special functional purpose. This helps car owners differentiate when selecting coolant, preventing the mixing of different types of coolant, which could damage the engine. Another purpose is to prevent accidental ingestion. The color of the coolant is not inherently linked to its performance or quality. Multi-purpose coolant is often prepared in a distinct fluorescent green mainly to facilitate leak detection.
5
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.